BC212LB_J35Z

BC212LB BC212LB PNP General Purpose Amplifier • This device is designed for general purpose amplifier application at collector currents to 100mA. • Sourced from process 68. TO-92 1 1. Emitter 2. Collector 3. Base Absolute Maximum Ratings* TC=25°C unless otherwise noted Symbol VCEO Collector-Emitter Voltage Parameter Value 50 VCBO Collector-Base Voltage 60 V VEBO Emitter-Base Voltage 5 V IC Collector Current 100 mA TJ, TSTG Operating and Storage Junction Temperature Range - 55 ~ 150 °C - Continuous Units V * These ratings are limiting values above which the serviceability of any semiconductor device may be impaired. NOTES: 1. These ratings are based on a maximum junction temperature of 150°C. 2. These are steady state limits. The factory should be consulted on applications involving pulsed or low duty cycle operations Electrical Characteristics TC=25°C unless otherwise noted Symbol Parameter Off Characteristics BVCEO Collector-Emitter Breakdown Voltage Test Condition Min. Typ. Max. Units IC = 2mA 50 V BVCBO Collector-Base Breakdown Voltage IC = 10µA 60 V 5 BVEBO Emitter-Base Breakdown Voltage IE = 10µA ICBO Collector Cut-off Current VCB = 30V 15 nA IEBO Emitter Cut-off Current VEB = 4V 15 nA On Characteristics* hFE DC Current Gain VCE = 5V, IC = 10µA VCE = 5V, IC = 2mA V 40 60 VCE(sat) Collector-Emitter Saturation Voltage IC = 100mA, IB = 5mA 0.6 V VBE(sat) Base-Emitter Saturation Voltage IC = 100mA, IB = 5mA 1.4 V VBE(on) Base-Emitter On Voltage VCE = 5V, IC = 2mA 0.72 V 6 pF 10 dB Small Signal Characteristics Cob Output Capacitance VCE = 10V, f = 1MHz hFE Small Signal Current Gain VCE = 5V, IC = 2mA, f = 1KHz NF Noise Figure VCE = 5V, IC = 200µA, f = 1KHz RG = 2KΩ, BW = 200Hz 0.6 60 * Pulse Test: Pulse Width < 300µs, Duty Cycle < 2.0% ©2002 Fairchild Semiconductor Corporation Rev. A1, August 2002 Symbol PD Parameter Total Device Dissipation Derate above 25°C Max. 350 2.8 Units mW mW/°C RθJA Thermal Resistance, Junction to Ambient 357 °C/W RθJC Thermal Resistance, Junction to Case 125 °C/W ©2002 Fairchild Semiconductor Corporation Rev. A1, August 2002 BC212LB Thermal Characteristics TA=25°C unless otherwise noted BC212LB Package Dimensions TO-92 +0.25 4.58 ±0.20 4.58 –0.15 ±0.10 14.47 ±0.40 0.46 1.27TYP [1.27 ±0.20] 1.27TYP [1.27 ±0.20] ±0.20 (0.25) +0.10 0.38 –0.05 1.02 ±0.10 3.86MAX 3.60 +0.10 0.38 –0.05 (R2.29) Dimensions in Millimeters ©2002 Fairchild Semiconductor Corporation Rev. A1, August 2002 TRADEMARKS The following are registered and unregistered trademarks Fairchild Semiconductor owns or is authorized to use and is not intended to be an exhaustive list of all such trademarks. ACEx™ FACT™ FACT Quiet series™ ActiveArray™ FAST® Bottomless™ FASTr™ CoolFET™ CROSSVOLT™ FRFET™ GlobalOptoisolator™ DOME™ GTO™ EcoSPARK™ HiSeC™ E2CMOS™ EnSigna™ I2C™ Across the board. Around the world.™ The Power Franchise™ Programmable Active Droop™ ImpliedDisconnect™ ISOPLANAR™ LittleFET™ MicroFET™ MicroPak™ MICROWIRE™ MSX™ MSXPro™ OCX™ OCXPro™ OPTOLOGIC® OPTOPLANAR™ PACMAN™ POP™ Power247™ PowerTrench® QFET™ QS™ QT Optoelectronics™ Quiet Series™ RapidConfigure™ RapidConnect™ SILENT SWITCHER® SMART START™ SPM™ Stealth™ SuperSOT™-3 SuperSOT™-6 SuperSOT™-8 SyncFET™ TinyLogic™ TruTranslation™ UHC™ UltraFET® VCX™ DISCLAIMER FAIRCHILD SEMICONDUCTOR RESERVES THE RIGHT TO MAKE CHANGES WITHOUT FURTHER NOTICE TO ANY PRODUCTS HEREIN TO IMPROVE RELIABILITY, FUNCTION OR DESIGN. FAIRCHILD DOES NOT ASSUME ANY LIABILITY ARISING OUT OF THE APPLICATION OR USE OF ANY PRODUCT OR CIRCUIT DESCRIBED HEREIN; NEITHER DOES IT CONVEY ANY LICENSE UNDER ITS PATENT RIGHTS, NOR THE RIGHTS OF OTHERS. LIFE SUPPORT POLICY FAIRCHILD’S PRODUCTS ARE NOT AUTHORIZED FOR USE AS CRITICAL COMPONENTS IN LIFE SUPPORT DEVICES OR SYSTEMS WITHOUT THE EXPRESS WRITTEN APPROVAL OF FAIRCHILD SEMICONDUCTOR CORPORATION. As used herein: 1. Life support devices or systems are devices or systems which, (a) are intended for surgical implant into the body, or (b) support or sustain life, or (c) whose failure to perform when properly used in accordance with instructions for use provided in the labeling, can be reasonably expected to result in significant injury to the user. 2. A critical component is any component of a life support device or system whose failure to perform can be reasonably expected to cause the failure of the life support device or system, or to affect its safety or effectiveness. PRODUCT STATUS DEFINITIONS Definition of Terms Datasheet Identification Product Status Definition Advance Information Formative or In Design This datasheet contains the design specifications for product development. Specifications may change in any manner without notice. Preliminary First Production This datasheet contains preliminary data, and supplementary data will be published at a later date. Fairchild Semiconductor reserves the right to make changes at any time without notice in order to improve design. No Identification Needed Full Production This datasheet contains final specifications. Fairchild Semiconductor reserves the right to make changes at any time without notice in order to improve design. Obsolete Not In Production This datasheet contains specifications on a product that has been discontinued by Fairchild semiconductor. The datasheet is printed for reference information only. ©2002 Fairchild Semiconductor Corporation Rev. I1