OTS-1V1DTR

Optiva Standard, 1 Composite Video and 1 Duplex RS-232/422/485 Data ™ OTS-1V1DTR Composite Video and Data The OTS-1V1DTR provides for the digital transmission of 1 Channel of Composite Video and 1 Channel of Duplex Serial Data. Video System Design All units come in an insert card version. The cards can be inserted into our 16-slot, 19” rack-mountable card cage (OT-CC-16-100) or one of our smaller Optiva™ Desktop Card Racks (OT-DTCR Series). The Optiva™ Desktop Card Racks can handle one, two or four insert cards, creating compact, mountable, stand alone systems. The use of separate OT-DTCR enclosures allows for future flexibility and expansion as all cards are hot-swappable and can be used in any enclosure. Each one of our card housing units operate with an appropriate power supply. See “Accessories” for power supply specifications. Optiva™ Upgrade Path This system can be purchased without an optical port as an add-on to an existing Optiva™ system daisy-chain. (See “Non-Optical Version” below). The Optiva™ bandwidth requirement of this system is 360 Mbps. 1 Serial Data In/Out S T A T U S A L E R T S T A T U S A L E R T 1 Serial Data Out/In Each insert card comes with a label identifying the specific protocols handled, connector pin-out and other vital information. For optimal bandwidth allocation, each insert card can daisy-chain with an additional card in the same chassis. See “Optiva™ Upgrade Path”. Audio Composite Video In ST, LC, SC or FC Composite Video Out ST, LC, SC or FC ™ Optiv a ™ Optiv a Data VAD Transmission VAD Transmission OTS-1VT1DTR OTS-1VR1DRT Features • Composite Video and Serial Data over one fiber • 10-Bit Digital Transmission • TDM - Single fiber, dual wavelength • Complies with SMPTE standards for Video transmission • Compatible with MDM-7000 Series for WDM and CWDM multiplexing • No EMI or RFI and no ground loops • Stand alone or rack-mount • Ideal for Camera PTZ applications Versions Available* Wavelength (nm) & Fiber 1310/1550 Multimode 1310/1550 Singlemode 1310/1550 SM (D) 1310/1550 SM (H) 1270-1610 SM (CWDM) Non-Optical Version Transmit/Receive** OTS-1VTDTR-A1/A3M-XX-IC OTS-1VTDTR-A2/A3-XX-IC OTS-1VTDTR-A2/A3D-XX-IC OTS-1VTDTR-A2/A3H-XX-IC OTS-1VTDTR-L4/L4-XX-IC OTS-1VTDTR-NOC-IC Receive/Transmit** OTS-1VRDRT-A3M/A1-XX-IC OTS-1VRDRT-A3/A2-XX-IC OTS-1VRDRT-A3D/A2-XX-IC OTS-1VRDRT-A3H/A2-XX-IC OTS-1VRDRT-L4/L4-XX-IC OTS-1VRDRT-NOC-IC Optical Connector ST, FC, LC or SC ST, FC, LC or SC ST, FC, LC or SC ST, FC, LC or SC ST, FC, LC or SC N/A Optical Budget (dB) 10 12 17 25 Varies N/A Range*** (km) Form Factor 3 20 40 60 20-70 N/A IC (1-slot) IC (1-slot) IC (1-slot) IC (1-slot) IC (1-slot) IC (1-slot) Serial Data Codes - "D" indicates RS-232. For other Serial Data preferences, please use: "DJ" = RS-422; "DK" = RS-485 (2W); and "DW" = RS-485 (4W). * Contact Opticomm for other versions available. ** XX indicates the type of optical connector. Each of ST, FC, LC or SC are available. *** Chromatic dispersion and additional losses should be taken into account. 800-867-8426 • info@opticomm.com • www.opticomm.com • Contact Opticomm for custom requirements. Opticomm reserves the right to change specifications without notice Composite Video, Audio & Data Video Standard Bit Resolution Level Bandwidth Differential Gain Differential Phase Compatibility Signal to Noise Ratio Connector Data Connector RS-232, RS-422 Data Rate RS-485 (2 Wire) Data Rate RS-485 (4 Wire) Data Rate Contact Closure General Dimensions & Weight Operating temperature Storage temperature Humidity Operating voltage Consumption System Latency Local Monitoring Remote Monitoring SMPTE 170M; RS-250C 10-Bit Processing; 10-Bit Transmission 1.0 Volt p-p 5.5 MHz < 1% < 0.7° NTSC, PAL > 67 dB BNC (IEC 60169-8) Optiva™ Multi-Signal Optiva™ Configurable Transmission Platform Communication Platform Network Management Network Management SDI and HD-SDI SDI & HD-SDI Composite Video, Composite Video, Audio & Data Audio & Data Audio/FSK/Intercom RGB/VGA/DVI RGB/VGA/DVI Audio/FSK/Intercom Data (Ethernet/Serial/USB) Data (Ethernet/Serial/USB) Micro DB25 DC to 1 Mbps DC to 1 Mbps DC to 1 Mbps CATV/RF & L-Band CATV/RF & L-Band Optical Switching, Routing Optical Switching, Routing & Redundancy & Redundancy Passive Multiplexing Passive Multiplexing Solutions Solutions Enclosures, Racks Enclosures, Racks & Frames & Frames 11 oz Power Supplies Power Supplies and Accessories & Accessories Insert Card (IC): 6.3” L x 0.8” W x 4.0” H -20° C to +55° C -40° C to +85° C 0 to 95% non-condensing 9-12 VDC 1 Amp Max per Insert Card Less than 1ms LED Status Indication Compatible with OptivaView™ SNMP Management Suite MADE IN THE USA Sample Configuration