OSXXX2E5D1E

Xeon 5 Power White LED OSXXX2E5D1E VER C.0 ■ Features ● ● ● ● ● Anode(+) 3.6 Highest Luminous Flux Super Energy Efficiency Long Lifetime Operation Superior ESD protection Superior UV Resistance 5.5 1.15 2.0 Cathode(-) BackView Anode 5.5 0.1 ■ Applications ● ● ● ● ● ● Read lights (car, bus, aircraft) Portable (flashlight, bicycle) Bollards / Security / Garden Traffic signaling / Beacons In door / Out door Commercial lights Automotive Ext 14.5 3.0 Cathode ■ Absolute Maximum Rating Item Symbol IF IFP VR PD Topr Tstg Tsol (Ta=25℃) Value White/ Warm white 1600 2000 10 6400 -30 ~ +85 -40~ +100 260℃/5sec ■Directivity Unit mA mA V mW ℃ ℃ ℃ 0.2 Unit:mm Tolerance:±0.30mm 1.05 0 DC Forward Current Pulse Forward Current* Reverse Voltage Power Dissipation Operating Temperature Storage Temperature Lead Soldering Temperature *Pulse width Max.10ms ■ Electrical 0 Duty ratio max 1/10 -Optical Characteristics Color (Ta=25℃) VF (V) IR(µA) Typ. Max. Max. VR=10V 8.0 8.0 Part Number Per Segment or (Dp) CCT (K) Typ Luminous Flux λD(nm) 2θ1/2 (deg) Φv (lm) Min Typ. Max. Min. Typ. Max. IF=1400mA X=0.31 ,Y=0.33 X=0.45,Y=0.41 Min. IF=1400mA OSW4X2E5D1E OSM5X2E5D1E Pure White W4 Warm White M5 6.5 6.5 7.0 7.0 10 10 6500 3000 300 320 280 300 - - 125 Note: Don’t drive at rated current more than 5s without heat sink for Xeon 3 emitter series. LED & Application Technologies http://www.optosupply.com VER A.0 Xeon 5 Power White LED OSXXX2E5D1E VER C.0 ■ Handling of Silicone Lens LEDs Notes for handling of silicone lens LEDs ● Please do not use a force of over 3kgf impact or pressure on the silicone lens, otherwise it will cause a catastrophic failure. ● The LEDs should only be picked up by making contact with the sides of the LED body. ● Avoid touching the silicone lens especially by sharp tools such as Tweezers. ● Avoid leaving fingerprints on the silicone lens. ● Please store the LEDs away from dusty areas or seal the product against dust. ● When populating boards in SMT production, there are basically no restrictions regarding the form of the pick and place nozzle, except that mechanical pressure on the silicone lens must be prevented. ● Please do not mold over the silicone lens with another resin. (epoxy, urethane, etc) LED & Application Technologies http://www.optosupply.com VER A.0