OVLFG3C7

Round Green Through-hole LED Lamp (5 mm) OVLFG3C7 x x x High brightness with well-defined spatial radiation patterns UV-resistant epoxy lens Green (525 nm) Product Photo Here The OVLFG3C7 is a high-intensity InGaN LED mounted in a clear plastic T-1¾ package. Its UV-resistant epoxy lens makes this device an optimal solution for outdoor applications. This LED provides a well-defined and even emission pattern. Applications x Traffic and pedestrian signals x Signage and architectural lighting x Backlighting x Automotive Part Number OVLFG3C7 Material InGaN Emitted Color Green Intensity Typ. (mcd) 5200 Lens Color Water Clear RoHS Moisture DO NOT LOOK DIRECTLY AT LED WITH UNSHIELDED EYES OR DAMAGE TO RETINA MAY OCCUR. OPTEK reserves the right to make changes at any time in order to improve design and to supply the best product possible. OPTEK Technology Inc. — 1645 Wallace Drive, Carrollton, Texas 75006 Phone: (972) 323-2200 or (800) 341-4747 FAX: (972) 323-2396 sensors@optekinc.com www.optekinc.com Issue A 10/05 Page 1 of 4 Round Green Through-hole LED (5 mm) OVLFG3C7 Absolute Maximum Ratings TA = 25oC unless otherwise noted Storage Temperature Range Operating Temperature Range Reverse Voltage Continuous Forward Current Power Dissipation Lead Soldering Temperature (3mm from the base of the epoxy bulb)1 Current Linearity vs. Ambient Temperature LED Junction Temperature Notes: 1. Solder time less than 5 seconds at temperature extreme. 2. Design of heat dissipation should be considered. 2 -40 ~ +100° C -40 ~ +85° C 5V 20 mA 50 mA 100 mW 260° C -0.2 mA/° C 125° C Peak Forward Current (10% Duty Cycle, 1KHz) Electrical Characteristics TA = 25oC unless otherwise noted SYMBOL Iv VF IR P D PARAMETER Luminous Intensity Forward Voltage Reverse Current Peak Wavelength Dominant Wavelength Spectra Half Width MIN 3115 2.6 ---------------- TYP 5200 3.4 ---521 525 25 30 MAX ---4.0 50 ------------- UNITS CONDITIONS IF = 20 mA IF = 20 mA VR = 5 V IF = 20 mA IF = 20 mA mcd V µA nm nm 2½ 50% Power Angle deg IF = 20 mA Standard Bins (IF = 20mA) Luminous Intensity (mcd) Lamps are sorted to luminous intensity (IV) and dominant wavelength ( D) bins shown. Orders for OVLFG3C7 may be filled with any or all bins contained as below. 6105–8550 4360–6105 3115–4360 X W V Luminous intensity is at V bin or above. Dominant Wavelength (525 nm) Notes: 1. All ranks will be included per delivery, rank ratio will be based on the chip distribution. 2. To designate luminous intensity ranks, please contact OPTEK. 3. Pb content