FMS6413CSX

www.fairchildsemi.com FMS6413 Single Channel Video Driver with Integrated Filter and Clamp Video Features General Description • Integrated Video Low Pass reconstruction filter • Integrated output driver provides a low impedance output and delivers 2Vp-p (6dB gain) composite video into 150Ω. • 7.1MHz 4th order video filter • 0.4% differential gain with 0.4° differential phase • Integrated DC Restore / Clamp Circuitry The FMS6413 Single Channel Video Filter – Driver Chip offers comprehensive video filtering for set top box or DVD applications. This part consists of a 4th order video Low Pass filter for video filtering. This device integrates a video driver so that it can directly drive to the outside world. There is also an integrated clamp circuit that allows the part to DC restore. Applications The video output is filtered at 7.1MHz and buffered to drive 2Vp-p into an AC coupled 150Ω load with up to 35pF of load capacitance at the output pin. The filter approximates a 4th-order Butterworth characteristic with an optimization toward low overshoot and flat group delay. Likewise, the driver is capable of driving a 75Ω load at 1Vp-p. There is an option for the video output to be DC coupled which limits the drive to 1 output. • • • • • • • CCTV DVD players Televisions HDTV Personal Video Recorders (PVRs) Video On Demand (VOD) Cable and Satellite Set top boxes Block Diagram SYNC STRIP, REFERENCE, AND TIMING x2 VIDEO_IN VIDEO_OUT gM 1V REV. 1.0.2 6/27/02 FMS6413 Pin Configuration FMS6413 8-Pin SOIC (S08) 1 2 3 4 VIDEO_IN VIDEO_OUT NC VCC_VIDEO GND_VIDEO NC NC NC 8 7 6 5 Pin Description Video Section Pin# Pin Type Description 1 VIDEO_IN Input Video Input 8 VIDEO_OUT Output Video Output: This pin is the filtered video output Power/Ground Pins 2 Pin# Pin Type Description 7 VCC_VIDEO Power +5 VDC for Video 3 GND_VIDEO Power Ground for Video 4 NC NC Reserved (Need to Float) 5 NC NC Reserved (Need to Float) 6 NC NC Reserved (Need to Float) 2 NC NC Reserved (Need to Float) REV. 1.0.2 6/27/02 FMS6413 Functional Description Introduction The FMS6413 is a monolithic continuous time video filter driver designed for reconstructing the video signals from a D/A source. This chip is intended for use in applications with AC coupled input and AC coupled outputs. (See Figure 1) The reconstruction filter approximates a 4th-order Butterworth characteristic with an optimization toward low over-shoot and flat group delay. The video output is capable of driving 2VP-P into an AC coupled 150Ω video load, with up to 35pF of load capacitance at the output pin. The channel is clamped during sync to establish the appropriate output voltage swing range. Thus the input coupling capacitor does not behave according to the conventional RC time constant. Clamping for the video channel settles to less than 10mv within 5ms of a change in video input source. In most applications the input coupling capacitor is 0.1µF. The input typically sinks 1µA during active video, which nominally tilts a horizontal line by about 2mV at the Video output. During sync, the clamp typically sources 20µA to restore the DC level. The net result is that the average input current is zero. Any change in the input coupling capacitor’s value will inversely alter the amount of tilt per line. Such a change will also linearly affect the clamp response time. This product is robust and stable under all stated load and input conditions. Capacitive bypassing VCC directly to ground ensures this performance. Video I/O The video input is driven by either a low impedance source of 1VP-P or the output of a 75Ω terminated line. The input is required to be AC coupled via a 0.1µF coupling capacitor which allows for a settling time of 5ms. The video output is capable of driving an AC coupled 150Ω load at 2VP-P, or 1VP-P into a 75Ω load. Up to 35pF of load capacitance (at the output pin) can be driven without stability or slew issues. The output is AC coupled with a 220µF or larger AC coupling capacitor. Typical Applications Diagram VIDEO_IN 1 VIDEO_IN SYNC STRIP, REF, AND TIMING 220µF x2 VIDEO_OUT 8 75Ω VIDEO_OUT Video Cable 0.1µF 75Ω gM 1V 2 NC (Reserved) VCC_VIDEO 0.1µF FMS6413 3 4 +5.0V 7 GND_VIDEO NC (Reserved) NC (Reserved) NC (Reserved) 1µF 6 5 Figure 1. REV. 1.0.2 6/27/02 3 FMS6413 Absolute Maximum Ratings (beyond which the device may be damaged) Parameter Min VCC_VIDEO (Positive DC Supply Voltage) Max Units +6.5 V GND_VIDEO (Negative DC Supply Voltage) Analog and Digital I/O V GND-0.3 VCC+0.3 V Output Current (Continuous) 60 mA Junction Temperature 150 °C Storage Temperature Range +150 °C Lead Temperature (Soldering, 10s) -65 260 °C Thermal Resistance (ΘJA) 115 °C/W Note: Functional operation under any of these conditions is NOT implied. Performance and reliability are guaranteed only if Operating Conditions are not exceeded. Operating Conditions Parameter 4 Min Temperature Range 0 VCC_VIDEO Range 4.75 Typ 5.0 Max Units 70 °C 5.25 V GND_VIDEO 0 V ICC (+5 VDC) 60 mA REV. 1.0.2 6/27/02 FMS6413 Electrical Characteristics 1Vp-p signal at room temperature Video Characteristics - Unless otherwise noted, typical output loading on video output is 150Ω. Condition VCC_VIDEO=+5.0V ±5% Symbol Parameter AV Low Frequency Gain (VIDEO_OUT) at 400KHz 6.0 dB VIDEO_OUT Output Level (During Sync) Sync Present on YIN 1.0 V tCLAMP Clamp Response Time Settled to Within 10mV,0.1µF cap on VIDEO_IN 5 ms f1dB –1.0dB Bandwidth (Flatness) (VIDEO_OUT) No Peaking Cap (Note 1) 4.0 4.5 MHz fC –3dB Bandwidth (Flatness) (VIDEO_OUT) 6.7 7.1 MHz fSB Stopband Rejection (VIDEO_OUT) fIN = 27MHz to 100MHz worst case -37 -42 dB Vi Input Signal Dynamic Range AC Coupled 1.3 1.4 ISC Output Short Circuit Current (All Channels) VIDEO_OUT to GND 40 CL Output Shunt Capacitance VIDEO_OUT 35 pF dG Differential Gain VIDEO_OUT 0.4 % dP Differential Phase VIDEO_OUT 0.4 ° THD Output Distortion (All Channels) VIDEO_OUT = 1.8VP-P at 3.58/ 4.43MHz 0.8 % PSRR PSRR (All Channels) 0.5VP-P (100kHz) at VCC -40 dB NTC-7 weighting 4.2 MHz lowpass -75 dB 70 ns SNR Min Typ Max Units VP-P 80 mA tpd Group Delay 100kHz ∆tpd Group Delay Deviation from Flatness to 3.58MHz (NTSC) 9 ns to 4.43MHz (PAL) 7 ns Notes: 1. Peaking capacitor increases video output at 4.2MHz nominally by 0.7dB 2. Sustained short circuit protection limited to 10 seconds REV. 1.0.2 6/27/02 5 FMS6413 Mechanical Dimensions Inches (millimeters) Package: S08 8-Pin SOIC 0.189 - 0.199 (4.80 - 5.06) 8 0.148 - 0.158 0.228 - 0.244 (3.76 - 4.01) (5.79 - 6.20) PIN 1 ID 1 0.017 - 0.027 (0.43 - 0.69) (4 PLACES) 0.050 BSC (1.27 BSC) 0.059 - 0.069 (1.49 - 1.75) 0° - 8° 0.055 - 0.061 (1.40 - 1.55) 0.012 - 0.020 (0.30 - 0.51) 0.004 - 0.010 (0.10 - 0.26) 0.015 - 0.035 (0.38 - 0.89) 0.006 - 0.010 (0.15 - 0.26) SEATING PLANE 6 REV. 1.0.2 6/27/02 FMS6413 Ordering Information Part Number Temperature Range Package FMS6413CS 0° to 70° 8 Pin SOIC (S08) FMS6413CSX 0° to 70° Tape and Reel DISCLAIMER FAIRCHILD SEMICONDUCTOR RESERVES THE RIGHT TO MAKE CHANGES WITHOUT FURTHER NOTICE TO ANY PRODUCTS HEREIN TO IMPROVE RELIABILITY, FUNCTION OR DESIGN. FAIRCHILD DOES NOT ASSUME ANY LIABILITY ARISING OUT OF THE APPLICATION OR USE OF ANY PRODUCT OR CIRCUIT DESCRIBED HEREIN; NEITHER DOES IT CONVEY ANY LICENSE UNDER ITS PATENT RIGHTS, NOR THE RIGHTS OF OTHERS. LIFE SUPPORT POLICY FAIRCHILD’S PRODUCTS ARE NOT AUTHORIZED FOR USE AS CRITICAL COMPONENTS IN LIFE SUPPORT DEVICES OR SYSTEMS WITHOUT THE EXPRESS WRITTEN APPROVAL OF THE PRESIDENT OF FAIRCHILD SEMICONDUCTOR CORPORATION. As used herein: 1. Life support devices or systems are devices or systems which, (a) are intended for surgical implant into the body, or (b) support or sustain life, and (c) whose failure to perform when properly used in accordance with instructions for use provided in the labeling, can be reasonably expected to result in a significant injury of the user. 2. A critical component in any component of a life support device or system whose failure to perform can be reasonably expected to cause the failure of the life support device or system, or to affect its safety or effectiveness. www.fairchildsemi.com 6/27/02 0.0m 004 Stock#DS30006413  2002 Fairchild Semiconductor Corporation