OE-F8HS18DS

厂商：
NEL
封装：
描述：
OE-F8HS18DS - Precision SC-cut OCXO in 36x27 mm “Europack” - Nel Frequency Controls,inc

数据手册：

下载OE-F8HS18DS.pdf

立即购买

详情介绍
数据手册
价格&库存

OE-F8HS18DS 数据手册

CRYSTAL OSCILLATORS Data Sheet 0635J OE-X8HXXXXX Precision SC-cut OCXO in 36x27 mm “Europack” Product Data Sheet Features • • • • • • SC-cut crystal -9 High Stability (up to ± 5x10 ) Low Aging (5x10 /day, 5x10 /year) Low Phase Noise (-160 dBc/Hz, TYP, floor) Sine Wave or HCMOS/TTL output 4.8 MHz to 160 MHz Frequencies Available -10 -8 0.50 (12,7 mm) 0.25 (6,35 mm) Applications • • • • Ø0.030 (0,76 mm) TYP Specifications: Systems Telecommunication Data Communications GPS Instrumentation 0.70 (17,78 mm) 3 1.00 (25,40 mm) 4 2 1.07 (27,20 mm) Vcc 1 5 1.42 (36,1 mm) Vc 1 3 DUT 5 4 OUTPUT Vref 2 10K 357 Beloit Street, P.O. Box 457, Burlington, WI 53105-0457 U.S.A. Phone 262/763-3591 FAX 262/763-2881 Email: nelsales@nelfc.com www.nelfc.com CRYSTAL OSCILLATORS OE-X8HXXXXX Series Parameter Symb Absolute Maximum Ratings Vcc Input Break Down Voltage Ts Storage temper. Vc Control Voltage Electrical F Frequency Frequency stability ∆F/F Aging Allan Variance SSB Phase Noise Condition Min -0.5 -40 -1 4.8 vs. Temp. vs. Supply per day per year .1s to 10s 1Hz 10 Hz 100 Hz 1 KHz 10 KHz After 30 minutes worst direction 4.75 3.15 11.4 10.000 ±10 1 5E-10 1E-7 1E-11 -90 -120 -150 -153 -160 Typ Max 13.0 85 9 160 2 Unit V °C V MHz ppb ppb/V Data Sheet 0635J Note 1* See chart below after 30 days 5E-8 available2* All parameters for 10 MHz dBc/Hz 3* Retrace G-sensitivity Input Voltage Vcc steady state, 25°C W Standard Operating steady state, -30°C Temperature, for Op start-up @ -30°C 3.2 Temp. 85 °C ad 20% Subharmonics -45 dBc At Higher Frequencies Spectral Purity Spurious -80 Harmonics/Sine -35 -30 10KOhm//15pF (HCMOS/TTL), 50 Ohm (Sinewave) Load to 0.1ppm accuracy 3 5 minutes 3 min. at 12V Warm-up time τ 3.3V HCMOS/TTL compatible or Sinewave (+7± 3) dBm -25dBm Harmonics at sine Output Waveform Vc 0 4.0 V Control voltage from nominal F ±0.5 ±1 ppm Pull range Monotonic, posit 0.4 ppm/V Deviation slope Vc0 @25°C, Fnom. 1.0 2.0 3.0 V Setability Environmental and Mechanical -30°C to 70°C Standard, Other options – see chart below Operating temp. range Per MIL-STD-202, 30G, 11ms Mechanical Shock Per MIL-STD-202, 5G to 2000 Hz Vibration 260°C for 10s Max leads only Soldering Conditions Electrical Connections Pin #1-Vc ; Pin#2 – Vref; Pin #3 – Vcc; Pin #4- Output ; Pin #5- GND; Pin Out Power consumption Notes: 1* Higher frequencies can be achieved either by using higher frequency crystals or by low noise analog harmonic multiplication. Both methods have advantages and drawbacks. If lowest possible phase noise on the noise floor is most important – high frequency crystal will be used. If phase noise close to the carrier and aging are more important – multiplication will be used. Please consult factory for your specific requirement. 2* Aging rate is usually proportional to the operating frequency, unless higher frequency is achieved by multiplication. Keep it in mind while specifying aging. 3* Phase noise deteriorates with frequencies going higher. If analog multiplication is used to achieve higher frequency the phase noise roughly follows the formula of additional 20LogN, where N is a multiplication factor across entire frequency offset range. If higher frequency is achieved by using higher frequency crystal phase noise close to the carrier deteriorates due to the lower Q of the crystal and is usually worse, compared to multiplied solution. On the noise floor, however it remains more or less the same. This design usually starts utilizing multiplication techniques in the range of 25 MHz to 35 MHz. P 5.0 3.3 12.0 0.8 1.5 2.5 -50 ±10 ±1.0 5.25 3.45 12.6 1.2 ppb ppb/G V See chart below to specify 357 Beloit Street, P.O. Box 457, Burlington, WI 53105-0457 U.S.A. Phone 262/763-3591 FAX 262/763-2881 Email: nelsales@nelfc.com www.nelfc.com CRYSTAL OSCILLATORS OE-X8HXXXXX Series Data Sheet 0635J Creating a Part Number OE - X 8H X XX X X Package Code OE 5 pin 36x27mm Supply Voltage Code 0 A F Specification 5V ± 5% 3.3V± 5% 12V 5% Aging Code L S P Specification 1x10-9/Day 5x10-10/Day 2x10-10/Day Temperature Range Code A B C D E F Specification 0°C to 50°C -10°C to 60°C 0°C to 70°C -20°C to 70°C -30°C to 70°C -40°C to 80°C Output Code T S Specification TTL Sinewave Temperature Stability Code 17 58 28 18 59 YZ Specification 1x10-7 5x10-8 2x10-8 1x10-8 5x10-9 Yx10-Z Not all combinations are available. Consult Factory. 357 Beloit Street, P.O. Box 457, Burlington, WI 53105-0457 U.S.A. Phone 262/763-3591 FAX 262/763-2881 Email: nelsales@nelfc.com www.nelfc.com

下载 PDF

OE-F8HS18DS

1. 物料型号： - 型号为OE-X8HXXXXX系列。

2. 器件简介： - 该器件是一款精密的SC-cut OCXO（恒温晶体振荡器），封装形式为36x27 mm “Europack”。 - 特点包括高稳定性（最高可达±5×10^-9）、低老化率（5×10^-10/天，5×10^-8/年）、低相位噪声（-160 dBc/Hz，典型值，底线）。 - 支持正弦波或HCMOS/TTL输出，频率范围从4.8 MHz到160 MHz。

3. 引脚分配： - Pin #1: Vc（控制电压）； - Pin #2: Vref（参考电压）； - Pin #3: Vcc（电源电压）； - Pin #4: 输出； - Pin #5: GND（地）。

4. 参数特性： - 频率稳定性：±10 ppb（温度变化）、±1.0 ppb/V（电源变化）； - 老化：5×10^-10/天，5×10^-8/年； - 相位噪声：-160 dBc/Hz（典型值）； - 电源电压：4.75 V至5.25 V； - 功耗：0.8 W至1.2 W（25°C时稳定状态）； - 负载：10KOhm//15pF（HCMOS/TTL），50 Ohm（正弦波）； - 预热时间：3至5分钟； - 输出波形：3.3V HCMOS/TTL兼容或正弦波（+7±3 dBm）。

5. 功能详解： - 该振荡器提供高稳定性和低相位噪声的输出，适用于需要精确时钟信号的应用。 - 可以通过改变控制电压Vc来调整频率，具有±0.5 ppm至±1 ppm的拉偏范围。

6. 应用信息： - 适用于电信系统、数据通信、GPS、仪器仪表等领域。

7. 封装信息： - 封装形式为5针36x27mm的“Europack”。 - 可以根据需要选择不同的老化率、供电电压、温度范围和输出类型（TTL或正弦波）。

OE-F8HS18DS 价格&库存

-> 查询更多价格&库存

很抱歉，暂时无法提供与“OE-F8HS18DS”相匹配的价格&库存，您可以联系我们找货

免费人工找货

搜索历史

OE-F8HS18DS

相关技术文章