801-RF1575.42M-D

Oscilent Corporation RF SAW Filter | 801-RF1575.42M-D Page 1 of 3 RF SAW Filter Part Number Package Application Last Modified 801-RF1575.42M-D . TYPE : 2.5 x 2.0 SMD GPS Mar. 14, 2007 GPS, RF SAW Filter PART NUMBER : 801-RF1575.42M-D .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Maximum Insertion Loss Attenuation: Condition 1574.42~ 1576.42 MHz DC~ 1429.0 MHz 1429.0~ 1501.0 MHz 1501.0~ 1526.0MHz 1625.0~ 1650.0 MHz 1650.0~ 2200.0 MHz 2200.0~ 2500.0 MHz Source Impedence (single ended)* Load Impendance (single ended)* VSWR Amplitude Ripple Maximum DC Voltage Maximum Input Power Operating Temperature 1574.42~ 1576.42 MHz 1574.42~ 1576.42 MHz Minimum 19 23 20 15 21 21 -40 Typical 1575.42 1.0 21 26 25 30 25 25 50 50 1.1 0.1 Maximum 1.5 1.5 0.5 7.5 20 +85 ohm ohm dBp-p V dBm ºC dB Units MHz dB * No Matching Network(Ref. Testing Enviroment Circut as shown below) . PACKAGE OUTLINE (mm) PIN LAYOUT A B C D Ground In Out Ground TEST FIXTURE Oscilent Corporation RF SAW Filter | 801-RF1575.42M-D Page 2 of 3 Load/ Source Impedance = 50 ohms FREQUENCY RESPONSE VSWR SMITH CHART Oscilent Corporation RF SAW Filter | 801-RF1575.42M-D Page 3 of 3 Part No.: 801-RF1575.42M-D Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map