OVFSQ4C8

4-Pin Red-Orange LED Lamp (7.6mm) OVFSQ4C8 x x x x x Packaged in tubes Compatible with automatic placement equipment Compatible with infrared and vapor phase reflow solder process Mono-color type Pb-free Product Photo Here The OVFSQ4C8 is designed with higher forward voltage to maximize brightness and incorporates a low-profile lens to enhance efficient light distribution. Response time is fast and it consumes less power resulting in low current requirements from circuit power supply. Tubular arrays replace neon in outdoor and indoor signs. This square package allows high-density arrays to form light engines. Applications x Automotive: Rear Stop/Turn Signal Lamps/Truck Marker Lamps x Mood-setting Decoration and Landscape Lighting x Special Decorative Interior/Exterior Lighting x Special Effects Stage Lighting x Illumination for Signs and Channel Letters x Traffic Signals, Pedestrian and Walkway Signs Part Number OVFSQ4C8 Material AlInGaP Emitted Color Red-Orange Flux Typ. mlm 4500 Lens Color W ater Clear RoHS 2,3 ANODE 1,4 CATHODE Data is subject to change without prior notice. OPTEK Technology Inc. — 1645 Wallace Drive, Carrollton, Texas 75006 Phone: (972) 323-2200 or (800) 341-4747 FAX: (972) 323-2396 visibleLED@optekinc.com www.optekinc.com Issue 1.0 0505 Page 1 4-Pin Red-Orange LED Lamp (7.6mm) OVFSQ4C8 Absolute Maximum Ratings TA = 25o C unless otherwise noted Storage Temperature Range Operating Temperature Range Lead Soldering Temperature (3mm from the base of the epoxy bulb)1 Reverse Voltage Continuous Forward Current Power Dissipation 2 -40 ~ +100° C -40 ~ +100° C 260° C 5V 70 mA 200 mA 220 mW Peak Forward Current (10% Duty Cycle, PW ”  —VHF Notes: 1. Solder time less than 5 seconds at temperature extreme. 2. Heat sink is adequate if the device is operated at ambient temperature higher than 25° For long term performance the drive currents C. between 10mA and 50mA are recommended. Please contact an Optek sales representative for more information on recommended drive conditions. TA = 25o C unless otherwise noted SYMBOL lumen VF IR D Electrical Characteristics PARAMETER Luminous Flux Forward Voltage Reverse Current Dominant Wavelength 50% Power Angle MIN 3000 ------612 ---TYP 4500 2.6 ---618 40 MAX ---3.2 100 628 ---UNITS mlm V µA nm deg CONDITIONS IF = 70mA IF = 70mA VR = 5V IF = 70mA IF = 70mA 2 ½ Lamps are sorted to luminous flux ( V), forward voltage (VF), and dominant wavelength ( D) bins shown. Orders for OVFSQ4C8 may be filled with any or all bins contained as below. Luminous Flux mlm) 5000-7300 4000-6100 3500-4800 3000-4200 612 M L K J Luminous flux is at J bin or above. Standard Bins (IF = 70mA) Dominant Wavelength (nm) 628 Forward Voltage (VF) Rank Voltage (V) V4 2.2–2.4 V5 2.4–2.6 V6 2.6–2.8 V7 2.8–3.0 V8 3.0–3.2 Important Notes: 1. All ranks will be included per delivery, rank ratio will be based on the chip distribution. 2. To designate luminous intensity ranks, please contact OPTEK. Issue 1.0 Page 2 0505 OPTEK Technology Inc. — 1645 Wallace Drive, Carrollton, Texas 75006 Phone: (972) 323-2200 or (800) 341-4747 FAX: (972) 323-2396 visibleLED@optekinc.com www.optekinc.com 4-Pin Red-Orange LED Lamp (7.6mm) OVFSQ4C8 Typical Electro-Optical Characteristics Curves mA % Forward Current vs. Forward Voltage V Relative Luminous Flux vs. Forward Current mA Half Power W L = 23nm mA nm ° C Relative Luminous Flux vs. Wavelength Maximum Forward DC Current vs. Ambient Temperature 50% Power Angle: 40° V A Far Field Pattern Reverse Current vs. Reverse Voltage OPTEK Technology Inc. — 1645 Wallace Drive, Carrollton, Texas 75006 Phone: (972) 323-2200 or (800) 341-4747 FAX: (972) 323-2396 visibleLED@optekinc.com www.optekinc.com Issue 1.0 0505 Page 3 4-Pin Red-Orange LED Lamp (7.6mm) OVFSQ4C8 Moisture Resistant Packaging 60/Tube Aluminum Moisture-proof Bag Desiccant Bar Code Label Issue 1.0 Page 4 0505 OPTEK Technology Inc. — 1645 Wallace Drive, Carrollton, Texas 75006 Phone: (972) 323-2200 or (800) 341-4747 FAX: (972) 323-2396 visibleLED@optekinc.com www.optekinc.com 4-Pin Red-Orange LED Lamp (7.6mm) OVFSQ4C8 Issue Change Description Approval Date 1.0 Initial Release R. Bailey 5/19/05 OPTEK Technology Inc. — 1645 Wallace Drive, Carrollton, Texas 75006 Phone: (972) 323-2200 or (800) 341-4747 FAX: (972) 323-2396 visibleLED@optekinc.com www.optekinc.com Issue 1.0 0505 Page 5