FPF2004

IntelliMAXt Advanced Load Management Products FPF2000 - FPF2007 General Description The FPF2000 through FPF2007 is a family of load switches which provide full protection to systems and loads which may encounter large current conditions. These devices contain a 0.7 W current−limited P−channel MOSFET which can operate over an input voltage range of 1.8 − 5.5 V. Switch control is by a logic input (ON) capable of interfacing directly with low voltage control signals. Each part contains thermal shutdown protection which shuts off the switch to prevent damage to the part when a continuous over−current condition causes excessive heating. When the switch current reaches the current limit, the part operates in a constant current mode to prohibit excessive currents from causing damage. For the FPF2000 − FPF2002 and FPF2004 − FPF2006, if the constant current condition still persists after 10ms, these parts will shut off the switch and pull the fault signal pin (FLAGB) low. The FPF2000, FPF2001, FPF2004 and FPF2005, have an auto−restart feature which will turn the switch on again after 80 ms if the ON pin is still active. The FPF2002 and FPF2006 do not have this auto−restart feature so the switch will remain off until the ON pin is cycled. For the FPF2003 and FPF2007, a current limit condition will immediately pull the fault signal pin low and the part will remain in the constant−current mode until the switch current falls below the current limit. For the FPF2000 through FPF2003, the minimum current limit is 50 mA while that for the FPF2004 through FPF2007 is 100 mA. These parts are available in a space−saving 5 pin SC−70 package. Features • • • • • • • • • • July, 2021 − Rev. 8 SC−88A (SC−70 5 Lead), 1.25x2 CASE 419AC−01 MARKING DIAGRAM &Y &O20x&C &O&V 20x &Y &O &C &V = Device Code (x = 0, 1, 2, 3, 4, 5, 6, 7) = Binary Calendar Year Coding Scheme = Plant Code Identifier on Tiny Logic Package = Single Digit Die Run Code = Eight−Week Binary Datacoding Scheme ORDERING INFORMATION See detailed ordering and shipping information on page 2 of this data sheet. 1.8 to 5.5 V Input Voltage Range Controlled Turn−On 50 mA and 100 mA Current Limit Options Undervoltage Lockout Thermal Shutdown