ENW-C9A04N4E

SNAP PAN4570 ® The PAN4570 is a short range, low power, 2.4 GHz ISM band transceiver using the Ember EM250 single chip solution for mesh networking. With IEEE 802.15.4 compliance, 16-bit ZAP2b micro-processor, on-board reference oscillators, and optimized RF front-end circuitry, the PAN4570 provides everything needed for a full mesh network solution. A reliable application programming interface and Ember’s EmberZNet stack can easily create application profiles. Product Performance: • • • • • • • • • • • • • • 128k Flash And 5k SRAM Memory 3 Antenna Options: Plug, 50 O SMD Port Or Ceramic Antenna 16 Selectable Channels With 250 kBps In The 2.4 Ghz Band 3 Different Power Modes For Increased Battery Life High Sensitivity Of -97 dBm Typical At A 1% Packet Error Rate +3 dBm Output Power (+5 dBm In Boost Mode) Low Supply Voltage: 2.1 V To 3.6 V, 3.0 V Typical Small Size: 20.0mm X 26.5mm X 3.0mm Onboard Low Power Regulator Operating Temperature Range: -40°C To +85°C Link Quality And Clear Channel Assessment Capability All Of The 17 GPIO Of EM250 Are Available At The Module Pads, Which Are Multiplexed To GPIO, UART, SPI, I2C Or Up To Four Analog Inputs To An ADC And Two Timer Waveform Outputs Critical Portions Of IEEE 802.15.4-2003 Plus A First-line Filter For Non-Intended Packets Are Realized In Hardware, Thus Reducing The Workload On The uc FCC Certified Applications: • • • • • Remote Control And Wire Replacement In Industrial Systems Such As Wireless Sensor Networks Factory / Home Automation And Motor / Lighting Control Inventory Management And RFID Tagging Automated Meter Reading Monitoring (Environmental, Patient or Fitness) Part Numbers: Part Number Description ENWC9A02A3E PAN4570, Mesh Networking Module With Ceramic Antenna ENWC9A03N2E PAN4570, With U.FL Antenna Connector ENWC9A04N4E PAN4570, With RF Out On SMD Pads EVAL_PAN4570 Evaluation Kit For The PAN4570 Module Panasonic Electronic Components http://www.panasonic.com/rfmodules 1-800-344-2112 16 SNAP ® PAN4570 Dimensions & Pin Layout: 26,5 mm 26.5mm Pin No. 20.0mm 20,0 mm Antenna 24 23 22 21 20 19 18 17 16 15 14 13 25 26 27 28 29 30 31 32 33 34 35 36 12 11 10 9 8 7 6 5 4 3 2 1 Top View Height 3,0 mm 3.0mm Pin No. Pin Name VBAT 27 SIF_MOSI 2 REG_out 28 SIF_LOADB 3 Reset 29 n.c. 4 OSC32A 30 to 37 5 OSC32B 38 6 to 12 13,24 14 to 23 37 38 39 40 41 42 43 44 45 46 47 48 Pin Name 1 GPIO 0 to 6 GND GPIO 7 to 16 25 SIF_CLK 26 SIF_MISO GND RF 39, 48 GND 40 VC1 41 to 45 n.c. 46 Reg_EN 47 Reg_IN Note: Access to the programming interface pins 25, 26, 27, 28, 1, and 3 has to be provided on the application board. Technical Specifications: Parameter Value Condition / Notes -96 dBm typ. - Normal -97 dBm typ. - Boost For 1% packet error rate Output Power 3 dBm 5 dBm Normal Boost Mode On Power Supply 2.1 V to 3.6 V 3.0 V typical Error Vector Magnitude 15% Typical 35% Boost Typical as defined by IEEE802.15.4-2003 Maximum Data Rate 250 kbps Over The Air Current Consumption Total Rx Current Total TX Current Deep Sleep Mode Deep Sleep Mode 35.5 mA typ. 35.5 (41.5) mA typ. 1.5 uA 1.0 uA @ max Tx power, boost mode off (on) max, with 32.768KHz osc running max, with internal RC osc running Receiver Sensitivity Operating Temperature Range -40°C to +85°C Notes: All parameters are valid for VDD = 3.0V and Tamb = 25°C. The data stated above is preliminary data. 17 Panasonic Electronic Components http://www.panasonic.com/rfmodules 1-800-344-2112