FS22ABP

Toggles Series FS Rockers General Specifications Pushbuttons For high frequency (DC through 1GHz): Isolation 40dB minimum at 1GHz. Insertion loss 0.5dB maximum at 1GHz. Programmable Illuminated PB Innovative alternative to relay products Highly reliable, self-cleaning twin contact mechanism with gold plating Long total travel of .138” (3.5mm) for highly visible actuator position Distinct audible and tactile feedback during actuation Keylocks Suited to high frequency applications (90MHz to 1GHz) such as CATV and communication equipment Slides Rotaries Distinctive Characteristics Electrical Capacity (Resistive Load) H Logic Level: Tactiles Impedance: Insertion Loss: Isolation: Indicators Touch Tilt Other Ratings Accessories Actual Size with Tall Actuator Impedance 75 ohms RF Ratings Supplement Miniature Slides for High Frequency Contact Resistance: Insulation Resistance: Dielectric Strength: Mechanical Life: Electrical Life: Contact Timing: Total Travel: Environmental Data Operating Temp Range: Humidity: Vibration: Shock: Installation Soldering Time & Temp: Cleaning: H14 0.4VA maximum @ 28V AC/DC maximum (Applicable Range 0.1mA ~ 0.1A @ 20mV ~ 28V) Note: Find additional explanation of operating range in Supplement section. 75 ohms 0.5dB maximum @ 1GHz 40dB minimum @ 1GHz 200 milliohms maximum 250 megohms minimum @ 500V DC 500V AC minimum for 1 minute minimum 1,000 operations minimum 1,000 operations minimum Nonshorting (break-before-make) .138” (3.5mm) –30°C through +85°C (–22°F through +185°F) 90 ~ 95% humidity for 240 hours @ 40°C (104°F) 10 ~ 55Hz with peak-to-peak amplitude of 1.5mm traversing the frequency range & returning in 5 minutes; 3 right angled directions for 2 hours 50G (490m/s2) acceleration (tested in 6 right angled directions, with 5 shocks in each direction) Wave Soldering: See Profile A in Supplement section. Manual Soldering: See Profile A in Supplement section. These devices are not process sealed. Hand clean locally using alcohol based solution. www.nkkswitches.com Series FS Toggles Miniature Slides for High Frequency 2 2 A A P Pole A DPDT Terminals P DC through 1GHz Circuit ON Actuators NONE ON A Short (.291” or 7.4mm) B Tall (.488” or 12.4mm) Rotaries 2 Straight PC Keylocks 2 Frequency Band Programmable Illuminated PB Pushbuttons FS Rockers TYPICAL SWITCH ORDERING EXAMPLE H Tactiles FS22AAP Slides DESCRIPTION FOR TYPICAL ORDERING EXAMPLE Short Actuator DPDT ON-NONE-ON Circuit Tilt Frequency Band DC through 1GHz Touch Straight PC Terminals Model DP FS22 Left Center Right Left Center Right ON NONE ON 2-1 5-4 NA 2-3 5-6 Throw & Schematics Note: Terminal numbers are not actually on the switch. 2 www.nkkswitches.com DPDT 1 (COM) 3 4 5 6 H15 Accessories Pole Connected Terminals Supplement Slide Position Indicators POLE & CIRCUIT Series FS Toggles Miniature Slides for High Frequency HIGH FREQUENCY PERFORMANCE RF Connection Options 5 2 6 3 Out In 4 1 5 2 6 3 Out In Keylocks 1 5 2 6 3 Out In Out 2 A T = Terminator A = Amplifier or other device Isolation Insertion Loss >40dB @ 1GHz (higher value is better)