NJM2753V

NJM2753 3-Input / 1-Output Stereo Audio Selector s GENERAL DESCRIPTION The NJM2753 is 3-Input / 1-Output Stereo Audio Selector. The NJM2753 consists of switches and buffer operational amplifiers. Based on the internal switch op-amp technology, the NJM2753 features lower output noise, lower distortion and higher channel separation than the general Multiplexers or Analogue Switches. The NJM2753 contains compatibility with NJM2752(2in-1out SW),NJM2755(4in-1out SW). sAPPLICATIONS q LCD-TV/PDP-TV q Car Stereo q Any Audio System s FEATURES q Operating Voltage q 3-Input / 1-Output Stereo Audio Selector q Low Output Noise q Low Distortion q Bipolar Technology q Package Outline s PACKAGE OUTLINE NJM2753V 4.7 to 10V -114dBV typ. 0.0009% typ. SSOP14 s BLOCK DIAGRAM IN1A IN1B IN2A IN2B LOGIC CNT1 CNT2 OUTA IN3A OUTB IN3B V＋ Vref Vref GND Ver.1.0 -1- NJM2753 s PIN CONFIGURATIONS NJM2753 SSOP14 SSOP14 1 OUTA OUTB 14 NJM2753V 2 IN1A V+ IN2A CNT1 IN3A CNT2 IN1B GND IN2B Vref IN3B N.C 13 3 12 4 11 5 10 6 9 7 8 PIN.No. 1 2 3 4 5 6 7 SYMBOL OUTA IN1A V+ IN2A CNT1 IN3A CNT2 FUNCTION Ach Output Terminal Ach Input Terminal1 Power Supply Terminal Ach Input Terminal2 Control Switch Terminal1 Ach Input Terminal2 Control Switch Terminal2 PIN.No. 8 9 10 11 12 13 14 SYMBOL N.C IN3B Vref IN2B GND IN1B OUTB FUNCTION No Connection Bch Input Terminal3 Reference Terminal Bch Input Terminal2 GND Terminal Bch Input Terminal1 Bch Output Terminal [Reference] The NJM2753 contains compatibility with NJM2752 (2in-1out SW),NJM2755 (4in-1out SW). NJM2752 1 NJM2755 OUTB 14 OUTA 1 OUTA OUTB 16 NJM2752V NJM2755V 2 IN1A V+ IN2A CNT1 N.C N.C IN1B GND IN2B Vref N.C N.C 13 2 IN1A V+ IN2A CNT1 IN3A CNT2 IN4A IN1B GND IN2B Vref IN3B N.C IN4B 15 3 12 3 14 4 11 4 13 5 10 5 12 6 9 6 11 7 8 7 10 8 9 -2- NJM2753 s ABSOLUTE MAXIMUM RATINGS (Ta=25°C) PARAMETER SYMBOL Supply Voltage V + RATING 12 SSOP14 1) 450 2) 570 UNIT V Power Dissipation PD NOTE 1): EIA/JEDEC STANDARD Test board (76.2x114.3x1.6mm, 2layer, FR-4) mounting 2): EIA/JEDEC STANDARD Test board (76.2x114.3x1.6mm, 4layer, FR-4) mounting mW Operating Temperature Range Storage Temperature Range TOPR TSTR -40 to +85 -40 to +150 °C °C s ELECTRICAL CHARACTERISTICS ( Ta=25°C, V =9V) PARAMETER Operating Voltage Supply Current Reference Voltage Voltage Gain Total Harmonic Distortion Output Noise Voltage Maximum Output Voltage Cross Talk Channel Separation Switch-ON Voltage Level Switch-OFF Voltage Level Input Impedance Output Impedance s SWITCH CONTROL LOGIC CNT2 CNT1 INPUT SELECTOR Ach / Bch L L H L H L 1 2 3 SYMBOL V + + TEST CONDITION No Signal Vin=1Vrms, f=1kHz Vin=1Vrms, f=1kHz A-Weighted f=1kHz, THD=1% Vin=1Vrms, f=1kHz, A-Weighted Vin=1Vrms, f=1kHz, A-Weighted MIN. 4.7 -1 6 (2.0) 85 90 2.4 - TYP. 9.0 10 4.5 0 0.0009 -114 (2) 8 (2.5) 100 110 100 45 MAX. 10 15 1 0.03 -100 (10) 0.5 - UNIT V mA V dB % dBV (µVrms) dBV (Vrms) dB dB V V kΩ Ω ICC VREF GV THD+N VNO VOM CT CS VCH VCL RIN ROUT -3- NJM2753 s TERMINAL DESCRIPTION PIN No. 2 4 6 9 11 13 SYMBOL IN1A IN2A IN3A IN3B IN2B IN1B FUNCTION Ach Input Terminal1 Ach Input Terminal2 Ach Input Terminal3 Bch Input Terminal3 Bch Input Terminal2 Bch Input Terminal1 EQUIVALENT CIRCUIT TERMINAL VOLTAGE V+/2 650 100k 3p 5 7 CNT1 CNT2 Control Switch Terminal1 Control Switch Terminal2 0V (GND) CNT 650 100k 1 14 OUTA OUTB Ach Output Terminal Bch Output Terminal OUTA OUTB V+/2 45 100k 10 Vref Reference Terminal V+/2 VREF 50k 650 50k 3 12 V+ GND Power Supply Terminal GND Terminal V+ V+ 0V 12k GND -4- NJM2753 sMEASUREMENT CIRCUIT 10µF + 1 OUTA OUTB 14 + 10µF 10µF NJM2753 10µF + 2 IN1A V+ IN2A CNT1 IN3A CNT2 IN1B GND IN2B Vref IN3B N.C 13 + + 3 12 + 100µF 10µF + 10µF 10µF 10µF 4 11 5 10 + 10µF + + 6 9 7 8 -5- NJM2753 sAPPLICATION CIRCUIT 10µF + 1 OUTA OUTB 14 + 10µF 10µF NJM2753 10µF + 2 IN1A V+ IN2A CNT1 IN3A CNT2 IN1B GND IN2B Vref IN3B N.C 13 + + 3 12 + 100µF 10µF + 10µF 10µF 10µF 4 11 100k 5 10 + 1µF 6 + + 9 10µF 100k 1µF 7 8 Application note: Resistor(100k) and capacitor(1µF) connected to CNT1 are added to reduce pop-noise. The value of input capacitor connected to IN1A and IN2A depends on cut-off frequency(calculated by fc=1/2πRC) you need. R(input impedance)=100kΩ. -6- NJM2753 !TYPICAL CHARACTERISTICS ICC vs Supply Voltage No signal 14 VREF vs Supply Voltage No signal 7 25 C 105 C 12 10 ICC [mA] 8 6 4 2 0 0 2 4 6 8 10 12 14 Supply Voltage [V] o o 6 5 VREF[V] 4 3 2 1 0 0 -40 to 105oC -40oC 2 4 6 8 10 12 14 Supply Voltage [V] GAIN vs FrequencyV=9V, I/O: INA1-Aout 1 0.8 0.6 0.4 Gain Output [dB] 0.2 0 -0.2 -0.4 -0.6 -0.8 -1 10 100 1000 Frequency [Hz] 10000 100000 0.0001 0.01 10 100 THD+N vs Input Voltage BW:400-30kHz ,f=1kHz, I/O: INA1-Aout -40 to 105 C 1 THD+N [%] o -40oC 25oC 0.1 0.01 105oC 0.001 0.1 1 10 Input Voltage [Vrms] Maximum Output Voltage vs Frequency V=9V, THD=1%, I/O: INA1-Aout 2.7 2.65 THD+N vs Frequency I/O: INA1-Aout 1 0.1 THD+N [%] -40℃ 25℃　105℃ Maximum Output Voltage [Vrms ] 2.6 2.55 2.5 2.45 2.4 2.35 2.3 0.01 0.001 0.0001 10 100 1000 Frequency [Hz] 10000 100000 1 10 100 1000 10000 100000 Frequency [Hz] -7- NJM2753 !TYPICAL CHARACTERISTICS Maximum Output Voltage vs Supply Voltage THD=1%, I/O: INA1-1Aout 4 3.5 Maximum Output Voltage [Vrms ] 3 2.5 2 1.5 1 0.5 0 0 2 4 6 8 10 12 14 Supply Voltage [±V] Maximum Output Voltage [Vrms ] 3.0 Maximum Output Voltage vs Load Resistance V=9V, THD=1%, f=1kHz, I/O: INA1-Aout / INB1-Bout 2.5 2.0 1.5 1.0 0.5 0.0 1 10 100 RL[Ω] 1000 10000 100000 -40 -50 Cross Talk vs Frequency V=9V, Vin=1Vrms, BW:10-80kHz, I/O: INA2-IN3A/Aout, Select Channel:1ch -40 -50 Cross Talk vs Frequency V=9V, Vin=1Vrms, BW:10-80kHz, I/O: INA2-INA3/Aout, Select Channel:1ch Rg=5.1k Ω Rg=3.3k Ω -60 Cross Talk[dB] Cross Talk[dB] -70 -80 -90 -100 -60 -70 -80 -90 -100 105oC 25oC -40oC Rg=620Ω Rg=0Ω -110 10 100 1000 Frequency [Hz] 10000 100000 -110 10 100 1000 Frequency [Hz] 10000 100000 -40 -50 Channel Separation vs Frequency V=9V, Vin=1Vrms, BW:10-80kHz, I/O: INB1-Aout -40 -50 Channel Separation vs Frequency V=9V, Vin=1Vrms, BW:10-80kHz, I/O: INB1-Aout Rg=5.1k Ω Rg=3.3k Ω Channel Separation[dB] Channel Separation[dB] -60 -70 -80 -60 -70 -80 -90 -100 -110 10 100 1000 Frequency [Hz] 10000 100000 10 100 1000 Frequency [Hz] 10000 100000 Rg=620Ω -40 to 25oC 105oC Rg=0Ω -90 -100 -110 -8- NJM2753 !TYPICAL CHARACTERISTICS CNT Voltage vsCross Talk V=9V, Vin=1Vrms, A-w eghit I/O: IN2A-Aout 10 CNT Voltage vsCross Talk V=9V, Vin=1Vrms, A-w eghit I/O: IN1A-Aout 10 0 -10 -20 -30 Cross Talk[dB] -40 -50 -60 -70 -80 -90 -100 -110 -120 -130 1.5 -40 C 25oC Cross Talk[dB] o 0 -10 -20 -30 -40 -50 -60 -70 -80 -90 -100 -110 -120 -130 1 1.2 1.4 1.6 1.8 2 CNT Voltage[V] 105oC 25oC -40oC 105oC 1.7 1.9 2.1 2.3 2.5 CNT Voltage[V] [CAUTION] The specifications on this databook are only given for information , without any guarantee as regards either mistakes or omissions. The application circuits in this databook are described only to show representative usages of the product and not intended for the guarantee or permission of any right including the industrial rights. -9-