CEF400-112C

CEF400-112C 400 Watt Open Frame Single Output AC/DC Switching Power Supply PRODUCT SPECIFICATIONS INPUT CHARACTERISTICS Parameter Input Voltage Operating Range (AC) Input Frequency Turn-on Input Voltage Turn-off Input Voltage Maximum Input Current Inrush Current Power Factor Leakage Current OUTPUT CHARACTERISTICS Conditions Min. 85 47 76 63 1.75 Typ. Max. 264 63 85 78 6.5 20 0.90 Units Vac Hz Vac Arms Apk mA Ramp up Ramp down IEC EN61000-3-2 compliant 264 Vac input FEATURES n 400W continuous output power n EN61000-3-2 compliance IEC n Remote sense compensation n Power Fail signal AC n Power Good signal DC n Remote Inhibit control n Droop current share n I2C interface n Standby 5V n profile (1U) Low n Integrated cooling fan n Over-voltage protection n Over-current protection n Thermal overload protection n Built-in OR-ing FET Output Voltage 12V Parameter Voltage Set Point Accuracy Line and Load Regulation Ripple Voltage & Noise➀ Rated Output Current Voltage Set Point Accuracy Line and Load Regulation Ripple Voltage & Noise➀ Rated Output Current Conditions 17A load 20MHz Bandwidth Min. 12.08 11.75 33.3 4.85 4.85 Typ. 12.125 Max. 12.16 12.45 175 5.15 5.15 50 Units VDC mV p-p A VDC mV p-p A 5 5Vsb 20MHz Bandwidth 1.3 GENERAL Parameter Remote Sense Efficiency Turn on Delay Transient Response Current Sharing Accuracy Hold-up Time, to 10.8V Isolation Conditions Sum of +ve & -ve drops Full load, high line 12V Ramp 1A/μs 33% step 5Vsb Ramp 1A/μs 33% step 200-720W load 2 in parallel 400W, 120Vac line Output to Chassis-Basic Input to Chassis-Basic Full load and 100Vac input Min. Typ. 500 83 2 Max. Units mV % s ±375 ±40 45/55 20 500 1500 0.02 mV % ms Vrms % / °C DESCRIPTION The CEF400-112C is a 400W active powerfactor-corrected (PFC) front-end power supply for distributed power architecture (DPA) systems requiring high power density in a 1U low profile package. The built-in OR-ing FET allows the power supply to operate in active current sharing mode for redundant (N+1) operation. Additional features include I2C interface, built-in fan and a 5V standby auxiliary output. The CEF400-112 provides reliable 12V bulk power for Information Technology Equipment and Industrial Applications. Temperature Coefficient ➀ Ripple and noise are measured with 0.1 µF of ceramic capacitance and 10 µF of tantalum capacitance on each of the power supply outputs. The output noise requirements apply over a 0 Hz to 20 MHz bandwidth. A short coaxial cable with 50Ω scope termination is used. PROTECTION CHARACTERISTICS Parameter Over Voltage Over Current Short Circuit Over Voltage Over Current 5Vsb Unit 12V Output Voltage Conditions Latching Auto-restart Min. 14.065 36 Typ. 14.5 38 Max. 14.935 42 Units V A The 12V output shall current limit and shutdown during a shorted output condition, and shall automatically restart after the short is removed. Latching Auto-restart Auto-restart 5.6 1.4 2.1 6 2.65 V A 　 Over-temperature Input Undervoltage Unit shall self-protect against excessive internal temperatures and automatically recover. For full details go to www.murata-ps.com/rohs No damage will be sustained by operation at voltages below the specified input operating voltage range. www.murata-ps.com Technical enquiries email: sales@murata-ps.com, tel: +1 508 339 3000 MPS_CEF400-112C.B16 Page 1 of 3 CEF400-112C 400 Watt Open Frame Single Output AC/DC Switching Power Supply MONITORING AND CONTROL SIGNALS TTL logic signal goes high to denote loss of AC input. Power supply will provide a minimum of 5ms from loss of AC input before this signal goes high. Additionally a minimum of 3ms of holdup will be provided between the signal going high and the output going out of regulation. The signal will not go high when loss of AC input is less than 5ms in duration. TTL logic goes high after the output is in regulation. It goes low when there is loss of regulation. TTL logic input signal disables the output when held low, and enables the output when held high. Compensates for 0.5 V lead drop min. Will operate without remote sense connected. Unit is protected against reverse connection of the remote sense lines. EMISSIONS AND IMMUNITY EMI Electromagnetic Susceptibility ESD Electromagnetic Field Electrical Fast Transients/Burst Surge RF Conducted Immunity Magnetic Immunity Voltage Dips, Interruptions EN55022 Class B conducted AC Fail DC OK Remote On/Off IEC/EN 61000-4-2, Level 3 IEC/EN 61000-4-3, Level 3 IEC/EN 61000-4-4, Level 3 IEC/EN 61000-4-5, Level 3 IEC/EN 61000-4-6, Level 3 IEC/EN 61000-4-8, Level 3 IEC/EN 61000-4-11, Level 3 Remote Sense ENVIRONMENTAL CHARACTERISTICS SAFETY - Pending EN UL cUL CB CE Material Flammability RELIABILITY Calculated1 per MIL-HDBK-217N2, GB, 25°C, Quality Level I MTBF Calculated1 per Telcordia SR-332, Issue 1, Method 1, Case 3, GFC, Ground fixed, Controlled, Quality Level I 212khrs Parameter EN60950-1 UL60950-1 CSA C22.2 No. 60950-1 Certificate and report CE Mark - Comply with LVD UL 94V-0 Storage Temperature Range Operating Temperature Range Operating Humidity Storage Humidity Conditions Non-condensing w/o derating Non-condensing Min. –40 0 10 5 Typ. Max. Units + 85 50 90 95 °C % MECHANICAL Dimensions Weight Vibration Shock 293khrs Drop Tip over 4.0" × 7.0" × 1.59" (101.6mm × 177.8mm × 40.39mm) 2.0 lbs (0.91 kgs) Designed to meet IEC 68-2-6 to the levels from IEC 721-3-2 Designed to meet IEC 68-2-27 Designed to meet IEC 68-2-31 Designed to meet IEC 68-2-31 Notes Specifications subject to change without notice. Specifications are at factory settings. Warranty: 1 year. 1 Calculated figures exclude the integral fan. www.murata-ps.com Technical enquiries email: sales@murata-ps.com, tel: +1 508 339 3000 MPS_CEF400-112C.B16 Page 2 of 3 CEF400-112C 400 Watt Open Frame Single Output AC/DC Switching Power Supply MECHANICAL DIMENSIONS A B B 7.00 5.500 4.700 .75 1.15 1.59 M3 THDS (6 'A' PLS) 2X 10-32-UNF-2A OUTPUT SCREWS 6-32 THDS (8 'B' PLS) TP1 PIN #1 PIN #6 PIN #7 J7 B A AB C 2.500 B A AB 4.00 COM +V COVER 1.0mm STEEL J7 I2C Control Connector Pin # 1 2 3 4 5 6 7 8 9 10 11 12 Function SCL SDA 5V I2C A0 A1 A2 N/C N/C GND GND GND GND .75 BOTTOM INPUT END AIRFLOW OUTPUT END PIN #1 APPLY LABEL (ITEM 580) ON COVER, ORIENT AS SHOWN J1 B TYPICAL SIDE VIEW J5 Aux/Control Connector Pin # 1 2 3 4 5 6 7 8 9 10 Function NC -Sense +Sense 5VSB (Standby) 5VSB Return +12V Common Remote On/Off DC OK AC Fail PIN #5 A B .85 J5 J1 Input Connector Pin # 1 2 3 4 5 Function Line No Pin Neutral No Pin Ground 5.850 .25 6.250 PIN #6 PIN #1 J1 (Molex #26-62-4051, 5 Position, 3-Pin, .156" Straight Header) Mating Plug Housing Molex #09-50-8051 Mating Crimp Terminal Molex #08-52-0113 J5 (Molex #90130-3210, 10 Position C-Grid-III Receptacle, .100") Mating Plug Housing Molex #90142-0012 Mating Crimp Terminal Molex #90119-0121 J7 (Molex #87833-1231, 12 Position 2mm Milli-Grid) Mating Plug Housing Molex #51110-1260 Mating Crimp Terminal Molex #50394-8100 USA: Canada: UK: France: Germany: Japan: China: Singapore: Mansfield (MA), Tel: (508) 339-3000, email: sales@murata-ps.com Toronto, Tel: (866) 740-1232, email: toronto@murata-ps.com Milton Keynes, Tel: +44 (0)1908 615232, email: mk@murata-ps.com Montigny Le Bretonneux, Tel: +33 (0)1 34 60 01 01, email: france@murata-ps.com München, Tel: +49 (0)89-544334-0, email: munich@murata-ps.com Tokyo, Tel: 3-3779-1031, email: sales_tokyo@murata-ps.com Osaka, Tel: 6-6354-2025, email: sales_osaka@murata-ps.com Shanghai, Tel: +86 215 027 3678, email: shanghai@murata-ps.com Guangzhou, Tel: +86 208 221 8066, email: guangzhou@murata-ps.com Parkway Centre, Tel: +65 6348 9096, email: singapore@murata-ps.com Technical enquiries email: sales@murata-ps.com, tel: +1 508 339 3000 Murata Power Solutions, Inc. 11 Cabot Boulevard, Mansfield, MA 02048-1151 U.S.A. Tel: (508) 339-3000 (800) 233-2765 Fax: (508) 339-6356 www.murata-ps.com email: sales@murata-ps.com ISO 9001 REGISTERED Murata Power Solutions, Inc. makes no representation that the use of its products in the circuits described herein, or the use of other technical information contained herein, will not infringe upon existing or future patent rights. The descriptions contained herein do not imply the granting of licenses to make, use, or sell equipment constructed in accordance therewith. Specifications are subject to change without notice. © 2008 Murata Power Solutions, Inc. 10/02/08 www.murata-ps.com MPS_CEF400-112C.B16 Page 3 of 3