MPD6D207S

MPD6D20*S Short Form 1 DC-DC Converter Short Form MPD6D20*S (Isolated DC-DC Converter) The MPD6D20*S Series is 24V or 27V Input , Low height 0.3” , small size 1.57” x 1.18” as same area of a eighth brick , surface-mountable devices , fixed switching frequency of Isolated DC-DC Converter. This series is pin compatibility to other Murata original DC-DC Converters of 48V input 10W,15W,20W series which are actually Japan De-facto Standard. ■FEATURES • Low Profile & Small Size:39.9×30.05×8.0mm • Wide Input Voltage Range(18 to 36V) • Wide Operating Ambient Temp:-40 to +85°C. with minimum power derating • Input-Output Isolation Voltage(1.5kVdc) • UL60950 recognized ,Self-declare CE mark ■FUNCTIONS • Over current Limit Inception • Low voltage Protection • Over voltage Protection • Remote On/Off control • Alarm signal Output • Output Current multiplied up to 10 times with parallel operation ■GENERAL SPECIFICATIONS MPD6D***S SERIES where *** is in below cell Item Model Input 207 Input Voltage Range Turn-on Input Voltage Turn-on/off Hysteresis (Min.) Output Output Voltage O u t pu t V o lt age T o le ran c e Nominal Output Current Overcurrent Limit Inception 209 18 to 36V (Continuous) Forced Air Convection 160LFM (0.8m/s) 16 to 18V 1V 3.3V 5.5V +5%,-3% 9.0A 6.0A 9.2A 6.2A (Min.) Lowvoltage Protection(Max.) Efficiency(typ) Output Ripple and Noise (Max.) Remote ON/OFF Isolation Input - Output(Min.) 90% of Nominal Output Voltage 91% 50mVp-p with FBW=100MHz 25mVp-p with FBW =20MHz ON :RC pin connected to -Vin or open OFF:RC pin connected to +Vin 1500Vdc 91% Note: 1. This datasheet is downloaded from the website of Murata Manufacturing co., ltd. Therefore, it’ s specifications are subject to change or our products in it may be discontinued without advance notice. Please check with our sales representatives or product engineers before ordering. 2. This datasheet has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering. 2008.2.1 MPD6D20*S Short Form 2 ■ DIMENSIONS 39.9 ± 0.6 20 NC NC 10 NC -Vin +Vin NC PO RC ALM NC 30.05 -V out Flat surface for Auto Chip Placer 2.54 +V out 0.5 ± 0.1 1 Unit : mm Tolerance : ±0.5 3.37 (37.3) Max.8.0 11 Weight : Max.15g 1.3±0.3 ■Pin assignment Pin No. 1,10,11,15,20 2,3,4 5,6 12 13 14 16,17 18,19 Designation NC +V out -V out ALM RC PO + Vin - Vin Function Not Connected +Output -Output Alarm output Note1 Remote On/Off Control Parallel Operation Note2 + Input - Input Note 1: Any DC-DC Converter halted by abnormality forces all DC-DC Converters, which are connected ALM pins to the others for parallel and/or multiple operation,to stop their operation. Note 2: DC-DC Converters connected PO pins to the others can synchronize start timing for parallel and/or multiple operation. Note: 1. This datasheet is downloaded from the website of Murata Manufacturing co., ltd. Therefore, it’ s specifications are subject to change or our products in it may be discontinued without advance notice. Please check with our sales representatives or product engineers before ordering. 2. This datasheet has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering. 2008.2.1 MPD6D20*S Short Form 3 ■Typical Power De-rating(with Single unit operation) MPD6D207S Forced Air Convection 160LFM (0.8m/s) 10 Output Curent(A) 8 6 4 2 0 -40 -20 0 20 40 60 80 100 Ambient Temperature (°C） Forced Air C onvection 240LFM (1.2m /s) Output Curent(A) 10 8 6 4 2 0 -40 -20 0 20 40 60 80 100 Am bient Tem perature (Deg.C ） Notice:We would like to emphasize that these data are based on our experimental measurement. Please confirm that the maximum temperature of components mounted on a PCB substrate of the DC-DC Converter is 120°C or less in your application. Note: 1. This datasheet is downloaded from the website of Murata Manufacturing co., ltd. Therefore, it’ s specifications are subject to change or our products in it may be discontinued without advance notice. Please check with our sales representatives or product engineers before ordering. 2. This datasheet has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering. 2008.2.1 MPD6D20*S Short Form 4 ■Typical Power De-rating(with Single unit operation) MPD6D209S Forced Air C onvection 160LFM (0.8m /s) Output Curent(A) 8 6 4 2 0 -40 -20 0 20 40 60 80 100 Am bient Tem perature (Deg.C ） Forced Air C onvection 240LFM (1.2m /s) Output Curent(A) 8 6 4 2 0 -40 -20 0 20 40 60 80 100 Am bient Tem perature (Deg.C ） Notice:We would like to emphasize that these data are based on our experimental measurement. Please confirm that the maximum temperature of components mounted on a PCB substrate of the DC-DC Converter is 120deg.C or less in your application. ■ Safety UL60950 recognized, CE marking(LVD & EMC directive) Note: 1. This datasheet is downloaded from the website of Murata Manufacturing co., ltd. Therefore, it’ s specifications are subject to change or our products in it may be discontinued without advance notice. Please check with our sales representatives or product engineers before ordering. 2. This datasheet has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering. 2008.2.1