COP688FH

COP888FH 8-Bit CMOS ROM Based Microcontrollers with 12k Memory, Comparators, USART and Hardware Multiply/Divide September 1999 COP888FH 8-Bit CMOS ROM Based Microcontrollers with 12k Memory, Comparators, USART and Hardware Multiply/Divide General Description The COP888FH Family of ROM based microcontrollers are highly integrated COP8™ Feature core devices with 12k memory and advanced features including Analog comparators, and Hardware Multiply/Divide. These single-chip CMOS devices are suited for more complex applications requiring a full featured controller, low EMI, two comparators, a full-duplex USART, and hardware multiply/divide functions. COP87L88FH devices are pin and software compatible (different VCC range) 16k OTP (One Time Programmable) versions for pre-production , and for use with a range of COP8 software and hardware development tools. Device COP684FH COP884FH COP984FH COP688FH COP888FH COP988FH Memory (bytes) RAM (bytes) I/O Pins 12k ROM 12k ROM 12k ROM 12k ROM 12k ROM 12k ROM 512 512 512 512 512 512 24 24 24 36/40 36/40 36/40 Family features include an 8-bit memory mapped architecture, 10 MHz CKI with 1µs instruction cycle, hardware multiply/divide functions, three multi-function 16-bit timer/ counters with PWM, full duplex USART, MICROWIRE/ PLUS™, two Analog comparators, two power saving HALT/ IDLE modes, MIWU, idle timer, high current outputs, software selectable options WATCHDOG™ and clock/ oscillator mode, low EMI 2.5V to 5.5V operation, and 28/ 40/44 pin packages. Devices included in this data sheet are: Packages 28 DIP/SOIC 28 DIP/SOIC 28 DIP/SOIC Temperature -40 to +85˚C 0 to +70˚C Comments -55 to +125˚C 4.5V to 5.5V 2.5V to 4.0V, FHH=4.0V to 6.0V 40 DIP, 44 PLCC -55 to +125˚C 4.5V to 5.5V 40 DIP, 44 PLCC -40 to +85˚C 40 DIP, 44 PLCC 0 to +70˚C 2.5V to 4.0V, FHH=4.0V to 6.0V Key Features n Hardware Multiply/Divide Functions n Full duplex USART n Three 16-bit timers, each with two 16-bit registers supporting: — Processor Independent PWM mode — External Event counter mode — Input Capture mode n Quiet design (low radiated emissions) n 12 kbytes on-board ROM n 512 bytes on-board RAM I/O Features n Software selectable I/O options ( TRI-STATE ® , Push-Pull, Weak Pull-Up, and High Impedance Input) n Schmitt trigger inputs on ports G and L n Packages: — 40 DIP with 36 I/O pins — 44 PLCC with 40 I/O pins — 28 DIP/SO with 24 I/O pins CPU/Instruction Set Features n 1 µs instruction cycle time n Fourteen multi-source vectored interrupts servicing — External Interrupt — Idle Timer T0 — Three Timers (Each with 2 Interrupts) — MICROWIRE/PLUS — Multi-Input Wake Up — Software Trap — USART (2) — Default VIS (default interrupt) n Versatile and easy to use instruction set Additional Peripheral Features n n n n n Idle Timer Multi-Input Wakeup (MIWU) with optional interrupts (8) Two analog comparators WATCHDOG and Clock Monitor logic MICROWIRE/PLUS serial I/O COP8™ is a trademark of National Semiconductor Corporation. MICROWIRE™ is a trademark of National Semiconductor Corporation. MICROWIRE/PLUS™ is a trademark of National Semiconductor Corporation. TRI-STATE ® is a registered trademark of National Semiconductor Corporation. WATCHDOG™ is a trademark of National Semiconductor Corporation. iceMASTER™ is a trademark of MetaLink Corporation. © 1999 National Semiconductor Corporation DS012602 www.national.com CPU/Instruction Set Features (Continued) n 8-bit Stack Pointer (SP) — stack in RAM n Two 8-bit Register Indirect Data Memory Pointers (B and X) Fully Static CMOS n n n n Low current drain (typically < 5 µA) Two power saving modes: HALT and IDLE Single supply operation: 2.5V–5.5V Temperature ranges: 0˚C to +70˚C, −40˚C to +85˚C −55˚C to +125˚C Development Support n Emulation and OTP devices n Real time emulation and full program debug offered by MetaLink Development System Block Diagram DS012602-1 FIGURE 1. COP888FH Block Diagram www.national.com 2 Connection Diagrams Plastic Chip Carrier Dual-In-Line Package DS012602-2 Top View Order Number COP688FH-XXX/V, COP888FH-XXX/V or COP988FH-XXX/V See NS Plastic Chip Package Number V44A DS012602-3 Top View Order Number COP688FH-XXX/N, COP888FH-XXX/N or COP988FH-XXX/N See NS Molded Package Number N40A Dual-In-Line Package DS012602-4 Order Number COP684FH-XXX/M, COP884FH-XXX/M, COP984FH-XXX/M, COP684FH-XXX/N, COP884FH-XXX/N or COP984FH-XXX/N See NS Molded Package Number M28B or N28B FIGURE 2. Connection Diagrams 3 www.national.com Connection Diagrams Port L0 L1 L2 L3 L4 L5 L6 L7 G0 G1 G2 G3 G4 G5 G6 G7 D0 D1 D2 D3 D4 D5 D6 D7 I0 I1 I2 I3 I4 I5 I6 I7 C0 C1 C2 C3 C4 C5 C6 C7 VCC GND CKI RESET Type I/O I/O I/O I/O I/O I/O I/O I/O I/O WDOUT I/O I/O I/O I/O I I/CKO O O O O O O O O I I I I I I I I I/O I/O I/O I/O I/O I/O I/O I/O (Continued) Pinouts for 28-, 40- and 44-Pin Packages Alt. Fun MIWU MIWU MIWU MIWU MIWU MIWU MIWU MIWU INT T1B T1A SO SK SI HALT Restart CKX TDX RDX T2A T2B T3A T3B Alt. Fun 28-Pin Pack. 11 12 13 14 15 16 17 18 25 26 27 28 1 2 3 4 19 20 21 22 40-Pin Pack. 17 18 19 20 21 22 23 24 35 36 37 38 3 4 5 6 25 26 27 28 29 30 31 32 7 COMP1IN− COMP1IN+ COMP1OUT COMP2IN− COMP2IN+ COMP2OUT 8 9 10 9 10 11 12 13 14 15 16 39 40 1 2 44-Pin Pack. 17 18 19 20 25 26 27 28 39 40 41 42 3 4 5 6 29 30 31 32 33 34 35 36 9 10 11 12 13 14 15 16 43 44 1 2 21 22 23 24 6 23 5 24 8 33 7 34 8 37 7 38 www.national.com 4 COP98xFH Absolute Maximum Ratings (Note 1) If Military/Aerospace specified devices are required, please contact the National Semiconductor Sales Office/ Distributors for availability and specifications. Supply Voltage (VCC) Voltage at Any Pin −0.3V to VCC 7V + 0.3V Total Current into VCC Pin (Source) Total Current out of GND Pin (Sink) Storage Temperature Range 100 mA 110 mA −65˚C to +140˚C Note 1: Absolute maximum ratings indicate limits beyond which damage to the device may occur. DC and AC electrical specifications are not ensured when operating the device at absolute maximum ratings. DC Electrical Characteristics COP98xFH: 0˚C ≤ TA ≤ +70˚C unless otherwise specified Parameter Operating Voltage COP98XFH COP98XFHH Power Supply Ripple (Note 2) Supply Current (Note 3) CKI = 10 MHz CKI = 4 MHz CKI = 4 MHz CKI = 1 MHz HALT Current (Note 4) IDLE Current CKI = 10 MHz CKI = 4 MHz CKI = 1 MHz Input Levels RESET Logic High Logic Low CKI (External and Crystal Osc. Modes) Logic High Logic Low All Other Inputs Logic High Logic Low Hi-Z Input Leakage Input Pullup Current G and L Port Input Hysteresis VCC = 5.5V, VIN = 0V VCC = 5.5V, VIN = 0V −1 −40 0.7 VCC 0.2 VCC +1 −250 0.35 VCC V V µA µA V 0.7 VCC 0.2 VCC V V 0.8 VCC 0.2 VCC V V Peak-to-Peak VCC = 5.5V, tc = 1 µs VCC = 5.5V, tc = 2.5 µs VCC = 4V, tc = 2.5 µs VCC = 4V, tc = 10 µs VCC = 5.5V, CKI = 0 MHz VCC = 4V, CKI = 0 MHz VCC = 5.5V, tc = 1 µs VCC = 5.5V, tc = 2.5 µs VCC = 4V, tc = 10 µs Conditions Min 2.5 4.0 Typ Max 4.0 6.0 0.1 VCC 12.5 5.5 2.5 1.4 Units V V V mA mA mA mA µA µA mA mA mA