BGA3131J

+9 4) 1  BGA3131 DOCSIS 3.1 upstream amplifier Rev. 1 — 13 May 2016 Product data sheet 1. General description The BGA3131 is an upstream amplifier meeting the Data Over Cable Service Interface Specifications (DOCSIS 3.1). It is designed for cable modem, CATV set top box and VoIP modem applications. The device operates from 5 MHz to 205 MHz. The BGA3131 provides 58 dB gain control range in 1 dB increments with high incremental accuracy. Its maximum gain setting delivers 37 dB voltage gain and a superior linear performance. It supports the DOCSIS 3.1 output power levels while meeting the stringent ACLR requirements. The BGA3131 operates at 5 V supply. The gain is controlled via a 3-wire serial interface (SPI-Bus). The current consumption can be reduced in 4 steps via the serial interface. This interface enables the user to optimize between DC power efficiency and linearity. In addition, the current is automatically reduced at lower gain settings while preserving the linearity performance. In disable mode, the device draws typically 25 mA while it can be still programmed to new gain and current settings. The BGA3131 is housed in 20 pins 5 mm  5 mm leadless HVQFN package. 2. Features and benefits              58 dB gain control range in 1 dB steps using a 3-wire serial interface 5 MHz to 205 MHz frequency operating range  0.4 dB incremental gain step accuracy Maximum voltage gain 37 dB Excellent IMD3 of 60 dBc at 68 dBmV total output power Excellent second harmonic level of 60 dBc at 68 dBmV total output power Excellent third harmonic level of 60 dBc at 68 dBmV total output power Excellent noise figure of 6.5 dB at maximum gain Capable of transmitting modulated carriers while meeting the DOCSIS 3.1 ACLR specification. At an output power of 65 dBmV at the F-connector (assuming 3 dB of output loss), the typical ACLR is64 dBc 5 V single supply operation Excellent ESD protection at all pins Unconditionally stable Compliant to Directive 2002/95/EC, regarding Restriction of Hazardous Substances (RoHS) BGA3131 NXP Semiconductors DOCSIS 3.1 upstream amplifier 3. Applications  DOCSIS 3.1 and 3.0 cable modems  VoIP modems  Set-top boxes 4. Quick reference data Table 1. Quick reference data Typical values at VCC = 5 V; current setting = 3 mA; gain setting 50 up to and including 63; Tcase = 25 C; Zi(dif) = 200 ; Zo(se) = 75 ; voltage gain does include loss due to output transformer; unless otherwise specified. All RF parameters are measured on an application board with the circuit as shown in Figure 12 and components implemented as listed in Table 15. Symbol Parameter Conditions Min Typ Max Unit ICC supply current transmit-enable mode; TX_EN = HIGH 610 660 720 mA transmit-disable mode; TX_EN = LOW - 25 - mA - 37 - dB [1][2] Gv voltage gain gain code = 111111 NF noise figure transmit-enable mode; gain code = 111111 - 6.5 - dB 2H second harmonic level transmit-enable mode; gain code = 111111; Pi(RMS) = 31.0 dBmV; PL(RMS) = 68.0 dBmV into 75  impedance - 65 - dBc 3H third harmonic level transmit-enable mode; gain code = 111111; Pi(RMS) = 31.0 dBmV; PL(RMS) = 68.0 dBmV into 75  impedance - 65 - dBc IMD3 third-order transmit-enable mode; gain code = 111111; intermodulation distortion PL(RMS) = 65.0 dBmV per tone into 75  impedance - 60 - dBc PL(1dB) output power at 1 dB gain CW input signal RMS value; compression frequency = 205 MHz - 78 - dBmV [1] Pi