CWSC11JFAFS

Series CWSC Toggles LED Miniature Power Rockers Rockers B General Specifications Electrical Capacity (Resistive Load) Power Level: 9A @ 125V AC or 6A @ 250V AC Pushbuttons Other Ratings Programmable Illuminated PB Contact Resistance: Insulation Resistance: Dielectric Strength: Mechanical Life: Electrical Life: Nominal Operating Force: Angle of Throw: 20 milliohms maximum 500 megohms minimum @ 500V DC 1,500V AC minimum between contacts for 1 minute minimum; 3,000V AC minimum between contacts & case for 1 minute minimum 30,000 operations minimum 10,000 operations minimum Single Pole 4.50N; Double Pole 10.0N 33° Keylocks Materials & Finishes Rocker: Housing: Movable Contactor: Movable Contacts: Stationary Contacts: Switch Terminals: Lamp Terminals: Polycarbonate Polyamide Beryllium copper with silver plating Silver alloy Silver alloy Brass with silver plating Brass with silver plating Slides Rotaries Environmental Data Tactiles Operating Temp Range: Humidity: Vibration: Shock: –10°C through +50°C (+14°F through +122°F) 90 ~ 95% humidity for 96 hours @ 40°C (104°F) 10 ~ 55Hz with peak-to-peak amplitude of 1.5mm traversing the frequency range & returning in 1 minute; 3 right angled directions for 2 hours 50G (490m/s2) acceleration (tested in 6 right angled directions, with 5 shocks in each direction) Tilt Installation Soldering Time & Temp: Manual Soldering: See Profile A in Supplement section. Touch Standards & Certifications UL: File No. E44145 All models recognized at 9A @ 125V AC & 6A @ 250V AC. cULus marking on case is standard. Supplement Accessories Indicators B22 www.nkk.com LED Miniature Power Rockers Series CWSC Toggles Interior shield prevents contamination of the rocker by carbon from arcing. Front panel, snap-in mounting assures labor-saving installation. Single-break, snap-acting contact mechanism gives smooth actuation and audible feedback. Quick-make, quick-break characteristic limits arcing and prolongs electrical life. Stable stationary contact construction for high reliability. Offset terminal alignment gives outstanding insulation resistance and dielectric strength. Solder lug/.110” quick connect terminals can be used with connectors. Actual Size www.nkk.com B23 Supplement Accessories Indicators Touch Tilt Tactiles Slides Rotaries Keylocks Programmable Illuminated PB 9-amp or 6-amp electrical capacity in compact body. Pushbuttons Full face, bright LED illumination in choice of red, amber, or green for visible status indication. B Rockers Distinctive Characteristics Series CWSC Toggles LED Miniature Power Rockers TYPICAL SWITCH ORDERING EXAMPLE Rockers B CWSC Poles 1 2 SPST DPST 2 1 JC A Housing A Black C S Terminals S Solder Lug/ .110” (2.79mm) Quick Connect * Programmable Illuminated PB Pushbuttons Circuit 1 ON NONE OFF Cap/Diffuser Colors JC JD JF Clear/Red Clear/Amber Clear/Green LED Colors C D F Red Amber Green Keylocks Slides Rotaries * Wire harness & cable assemblies offered only in Americas TYPICAL ORDERING EXAMPLE Tactiles CWSC21JCACS Clear Rocker Cap with Red Diffuser DPST ON-NONE-OFF Circuit Solder Lug/ Quick Connect Terminals Red LED Tilt Black Housing Indicators Touch IMPORTANT: Switches are supplied with cULus marking on case. Specific models & ratings noted on General Specifications page. Supplement Accessories B24 www.nkk.com LED Miniature Power Rockers POLE & CIRCUITS Rocker Position Pole Model Down Center Up Series CWSC Connected Terminals Down Center Up Throw & Switch/Lamp Schematics Notes: Terminal numbers and polarity are actually on the switch. 1 (COM) B SP CWSC11 ON NONE OFF 1-1a OPEN OPEN SPST 1 (+) (-) 1a DP CWSC21 ON NONE OFF 1-1a 2-2a OPEN OPEN DPST 1a 2a (+) (-) CAP TYPES & COLORS Rocker Cap/Diffuser Caps are factory assembled and are not available separately. Cap/Diffuser Colors Available JC JD JF HOUSING Clear/Amber Clear/Green TERMINALS S Solder Lug/ .110” (2.79mm) Quick Connect (7.1) .280 (3.2) .126 (2.79) .110 (1.6) .063 Thk = (0.5) .020 A Black Housing with Snap-in Mounting LED SPECIFICATIONS & COLORS The LED is factory assembled and not available separately. LED circuit is isolated and requires an external power source. Polarity marks are on the bottom of the switch. The electrical specifications shown are determined at a basic temperature of 25°C. If the source voltage exceeds the rated voltage, a ballast resistor is required. The resistor value can be calculated by using the formula in the Supplement. C (+) (-) D Amber 30mA 20mA 2.0V 5V 0.29mA/°C –10°C ~ +50°C F Green 30mA 20mA 2.1V 5V 0.39mA/°C Colors: I FM IF VF VRM ∆I F Red 30mA 20mA 1.95V 5V 0.41mA/°C Continuous Forward Current Forward Voltage Reverse Peak Voltage Current Reduction Rate above 25°C Ambient Temperature Range www.nkk.com B25 Supplement Accessories Indicators Forward Peak Current Touch Tilt Tactiles On Off (I O) symbols are molded on the bezel. Slides Rotaries Keylocks Clear/Red Programmable Illuminated PB (COM) 2 Pushbuttons Rockers Toggles Series CWSC Toggles LED Miniature Power Rockers TYPICAL SWITCH DIMENSIONS LED Illuminated Rockers Single Pole (5.7) .224 NKK P/N This Side (2.79) Typ .110 (1.7) Typ .067 (0.5) Typ .020 B (15.7) .618 (21.1) .831 (12.9) .508 33° Pushbuttons (0.5) (4.5) .020 .177 (5.5) (18.6) .217 .732 2 2a 1 1a (2.25) Typ .089 (12.9) .508 (19.2) .756 Programmable Illuminated PB (2.0) .079 (10.6) .417 (15.1) .594 (17.7) .697 (7.1) .280 (1.6) Typ .063 (3.2) Typ .126 (4.95) .195 (12.6) .496 (12.9) .508 CWSC11JCACS Panel Thickness .030” ~ .079” (0.75mm ~ 2.0mm) LED Illuminated (5.7) .224 Double Pole NKK P/N This Side (2.79) Typ .110 (1.7) Typ .067 (0.5) Typ .020 Keylocks (15.7) .618 Rotaries (21.1) .831 33° (12.9) .508 (0.5) (4.5) .020 .177 (5.5) (18.6) .217 .732 2 2a 1 1a (2.25) Typ .089 (12.9) .508 (19.2) .756 (1.6) Typ .063 (10.6) .417 (15.1) .594 (2.0) .079 (3.2) Typ .126 (4.95) Typ .195 Slides (17.7) .697 (7.1) .280 (12.6) .496 (12.9) .508 CWSC21JCACS Tactiles Panel Thickness .030” ~ .079” (0.75mm ~ 2.0mm) Supplement Accessories Indicators Touch Tilt B26 www.nkk.com