PLG1A821MDO1

CONDUCTIVE POLYMER ALUMINUM SOLID ELECTROLYTIC CAPACITORS LG Radial Lead Type, Higher Capacitance series Higher Capacitance, Low ESR, High ripple current. Load life of 2000 hours at 105°C. Radial lead type : Lead free flow soldering condition correspondence Adapted to the RoHS directive (2002/95/EC). LG Higher Capacitance LF Specifications Item Category Temperature Range Rated Voltage Range Rated Capacitance Range Capacitance Tolerance tan δ ESR ( 1) Leakage Current ( 2) –55 to +105°C 2.5 to 16V 330 to 3900µF ± 20% at 120Hz, 20°C Not more than value of Standard ratings Not more than value of Standard ratings Not more than value of Standard ratings. 1.25 1.25 Capacitance change tan δ ESR ( 1) Leakage current ( 2) Within ± 20% of initial value ( 3) 150% or less of the initial specified value 150% or less of the initial specified value Initial specified value or less (100kHz) at 120Hz, 20°C at 100kHz, 20°C After 2 minute's application of rated voltage. 20°C Performance Characteristics Characteristics of Temperature Z+105°C / Z+20°C Impedance Ratio Z - 55 ° C / Z + 20 ° C After 2000 hours' application of rated voltage Endurance at 105°C, capacitors meet the specified value for life characteristics listed at right. After 1000 hours' application of rated voltage Damp Heat at 60°C 90%RH, capacitors meet the specified value for life characteristics listed at right. Capacitance change tan δ ESR ( 1) Leakage current ( 2) Within ± 20% of initial value ( 3) 150% or less of the initial specified value 150% or less of the initial specified value Initial specified value or less Resistance to Soldering Heat To comply with recommended conditions for reflow soldering. Pre-heating shall be done at 150 to 200°C and for 60 to 180 sec. Peak temp. is 265°C, within 10 sec. Measurement for solder temperature profile shall be made at a point on the terminal nearest where the terminals protrude through the soldering side of PC board. Navy blue print on the case top. Capacitance change tan δ ESR ( 1) Leakage current ( 2) Within ± 10% of initial value ( 3) 130% or less of the initial specified value 130% or less of the initial specified value Initial specified value or less Marking ( 1) ESR measurements should be made at a point on the terminal nearest the end seal of the capacitor. ( 2) Conditioning : If there is doubt about the measured result, measurement should be made again after the rated voltage is applied for 120 minutes at the temperature of 105°C. ( 3) Initial value : The value before test of examination of resistance to soldering. CONDUCTIVE POLYMER ALUMINUM SOLID ELECTROLYTIC CAPACITORS LG series Dimensions Capacitance Lot. No. Laminated Case Silvered lead Wire Type numbering system (Example : 4V 1200µF) 1 2 3 4 5 6 7 8 9 10 11 12 P L G 0 G 1 2 2 M CO 1 φ D+0.5 MAX P ± 0.5 LG 122 g 741 Size code Configuration Capacitance tolerance (± 20%) φd Series Voltage (g:4V) L+0.5MAX 15MIN 4MIN Rated Capacitance (1200µF) Rated voltage (4V) Voltage V Code 2.5 e 4 g 6.3 j 10 A 16 C Configuration (mm) Series name Type Size φD L P φd φ 8 × 9L 8.0 8.5 3.5 0.6 φ 8 × 12L 8.0 11.5 3.5 0.6 φ 10 × 13L 10.0 12.5 5.0 0.6 φD × L 8×9 8 × 12 10 × 13 Code CO DO DO Standard ratings Rated Voltage Surge Voltage Rated Capacitance (V) (V) (µF) Code Case Size φD × L (mm) tan δ Leakage Current (µA) ESR Rated ripple (mΩ) (mArms) (20˚C / 100kHz) (105˚C / 100kHz) Code 1800 2.5 (0E) 2.8 2200 3900 1200 4 (0G) 4.6 1800 2700 820 6.3 (0J) 7.2 1200 1800 560 10 (1A) 11.5 820 1200 330 16 (1C) 18.4 470 820 8×9 8 × 12 10 × 13 8×9 8 × 12 10 × 13 8×9 8 × 12 10 × 13 8×9 8 × 12 10 × 13 8×9 8 × 12 10 × 13 0.08 0.08 0.08 0.08 0.08 0.08 0.08 0.08 0.08 0.08 0.08 0.08 0.08 0.08 0.08 900 1100 1950 960 1440 2160 1033 1512 2268 1120 1640 2400 1056 1504 2624 9 8 8 9 9 8 9 9 8 11 10 9 13 11 11 6000 6700 7000 5900 6500 6900 5700 6100 6600 5100 5800 6200 4700 5400 5600 PLG0E182MCO1 PLG0E222MDO1 PLG0E392MDO1 PLG0G122MCO1 PLG0G182MDO1 PLG0G272MDO1 PLG0J821MCO1 PLG0J122MDO1 PLG0J182MDO1 PLG1A561MCO1 PLG1A821MDO1 PLG1A122MDO1 PLG1C331MCO1 PLG1C471MDO1 PLG1C821MDO1 Design, Specifications are subject to change without notice. Printed in Japan T.2007.B.3C