803-RF413.7M-A

Oscilent Corporation RF SAW Filter | 803-RF413.7M-A Page 1 of 3 RF SAW Filter Part Number Package Application Last Modified 803-RF413.7M-A . TYPE : 3.8 x 3.8 SMD CDMA450 Tx Jan. 01, 2007 CDMA450 (D-Band), RF-Tx SAW Filter PART NUMBER : 803-RF413.7M-A .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Maximum Insertion Loss Stop Band Attenuation: Condition 411.6 ~ 415.9 MHz 0.3 ~ 400.0 MHz 421.6 ~ 425.9 MHz 425.9 ~ 1700.0MHz 1700.0~ 2000.0 MHz Source Impedence (single ended)* Load Impendance (single ended)* VSWR Maximum Input Power Operating Temperature * No Matching Network 411.6 ~ 415.9 MHz Minimum 25 30 23 18 -30 Typical 413.7 1.8 27 50 27 21 50 50 1.5 Maximum 2.8 2.0 30 +80 ohm ohm dBm ºC dB Units MHz dB . PACKAGE OUTLINE (mm) PIN LAYOUT A B C D E F Ground In Ground Ground Out Ground TEST FIXTURE Oscilent Corporation RF SAW Filter | 803-RF413.7M-A Page 2 of 3 Source/ Load Impedance = 50 ohms FREQUENCY RESPONSE VSWR SMITH CHART Oscilent Corporation RF SAW Filter | 803-RF413.7M-A Page 3 of 3 Part No.: 803-RF413.7M-A Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map