TRSL-93120FG

Optoway TRSL-93120FG 3.3V / 1550 nm / 2.125 Gbps SFF LC SINGLE-MODE TRANSCEIVER FEATURES DESCRIPTION TRSL-93120FG 1 *********************************************************************************************************************************************************************** ********************************************************************************************************************************************************************** l D uplex LC Single Mode Transceiver l Fibre Channel 2X / 1X SM-LC-L FC-PI Compliant l IEEE 802.3z Gigabit Ethernet 1000BASE-ZX Compliant l Small Form Factor, RJ-45 size, 2X5 pin Package l 1550 nm DFB LD Transmitter l 30 dB Link Power Budget at Least l D istance up to 120 km l AC/AC Coupled Signal Input / Output l LVTTL Transmitter Disable Input l LVTTL Signal Detection Output l Single +3.3 V Power Supply l 0 to 70oC Operation l Wave Solderable and Aqueous Washable l Class 1 Laser International Safety Standard IEC-60825 Compliant The TRSL-93120FG series single mode transceivers is small form factor, low power, high performance module for bi-directional serial optical data communications such as Fibre Channel 2X/1X SM-LC-L FC-PI and IEEE 802.3z Gigabit Ethernet 1000BASE-LX. This module is designed for single mode fiber and operates at a nominal wavelength of 1550 nm. A guaranteed minimum optical link budget of 30 dB is offered which can correspond to a link distance of over 120 km (assuming worst case fiber loss of 0.22 dB/km). The transmitter section uses a multiple quantum well 1550 nm DFB laser and is a class 1 laser compliant according to International Safety Standard IEC-60825. The receiver section uses an integrated InGaAs detector preamplifier (IDP) mounted in an optical header and a limiting post-amplifier IC. A LVPECL logic interface simplifies interface to external circuitry. APPLICATIONS l l l l ATM Switches and Routers SONET / SDH Switch Infrastructure XDSL Applications Metro Edge Switching LASER SAFETY This single mode transceiver is a Class 1 laser product. It complies with IEC-60825 and FDA 21 CFR 1040.10 and 1040.11. The transceiver must be operated within the specified temperature and voltage limits. The optical ports of the module shall be terminated with an optical connector or with a dust plug. ORDER INFORMATION P /No. TRSL-93120FG Bit Rate FC-PI (Gb/s) 2.125/1.063 200/100 Distance (km) 120 Wavelengt h (nm) 1550 DFB Package 2X5 LC Temp. (oC) 0 to 70 TX Power RX Sens. RoHS (dBm) (dBm) Compliant 5 to 0 -30 Yes Absolute Maximum Ratings Parameter Storage Temperature Operating Temperature Soldering Temperature Power Supply Voltage Input Voltage Output Current Symbol Tstg Topr --Vcc --Iout Min -40 0 0 GND 0 Max 85 70 260 4.5 Vcc 30 Units o C o C o C V V mA Notes Air flow 1m/sec 10 seconds on leads only Recommended Operating Conditions Parameter Power Supply Voltage Operating Temperature Data Rate Power Supply Current Symbol Vcc Topr Icc Min 3.13 0 1063 Typ 3.3 2125 200 Max 3.47 70 300 Units / Notes V o C / air flow 1m/sec Mb/s mA *********************************************************************************************************************************************************************** OPTOWAY TECHNOLOGY INC. No.38, Kuang Fu S. Road, Hu Kou, Hsin Chu Industrial Park, Hsin Chu, Taiwan 303 Tel: 886-3-5979798 Fax: 886-3-5979737 E-mail: sales@optoway.com.tw http: // www.optoway.com.tw 1 2/1/2005 V2.0 Optoway Transmitter Specifications (0 oC < Topr < 70 oC, 3.13V < Vcc < 3. 47V) Parameter Optical Optical Transmit Power Output Center Wavelength Output Spectrum Width Side Mode Suppression Ratio Extinction Ratio Optical Modulation Amplitude (Peak-to-Peak) Optical Rise Time Optical Fall Time Relative Intensity Noise Electrical Data Input Current – Low Data Input Current – High Differential Input Voltage Data Input Voltage – Low Data Input Voltage -- High Disable Input Voltage -- Low Disable Input Voltage -- High Shut Off Time for TxDis Symbol Po λ ∆λ SMSR ER OMA tr tf RIN IIL IIH VIH - V IL VIL - V CC VIH - V CC VTDIS,L VTDIS,H tDIS -350 350 300 -2.0 -1.1 0 Vcc – 1 .3 -1.58 -0.74 0 .5 Vcc 1 Min 0 1520 --30 9 174 Typ --1550 --Max 5 1580 1 --Units dBm nm nm dB dB µW ps ps dB/Hz µA µA mV V V V V ms TRSL-93120FG Notes 1 -20 dB Width 2 *********************************************************************************************************************************************************************** FC-PI Standard 20% to 80% Values 20% to 80% Values 160 160 -120 2 2 TX Output Enabled TX Ouput Disabled Notes: 1. Output power is power coupled into a 9/125 µm single mode fiber. 2. These inputs are compatible with 10K, 10KH and 100K ECL and PECL inputs. Receiver Specifications (0oC < Topr < 70oC, 3.13V < Vcc < 3.47V) Parameter Optical Sensitivity @ 2.125 Gbps Sensitivity @ 1.063 Gbps Maximum Input Power Signal Detect -- Asserted Signal Detect -- Deasserted Signal detect -- Hysteresis Wavelength of Operation Electrical Data Output Voltage – Low Data Output Voltage – High Signal Detect Output Voltage -- Low Signal Detect Output Voltage -- High Symbol Sen. 2X Sen. 1X Pin Pa Pd Min -----9 ---45 1.0 1100 -2.0 -1.1 2.0 Typ ------------Max -30 -30 ---30 --1600 -1.58 -0.74 0.5 Units dBm dBm dBm dBm dBm dB nm V V V V Notes 1 1 Transition: low to high Transition: high to low VOL - VCC VOH - VCC VOL VOH 2 2 Notes: 1.Minimum sensitivity and saturation levels at BER=1E-12 for a 27-1 PRBS. 2. These outputs are compatible with 10K, 10KH and 100K ECL and PECL outputs. *********************************************************************************************************************************************************************** OPTOWAY TECHNOLOGY INC. No.38, Kuang Fu S. Road, Hu Kou, Hsin Chu Industrial Park, Hsin Chu, Taiwan 303 Tel: 886-3-5979798 Fax: 886-3-5979737 E-mail: sales@optoway.com.tw http: // www.optoway.com.tw 1 2/1/2005 V2.0 Optoway CONNECTION DIAGRAM TRSL-93120FG 3 *********************************************************************************************************************************************************************** P IN 1 2 3 4 5 6 7 8 9 10 MS Symbol VEEr VCC r SD RD− RD+ VCC t VEEt TDis TD+ TDMS Notes Directly connect this pin to the receiver ground plane +3.3V dc power for the receiver section Active high on this indicates a received optical signal. R eceiver Dataout Bar. See recommended circuit schematic Receiver Dataout. See recommended circuit schematic +3.3V dc power for the transmitter section Directly connect this plan to the transmitter ground plane Transmitter Disable. Connect this pin to +3.3V TTL logic “1 ” to disable module To enable module connect to TTL logic low “0” Transmitter Data In. See recommended circuit schematic Transmitter Data In Bar. See recommended circuit schematic Mounting Studs. Connect to Chassis Ground RECOMMENDED CIRCUIT SCHEMATIC Vcc3.3V TDZ=50R LVPECL TD+ Z=5OR 10 9 8 7 6 TXDis(LVTTL) 1uH Vcc3.3V T DT D+ TDis Ve e t Vc c t 10nF 10uF 1uH 10nF 10uF PHY DEVICE 1 2 3 4 5 Ve e r Vc c r SD R DR D+ 10nF 10uF Vcc3.3V RD+ 100R Z=50R LVPECL RDZ=5OR SD TO LVTTL STAGE Note: 1. TX input is terminated inside the module. 2. Veer and Veet are not internally connected to each other. 3. 50 Ω line pattern and component placements on TD+/TD- and RD+/RD- lines shall be symmetrical for better impedance matching. *********************************************************************************************************************************************************************** OPTOWAY TECHNOLOGY INC. No.38, Kuang Fu S. Road, Hu Kou, Hsin Chu Industrial Park, Hsin Chu, Taiwan 303 Tel: 886-3-5979798 Fax: 886-3-5979737 E-mail: sales@optoway.com.tw http: // www.optoway.com.tw 1 2/1/2005 V2.0 Optoway PACKAGE DIAGRAM Units in mm TRSL-93120FG 4 *********************************************************************************************************************************************************************** 1) Standard Case TRSL-93120FG 2) Extended Case TRSL-93120FEG Note: Specifications subject to change without notice. *********************************************************************************************************************************************************************** OPTOWAY TECHNOLOGY INC. No.38, Kuang Fu S. Road, Hu Kou, Hsin Chu Industrial Park, Hsin Chu, Taiwan 303 Tel: 886-3-5979798 Fax: 886-3-5979737 E-mail: sales@optoway.com.tw http: // www.optoway.com.tw 1 2/1/2005 V2.0