NEVH1.0M450

ALUMINUM ELECTROLYTIC 160V to 450V NEVH, NEHH SERIES SUBMINIATURE HIGH VOLTAGE (NEVH: Radial Lead, NEHH: Axial Leads) The NEVH and NEHH series subminiature aluminum electrolytic capacitors are ideal for polarized capacitor applications requiring small size, high capacitance, high voltage, low cost, and dependability over broad temperature ranges. MECHANICAL SPECIFICATIONS Lead Solderability: Meets the requirements of MIL - STD 202, Method 208 Marking: Consists of series type, nominal capacitance, rated voltage, temperature range, anode and/or cathode identification, vendor identification. Recommended Cleaning Solvents: Methanol, isopropanol ethanol, isobutanol, petroleum ether, propanol and/or commercial detergents. Halogenated hydrocarbon cleaning agents such as Freon (MF, TF, or TC), trichloroethylene, trichloroethane, or methylchloride are not recommended as they may damage the capacitor. RATINGS Capacitance Range: 1.0µf to 470µf Tolerance: - 10%, +75% Voltage Range: 160V to 450V PERFORMANCE SPECIFICATIONS Operating Temperature Range: • For 160V and 250V: - 40°C to +85°C ( - 40°F to +185°F) • For 350V and 450V: - 25°C to +85°C ( - 13°F to +185°F) Leakage Current: I ≤ 0.02CV + 100µA (measured after 3 minutes of applied voltage) I = Leakage Current (µA) C = Nominal Capacitance (µf) V = Rated Voltage (V) Capacitance Tolerance (M): at +20°C (+68°F), 120HZ Capacitance Values through 4.7µf - 10% to +75% Capacitance Values above 4.7µf - 10% to +50% Dissipation Factor: at +20°C (+68°F),120HZ Rated Voltage 1.0µf to 470µf Comparison Z WV 160, 250, and 350 0.20 450 0.25 CASE SIZE AND DIMENSIONS: NEVH SERIES Insulating Sleeve 18.0 Min dØ A ±0.5  L L’ 5.0 Min L’ = L + 1.0 Max at D Ø ≤ 8.0 DØ D’ Ø L’ = L + 2.0 Max at D Ø ≥ 10.0 D’ Ø = D Ø + 0.5 Max Impedance Ratio at Low Temperature: 120HZ 160 - 250 2 4 350 2 450 Z @ - 25°C ( - 13°F)/ Z @ +20°C (+68°F) Z @ - 40°C ( - 40°F)/ Z @ +20°C (+68°F) NEHH SERIES (Insulating Bar = Negative) 2 L Insulating Sleeve dØ Surge Voltage: DC Rated Voltage Surge Voltage 160 200 250 300 350 400 450 500  2.3 Max DØ 35.0 Min L’ 35.0 Min D’ Ø Load Life: 1000 ±12Hrs @ +85°C (+185°F), at rated voltage Leakage Current: Within values specified above Dissipation Factor: Within ±200% of specified value Capacitance Change Max: See Table Rated Voltage 160V to 450V Capacitance Change Max Within 20% of the initial value D’ Ø = D Ø + 0.5 Max L’ = L + 1.0 Max at D Ø ≤ 8.0 L’ = L + 2.0 Max at D Ø ≥ 10.0 Shelf Life: 1000 Hrs @ +85°C (+185°F), no voltage applied Leakage Current: Within ±200% of specified value Dissipation Factor: Within ±150% of specified value Capacitance Change Max: Within ±20% of initial value ORDERING INFORMATION NEVH Series Capacitance Tolerance Voltage 47 M 160 NTE Electronics, Inc. D Voice (800) 631 - 1250 (973) 748 - 5089 D FAX (973) 748 - 6224 D http://www.nteinc.com 5 ALUMINUM ELECTROLYTIC 160V to 450V NEVH, NEHH SERIES NEVH Series (Radial Type) Dimensions: Diameter (D Ø) x Length (L): mm WV Cap (µf) 1.0 2.2 3.3 4.7 10 22 33 47 100 220 330 470 160 6.3 x 11 6.3 x 11 8 x 11.5 8 x 11.5 10 x 12.5 10 x 20 13 x 21 13 x 25 16 x 25 18 x 35 22 x 35 22 x 40 250 6.3 x 11 8 x 11.5 10 x 12.5 10 x 12.5 10 x 20 13 x 25 13 x 25 16 x 25 18 x 36 350 8 x 11.5 10 x 12.5 10 x 16 10 x 16 13 x 21 13 x 25 16 x 31.5 18 x 36 22 x 35 450 10 x 12.5 10 x 16 10 x 20 13 x 20 13 x 25 16 x 31.5 18 x 35.5 22 x 35 25 x 40 * These dimensions are for reference only, please consult the factory for actual size. NEVH Series (Radial Type) Mechanical Specifications: mm Outside Diameter (D Ø) Lead Spacing (A) Lead Diameter (d Ø) 6.3 2.5 0.5 8 3.5 0.6 10 5 0.6 13 5 0.6 16 7.5 0.8 18 7.5 0.8 22 10 0.8 25 12.5 1.0 * These dimensions are for reference only, please consult the factory for actual size. NEHH Series (Axial Type) Dimensions: Diameter (D Ø) x Length (L): mm WV Cap (µf) 1.0 2.2 3.3 4.7 10 22 33 47 100 220 330 470 160 6.3 x 16 8 x 16 8 x 16 8 x 20 10 x 25 10 x 20 13 x 25 13 x 30 16 x 30 22 x 40 25 x 52 22 x 52 250 8 x 16 8 x 20 10 x 20 10 x 20 10 x 20 13 x 25 13 x 30 16 x 30 16 x 40 350 8 x 16 10 x 20 10 x 20 10 x 20 13 x 25 13 x 30 16 x 30 16 x 40 18 x 40 450 10 x 20 10 x 20 10 x 20 13 x 25 13 x 30 16 x 30 16 x 40 16 x 40 22 x 40 * These dimensions are for reference only, please consult the factory for actual size. NEHH Series (Axial Type) Mechanical Specifications: mm Outside Diameter (D Ø) Lead Diameter (d Ø) 6.3 0.6 8 0.6 10 0.6 13 0.8 16 0.8 18 0.8 22 0.8 25 0.8 * These dimensions are for reference only, please consult the factory for actual size. 6 NTE Electronics, Inc. D Voice (800) 631 - 1250 (973) 748 - 5089 D FAX (973) 748 - 6224 D http://www.nteinc.com