CWSB21FADF

Series CWSB Toggles Neon Miniature Power Rockers General Specifications B Electrical Capacity (Resistive Load) Power Level: 9A @ 125V AC Pushbuttons Rockers Other Ratings Programmable Illuminated PB Contact Resistance: Insulation Resistance: Dielectric Strength: Mechanical Life: Electrical Life: Nominal Operating Force: Angle of Throw: 20 milliohms maximum 500 megohms minimum @ 500V DC 1,500V AC minimum between contacts for 1 minute minimum; 3,000V AC minimum between contacts & case for 1 minute minimum 30,000 operations minimum 10,000 operations minimum 10.0N 30° Keylocks Materials & Finishes Rocker: Housing: Movable Contactor: Movable Contacts: Stationary Contacts: Switch Terminals: Lamp Terminals: Polycarbonate Polyamide Beryllium copper with silver plating Silver alloy Silver alloy Brass with silver plating Brass with silver plating Slides Rotaries Environmental Data Tactiles Operating Temp Range: Humidity: Vibration: Shock: –20°C through +85°C (–4°F through +185°F) 90 ~ 95% humidity for 96 hours @ 40°C (104°F) 10 ~ 55Hz with peak-to-peak amplitude of 0.75mm traversing the frequency range & returning in 1 minute; 3 right angled directions for 2 hours 50G (490m/s2) acceleration (tested in 6 right angled directions, with 5 shocks in each direction) Tilt Installation Soldering Time & Temp: Manual Soldering: See Profile B in Supplement section. Touch Standards & Certifications UL: Indicators File No. E44145 9A @ 125V AC Markings on case are standard. File No. 0701166_0_000 9A @ 125V AC Markings on case are standard. CSA: Supplement Accessories B18 www.nkk.com Neon Miniature Power Rockers Series CWSB Toggles Distinctive Characteristics Full face, Neon illumination in choice of red, amber, or green. Neon lamp suited to 125V AC applications. 9-amp electrical capacity in compact body. Built-in resistor for direct connection to 125V AC power source. Low cost molded rocker. Front panel, snap-in mounting assures labor-saving installation. Single-break, snap-acting contact mechanism gives smooth actuation and audible feedback. Quick-make, quick-break characteristic limits arcing and prolongs electrical life. Stable stationary contact construction for high reliability. Offset terminal alignment gives outstanding insulation resistance and dielectric strength. Solder lug/.187” quick connect terminals can be used with connectors. Actual Size B www.nkk.com B19 Supplement Accessories Indicators Touch Tilt Tactiles Slides Rotaries Keylocks Programmable Illuminated PB Pushbuttons Rockers Series CWSB Toggles Neon Miniature Power Rockers TYPICAL SWITCH ORDERING EXAMPLE Rockers B CWSB Poles 2 DPST 2 1 C A C Cap Colors C D F Red Amber Green F Pushbuttons Programmable Illuminated PB Neon Lamp Colors C D F Red Amber Green Circuit 1 ON NONE OFF H ousing A Black F Terminals Solder Lug/ .187” (4.75mm) Quick Connect * Keylocks Rotaries * Wire harness & cable assemblies offered only in Americas DESCRIPTION FOR TYPICAL ORDERING EXAMPLE CWSB21CACF Slides Red Rocker Cap DPST ON-NONE-OFF Circuit Solder Lug/ Quick Connect Terminals Red Neon Lamp Tactiles Black Housing Tilt IMPORTANT: Switches are supplied with UL & CSA markings on case. Specific models & ratings noted on General Specifications page. Touch Indicators POLE & CIRCUIT Rocker Position Pole Model Down Center Up Connected Terminals Down Center Up Throw & Switch/Lamp Schematic Note: Terminal numbers “1a” & “2a” are actually on the switch. DPST 2 1 2a 1a Supplement Accessories DP CWSB21 ON NONE OFF 1-1a 2-2a OPEN OPEN B20 www.nkk.com Neon Miniature Power Rockers NEON LAMP COLORS & SPECIFICATIONS The Neon lamp is factory assembled and not available separately. The lamp circuit is synchronous to switching circuit. The electrical specifications shown are determined at a basic temperature of 25°C. Values for the built-in resistors are given in the accompanying table. Neon Lamp Series CWSB Colors Toggles L o a d 2 1 2a 1a Source C Red D Amber 125V AC 33K ohms 1.4mA 15,000 F Green 125V AC 68K ohms 0.6mA 8,000 B Voltage Internal Series Resistance Current Endurance V I Hours 125V AC 33K ohms 1.4mA 15,000 HOUSING A Black Housing with Snap-in Mounting TERMINALS F Solder Lug/ .187” (4.75mm) Quick Connect (8.1) .319 (4.75) .187 Thk = (0.8) .031 (2.65) .104 On Off (I O) symbols are molded on the bezel. (1.15)R .045 (0.8)R .031 Cap Colors Available Red Green Double Pole (2.3) Dia Typ .091 (1.6) Dia Typ .063 (2.5) Typ .098 (4.0) Typ .157 Neon Illuminated (5.7) .224 (21.1) .831 (12.9) .508 30° (17.4) .685 (19.2) .756 2a 1a (10.6) .417 (15.1) .594 (2.0) .079 (16.2) .638 (1.0) .039 (8.1) .319 (12.6) .496 (12.9) .508 CWSB21CACF www.nkk.com B21 Supplement Panel Thickness .030” ~ .079” (0.75mm ~ 2.0mm) Accessories (2.65) .104 (0.8) Typ .031 (12.9) .508 Indicators (15.8) .622 (4.75) Typ .187 (18.6) .732 (4.0) .157 (5.0) .197 Touch Tilt TYPICAL SWITCH DIMENSIONS Tactiles C D Amber F Caps are factory assembled and are not available separately. Slides CAP COLOR CODES Rotaries Keylocks Programmable Illuminated PB Pushbuttons Rockers