FPN630A

FPN630 / FPN630A FPN630 FPN630A C TO-226 B E PNP Low Saturation Transistor These devices are designed for high current gain and low saturation voltage with collector currents up to 3.0 A continuous. Sourced from Process PC. Absolute Maximum Ratings* Symbol TA = 25°C unless otherwise noted Parameter Value Units VCEO Collector-Emitter Voltage 30 V VCBO Collector-Base Voltage 35 V VEBO Emitter-Base Voltage IC Collector Current TJ, Tstg Operating and Storage Junction Temperature Range 5.0 V 3.0 A -55 to +150 °C - Continuous *These ratings are limiting values above which the serviceability of any semiconductor device may be impaired. NOTES: 1) These ratings are based on a maximum junction temperature of 150 degrees C. 2) These are steady state limits. The factory should be consulted on applications involving pulsed or low duty cycle operations. 3) All voltages (V) and currents (A) are negative polarity for PNP transistors. Thermal Characteristics Symbol TA = 25°C unless otherwise noted Characteristic Max Units FPN630 / FPN630A 1.0 W Thermal Resistance, Junction to Case 50 °C/W Thermal Resistance, Junction to Ambient 125 °C/W PD Total Device Dissipation RθJC RθJA  1999 Fairchild Semiconductor Corporation (continued) Electrical Characteristics Symbol TA = 25°C unless otherwise noted Parameter Test Conditions Min Max Units OFF CHARACTERISTICS BVCEO IC = 10 mA, IB = 0 BVCBO Collector-Emitter Breakdown Voltage Collector-Base Breakdown Voltage 30 V BVEBO Emitter-Base Breakdown Voltage IC = 100 µA, IE = 0 35 V IE = 100 µA, IC = 0 VCB = 30 V, IE = 0 VCB = 30 V, IE = 0, TA = 100°C VEB = 4.0 V, IC = 0 5.0 ICBO Collector Cutoff Current IEBO Emitter Cutoff Current V 100 10 100 nA µA nA mV mV mV V V ON CHARACTERISTICS* hFE DC Current Gain IC = 100 mA, VCE = 2.0 V VCE(sat) Collector-Emitter Saturation Voltage IC = 1.0 A, VCE = 2.0 V IC = 2.0 A, VCE = 2.0 V IC = 1.0 A, IB = 100 mA VBE(sat) Base-Emitter Saturation Voltage IC = 2.0 A, IB = 200 mA IC = 1.0 A, IB = 100 mA 300 250 500 1.25 VBE(on) Base-Emitter Saturation Voltage IC = 1.0 A, VCE = 2.0 V 1.0 630 630A 100 250 60 40 630 630A SMALL SIGNAL CHARACTERISTICS Cobo Output Capacitance VCB = 10 V, IE = 0, f = 1.0 MHz FT Transition Frequency IC = 100 mA, VCE = 5.0 V, f = 100 MHz *Pulse Test: Pulse Width ≤ 300 µs, Duty Cycle ≤ 2.0% NOTE: All voltages (V) and currents (A) are negative polarity for PNP transistors. 100 100 pF MHz FPN630 / FPN630A PNP Low Saturation Transistor (continued) 1.6 β = 10 1.4 1.2 1 - 40 °C 0.8 0.6 25 °C 125 °C 0.4 0.2 0.001 0.01 0.1 1 I C - COLLECTOR CURRENT (A) 10 VBEON- BASE-EMITTER ON VOLTAGE (V) Base-Emitter Saturation Voltage vs Collector Current Base-Emitter On Voltage vs Collector Current 1.6 Vce = 2.0V 1.4 1.2 1 - 40 °C 0.8 0.6 0.4 125 °C 0.2 0.0001 Collector-Emitter Saturation Voltage vs Collector Current 1 0.001 0.01 0.1 1 I C - COLLECTOR CURRENT (A) 10 500 β = 10 f = 1.0MHz 450 0.8 0.6 125°C 25°C 0.4 - 40°C 0.2 400 C ibo 350 300 250 200 C obo 150 100 50 0 0.01 0.1 1 I C - COLLECTOR CURRENT (A) 0 0.1 10 0.5 1 10 20 V CE - COLLECTOR VOLTAGE (V) Current Gain vs Collector Current Vce = 2.0V PD - POWER DIS SIPATION (W) 500 400 125°C 300 200 100 0 0.0001 25°C - 40°C 0.001 0.01 0.1 1 I C - COLLECTOR CURRENT (A) 50 100 Power Dissipation vs Ambient Temperature 600 H FE - CURRENT GAIN 25 °C Input/Output Capacitance vs Reverse Bias Voltage CAPACITANCE (pf) VCESAT - COLLECTOR-EMITTER VOLTAGE (V) VBESAT -BASE-EMITTER SATURATION VOLTAGE(V) Typical Characteristics 10 1 TO-226 0.75 0.5 0.25 0 0 25 50 75 100 TEMPERATURE ( °C) 125 150 FPN630 / FPN630A PNP Low Saturation Transistor TRADEMARKS The following are registered and unregistered trademarks Fairchild Semiconductor owns or is authorized to use and is not intended to be an exhaustive list of all such trademarks. ACEx™ Bottomless™ CoolFET™ CROSSVOLT™ DOME™ E2CMOSTM EnSignaTM FACT™ FACT Quiet Series™ FAST  FASTr™ GlobalOptoisolator™ GTO™ HiSeC™ ISOPLANAR™ MICROWIRE™ OPTOLOGIC™ OPTOPLANAR™ PACMAN™ POP™ PowerTrench  QFET™ QS™ QT Optoelectronics™ Quiet Series™ SILENT SWITCHER  SMART START™ SuperSOT™-3 SuperSOT™-6 SuperSOT™-8 SyncFET™ TinyLogic™ UHC™ VCX™ DISCLAIMER FAIRCHILD SEMICONDUCTOR RESERVES THE RIGHT TO MAKE CHANGES WITHOUT FURTHER NOTICE TO ANY PRODUCTS HEREIN TO IMPROVE RELIABILITY, FUNCTION OR DESIGN. FAIRCHILD DOES NOT ASSUME ANY LIABILITY ARISING OUT OF THE APPLICATION OR USE OF ANY PRODUCT OR CIRCUIT DESCRIBED HEREIN; NEITHER DOES IT CONVEY ANY LICENSE UNDER ITS PATENT RIGHTS, NOR THE RIGHTS OF OTHERS. LIFE SUPPORT POLICY FAIRCHILD’S PRODUCTS ARE NOT AUTHORIZED FOR USE AS CRITICAL COMPONENTS IN LIFE SUPPORT DEVICES OR SYSTEMS WITHOUT THE EXPRESS WRITTEN APPROVAL OF FAIRCHILD SEMICONDUCTOR CORPORATION. As used herein: 1. Life support devices or systems are devices or 2. A critical component is any component of a life support device or system whose failure to perform can systems which, (a) are intended for surgical implant into be reasonably expected to cause the failure of the life the body, or (b) support or sustain life, or (c) whose support device or system, or to affect its safety or failure to perform when properly used in accordance with instructions for use provided in the labeling, can be effectiveness. reasonably expected to result in significant injury to the user. PRODUCT STATUS DEFINITIONS Definition of Terms Datasheet Identification Product Status Definition Advance Information Formative or In Design This datasheet contains the design specifications for product development. Specifications may change in any manner without notice. Preliminary First Production This datasheet contains preliminary data, and supplementary data will be published at a later date. Fairchild Semiconductor reserves the right to make changes at any time without notice in order to improve design. No Identification Needed Full Production This datasheet contains final specifications. Fairchild Semiconductor reserves the right to make changes at any time without notice in order to improve design. Obsolete Not In Production This datasheet contains specifications on a product that has been discontinued by Fairchild semiconductor. The datasheet is printed for reference information only. Rev. G