UPG152TA-E3

L, S BAND SPDT GaAs MMIC SWITCH FEATURES • WIDE FREQUENCY RANGE: 100 MHz to 2.5 GHz • LOW INSERTION LOSS: 0.5 dB Typical at 2.0 GHz • HIGH P1dB: +30 dBm typ. @ 2 GHz • LOW CONTROL VOLTAGE: +3V or 0V • SUPER SMALL SURFACE MOUNT PACKAGE: SOT-26 • AVAILABLE ON TAPE AND REEL UPG152TA INTERNAL BLOCK DIAGRAM OUT 2 3 4 VCONT2 GND 2 5 IN DESCRIPTION The UPG152TA is an L-Band Single Pole Double Throw (SPDT) GaAs MMIC switch developed for digital cellular, cordless, and PCS handset, WLAN, and other RF control applications. The device features low insertion loss, high P1dB, and low voltage operation. It is housed in a super small, lowcost SOT-26 package and is also available on tape-and-reel. NEC's stringent quality assurance and test procedures ensure the highest reliability and performance. OUT 1 1 6 VCONT1 ELECTRICAL CHARACTERISTICS (TA = 25°C, VCONT = 3V/0V) PART NUMBER PACKAGE OUTLINE SYMBOLS IL ISOL RLIN RLOUT P1dB IIP3 tSW ICONT PARAMETERS AND CONDITIONS Insertion Loss Isolation Input Return Loss Output Return Loss f = 0.1 – 2 GHz f = 2.0 – 2.5 GHz f = 0.1 – 2 GHz f = 2.0 – 2.5 GHz f = 0.1 - 2 GHz f = 0.1 - 2 GHz f = 0.1 - 2 GHz UNITS dB dB dB dB dB dB dBm dBm dBm ns µA 20 11 11 27 30 +48 +44 30 5 MIN UPG152TA T06 TYP 0.5 0.8 22 20 MAX 1.0 Input Power at 1 dB Compression Input IP3 at f = 900 MHz, VCONT = +3 V f = 1900 MHz, VCONT = +3 V Switching Speed Control Current f = 0.1 - 2 GHz f = 0.1 - 2 GHz, VCONT = 3V/0V, no RF signal California Eastern Laboratories UPG152TA ABSOLUTE MAXIMUM RATINGS1 (TA = 25°C) SYMBOLS VCONT 1,2 PIN PTOT TOPT TSTG PARAMETERS Control Voltage 1 and 2 Input Power Total Power Dissipation Operating Case Temperature Storage Temperature UNITS V dBm W °C °C RATINGS UPG152TA -6.0 to +6.0 2.7≤|VCONT1-VCONT2|≤6.0V 31 0.4 -50 to +90 -65 to +150 Note: 1. Operation in excess of any one of these parameters may result in permanent damage. RECOMMENDED OPERATING CONDITIONS UPG152TA SYMBOL VCONT VCONT PIN Control Voltage (ON) Control Voltage (OFF) Input Power Level (VCONT = 3V/0V) PARAMETER UNITS V V dBm MIN +2.7 -0.2 TYP +3.0 0 +27 MAX +5.3 +0.2 +29 APPLICATION EXAMPLE (PCS Handset) RX DEMOD I Q ÷N SW UPG152TA PLL PLL UPC8105GR I 0˚ Phase Shifter PA UPC8106T 90˚ TX Q UPG152TA TEST CIRCUIT UPG152TA IN Zo = 50Ω 51pF VCONT2 = 0V/3V 1000pF 4 6 1000pF VCONT1 = +3V/0V 3 51pF OUT 2 Zo = 50Ω SWITCH LOGIC TABLE CONTROL INPUTS (V) VCONT1 0 0 +3 +3 VCONT2 0 +3 0 +3 CONDITION OF OUTPUT PORTS1 OUT1 OFF ON OFF OFF OUT2 OFF OFF ON OFF Note: 1. Impedance of the output port in the "OFF" state is reflective. G1B 1 51pF OUT 1 Zo = 50Ω UPG152TA PIN CONNECTION DIAGRAM PIN NO. 1 2 3 4 5 6 CONNECTION OUT 1 GND OUT 2 VCONT2 IN VCONT1 2 1 G1B 3 Top View 4 5 6 4 5 6 Bottom View 3 2 1 OUTLINE DIMENSIONS (Units in mm) UPG152TA PACKAGE OUTLINE T06 +0.2 2.8 -0.3 +0.2 1.5 -0.1 ORDERING INFORMATION PART NUMBER UPG152TA-E3 QTY 3000/Reel 1.9±0.2 2 0.95 G1B 2.9±0.2 3 0.95 4 5 1 6 -0.05 0.3 +0.10 +0.2 1.1 -0.1 0.8 0.13±0.1 0 to 0.1 All dimensions are typical unless otherwise specified. Life Support Applications These NEC products are not intended for use in life support devices, appliances, or systems where the malfunction of these products can reasonably be expected to result in personal injury. The customers of CEL using or selling these products for use in such applications do so at their own risk and agree to fully indemnify CEL for all damages resulting from such improper use or sale. EXCLUSIVE NORTH AMERICAN AGENT FOR NEC RF, MICROWAVE & OPTOELECTRONIC SEMICONDUCTORS CALIFORNIA EASTERN LABORATORIES • Headquarters • 4590 Patrick Henry Drive • Santa Clara, CA 95054-1817 • (408) 988-3500 • Telex 34-6393 • FAX (408) 988-0279 Internet: http://WWW.CEL.COM DATA SUBJECT TO CHANGE WITHOUT NOTICE 12/7/2001