SD-A36BHB9-FREQ

CRYSTAL CLOCK OSCILLATORS Data Sheet 0629G Rev. A LVPECL UHF VCXO SD-X36BXXX Series Description The SD-X36BXXX Series of voltage controlled crystal oscillators (VCXO) provides ultra high frequency with LVPECL complementary outputs. The outputs can be Tri-stated for test automation or combining multiple clocks. The device is based on low noise analog harmonic multiplication for higher frequencies, and packaged in a miniature, low profile leadless ceramic SMD package with 6 gold plated pads. Applications and Features • Wide frequency range – 38.0MHz to 800.000MHz • Fiber Channel; 10 GbE; Infiniband; Network Processors; SOHO Routing • High Reliability - NEL HALT/HASS qualified for crystal oscillator start-up conditions • Low Phase Noise, Low Jitter • High shock resistance, to 1000g • Ultra High Frequency • Absolute Pull Range (APR) to ±100 ppm • Grounded lid and internal by-pass capacitor reduce EMI • RoHS Compliant, Lead Free Construction Creating a Part Number SD - X 36B X X X - FREQ Package Code Absolute Pull Range, ppm SD 6 pad 5x7mm SMD E ±20 F ±32 Input Voltage G ±50 A 3.3V±5% H ±100 B 2.5V±5% 9 Customer specific Enable Option H Enable High L Enable Low Temperature Range, °C A 0 to 50 B 0 to 70 C -20 to 70 D -40 to 85 9 Customer specific 357 Beloit Street, P.O. Box 457, Burlington, WI 53105-0457 U.S.A. Phone 262/763-3591 FAX 262/763-2881 Email: nelsales@nelfc.com www.nelfc.com CRYSTAL CLOCK OSCILLATORS SD-X36BXXX Series Continued LVPECL UHF VCXO Data Sheet 0629G Rev. A Absolute Maximum Ratings Parameter Operating Temperature Range Storage Temperature Range Supply Voltage Enable/Disable Voltage Parameter Nominal Frequency Supply Voltage Supply current Output Logic Type Load Output Levels Symb Fo Vcc Icc Symbol To Tst Vcc Ven/dis Conditions, Note Code A Code B Output to Vcc-2V, or Thevinin Equivalent overall Value -40 to +85 -50 to +90 -0.5 to 4.5 0 to Vcc MIN 38 3.135 2.375 TYP 3.3 2.5 80 LVPECL Unit ºC ºC V V MAX 800 3.465 2.625 100 Unit MHz V mA Ohm V Vcc1.620 55/45 0.7 Electrical Parameters 50 Voh Vol Vcc1.025 45/55 50/50 0.5 0.3 2.5 2.5 30 43 6 18 -50 -35 -65 -95 -125 -140 -145 -148 30 Duty Cycle Rise/Fall Time Jitter Integrated Wavecrest characterized Tr/Tf J Sub-Harmonics Phase Noise £(Δf) Frequency Stability ΔF/F Control Voltage Range Setability Absolute Pull Range Input Impedance Modulation Bandwidth Enable High Option Pin 2 Enabled Pin 2 Disabled Enable Low Option Pin 2 Disabled Pin 2 Enabled Vc Vcs APR Zin At 50% of output voltage swing 20 to 80, 80 to 20% Integrated from Phase Noise, 12 KHz to 20 MHz , RMS Random 320 M Accumul., 320 M Deterministic 320 M 320 M 212.5 MHz @ 10 Hz @100 Hz @1 KHz @10KHz @100KHz @>1MHz Overall, including initial calibration, temperature, aging 10 years, shock and vibration @ Vc=Vcc/2 Vc to set F at Fo; T, Vcc, load - nominal, as shipped Over all conditions, see part # creation @ Fmod < 100 Khz At Vc = Vcc/2, -3dB CMOS logic 1 or N/C CMOS logic 0 CMOS logic 1 or N/C CMOS logic 0 % ns ps ps ps ps dBc dBc/Hz ppm 0V 0.4 Vcc 20,32, 50,100 10 10 0.7 Vcc 0 0.7 Vcc 0 0.5 Vcc Vcc 0.6 Vcc V V ppm KOhm KHz Vcc 0.3 Vcc Vcc 0.3 Vcc V V 357 Beloit Street, P.O. Box 457, Burlington, WI 53105-0457 U.S.A. Phone 262/763-3591 FAX 262/763-2881 Email: nelsales@nelfc.com www.nelfc.com CRYSTAL CLOCK OSCILLATORS Rev. A SD-A36BXXX Series Continued LVPECL UHF VCXO Electrical Connection Pin Connection 1 Vco 2 Enable 3 VEE 4 Output 5 Output Complement 6 VCC Environmental and Mechanical Characteristics Operating temp. range Mechanical Shock Thermal Shock Vibration Hermetic Seal Soldering conditions see part # table Per MIL-STD-202, Method 213, Cond. E Per MIL-STD-883, Method 1011, Cond. A Per MIL-STD-883, Method 2007, Cond. A Leak rate less than 1x10-8 atm.cc/s of helium See MAX reflow profile below Maximum Reflow Profile 357 Beloit Street, P.O. Box 457, Burlington, WI 53105-0457 U.S.A. Phone 262/763-3591 FAX 262/763-2881 Email: nelsales@nelfc.com www.nelfc.com