THR-30185

REV DESCRIPTION DATE/APPD A DRAWING UNDER CHANGE CONTROL 9/17/04 GEC IMPACT ASSESSMENT REQUIRED PRIOR TO CHANGE DRAWN J. LEVRAULT CHECKED D. DEROSA MARKETING B. SMITH QA T. BROWN MFG. D. PAILLE PROJ. ENG. M. ZELFAND APPD E. WILCOX DATE 11/12/2002 Standard Part - THR-5/3000-15/500-D12 DATE Special Part - Input Over Voltage Shutdown Disabled 9/15/2004 DATE 9/3/2004 DATE ® ® 9/14/2004 PRODUCT SPECIFICATION THR-30185 DATE 9/3/2004 DATE 9/7/2004 DATE 9/3/2004 SIZE CODE IDENT. NO. DWG. NO. REV A 50721 43869 A SHEET 1 OF 4 MODEL: THR-30185 9/7/2004 INPUT: VOLTAGE RANGE: DC-DC CONVERTER PRODUCT SPECIFICATIONS MIN. TYP. MAX. UNITS TEST 9.00 24.00 36.00 V 100% L-TYPE FILTER TYPE: GBD TBD BACK RIPPLE CURRENT: mA GBD NO LOAD CURRENT @24Vin: 25 75 mA 100% FULL LOAD CURRENT @24Vin: For typical loads 874 974 mA 100% % 100% EFFICIENCY AT F. LOAD @24Vin: 80.0 NA OVERVOLTAGE SHUTDOWN: OUTPUT: 81.0 MIN. NOM. MAX. 2.70 17.000 17.85 W TOTAL OUTPUT POWER For all possible combinations of output voltages and their loads For product test use nominal currents for each output unless specified 4.900 5.00 5.100 VDC VOLTAGE(1): GBD 100% CURRENT RANGE(1): 275.0 2,200 3,000 mA 100% VOLTAGE(2): 13.50 15.00 16.50 VDC 100% CURRENT RANGE(2): 50.0 200.0 500.0 mA 100% VOLTAGE(3): -13.50 -15.00 -16.50 VDC 100% CURRENT RANGE(3): -50.0 -200.0 -500.0 mA 100% VOLTAGE SETTING ACCURACY: Measured at 24Vin , 1.5A load LINE REGULATION AT 5V: within 2% of 5.00V % 100% 2% SLOPE(± 1%) % 100% LOAD REGULATION AT 5V: 4% SLOPE(± 2%) % 100% LOAD REGULATION AT ±12V: 20-100% Load, 5V@ Nominal Load LINE REGULATION AT ±12V: Measured at 5Vo @ 2.75A, TEMPERATURE COEFFICIENT @5V: 10% SLOPE(± 5%) % 100% 2% SLOPE(± 1%) % 100% %/°C GBD OVER-VOLTAGE PROTECTION @5V: Voltage Clamp (TransZorb) RIPPLE/NOISE AT 20 MHz BANDWIDTH: 15V (-)15V 0.02 NA 5V DWG. No. 50 75 75 85 150 150 mV Pk/Pk mV Pk/Pk mV Pk/Pk 100% 100% 100% 43869 REV. A SHT 2 of 4 MODEL: THR-30185 9/7/2004 CURRENT LIMIT INCEPTION @5V: At .985Vout, 24V in, ± loads @ typical currents DC-DC CONVERTER PRODUCT SPECIFICATIONS 3.50 3.70 4.10 6 SHORT CIRCUIT CURRENT @5V: Vo Recovery Test Only, 24 Vin DYNAMIC LOAD RESPONSE RECOVERY TIME @5V: 5V load switched from 1.35A to 2.7A,±2% of Vo A 100% A 100% µSec 100% 150 300 MIN. TYP. MAX. 750 1000 VDC 100% ISOLATION RESISTANCE: TBD MOHM GBD ISOLATION CAPACITANCE: 500 pF GBD KHZ GBD GENERAL: ISOLATION VOLTAGE: SWITCHING FREQUENCY: 150 165 180 SYNC-ON/OFF CONTROL PIN: PROVIDED, FUNCTION TESTED MEETS REQUIREMENTS OF: UL-1950 CSA-C22.2 No234 VDE CALCULATED MTBF: YES YES N/A 200,000 MECHANICAL: MIN. TYP. CASE MATERIAL: DERATING INCHES GBD FIVE SIDED EMI/RFI SHIELDING: STORAGE TEMPERATURE GBD 2 OUNCES 56 GRAM BAKED ENAMEL STEEL, NON CONDUCTIVE BASE WEIGHT (NOMINAL): OPERATING AMBIENT TEMPERATURE Ta WHERE NO DERATING REQUIRED: Natural Convection,Vertical mount. HOURS MAX. 2" x 2" x .45" DIMENSIONS(NOMINAL): ENVIRONMENTAL: GBD GBD MIN. TYP. GBD GBD GBD MAX. -25 55 °C GBD -55 125 °C GBD AS PER DERATING CURVE DWG. No. 43869 REV. GBD A SHT 3 of 4 MODEL: THR-30185 11/12/2002 W DC-DC CONVERTER PRODUCT SPECIFICATIONS THR-30185 OUTPUT POWER TEMPERATURE DERATING CURVE 21 20 19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0 °C 25 30 35 % 40 45 50 55 65 70 75 80 85 90 95 100 THR-30185 Efficiency Vrs. Vin 84.00 83.50 83.00 82.50 82.00 81.50 81.00 80.50 80.00 79.50 79.00 78.50 78.00 Vin 77.50 77.00 10.00 12.00 15.00 DWG. No. 18.00 43869 24.00 REV. 36.00 A SHT 4 of 4