805-SL482.0M-20

Oscilent Corporation IF SAW Filter | 805-SL482.0M-20 Page 1 of 2 IF SAW Filter Part Number Package Application Last Modified 805-SL482.0M-20 . TYPE : 5.0 x 5.0 SMD Communication Jan. 01, 2007 IF SAW Filter PART NUMBER : 805-SL482.0M-20 .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Insertion Loss Relative Attenuation Bandwidth at -1.0 dB Bandwidth at -3.0 dB Bandwidth at -40.0 dB Amplitude Ripple Passband Phase Ripple Absolute Delay Source Impedance (Balanced)* Load Impedance (Balanced)* Temperature Coefficient Operating Temperature Storage Temperature Condition @ Fo Fo ± 15.0 MHz Fo ± 140.0 MHz 472 ~ 492 MHz 472 ~ 492 MHz @ Fo Minimum 5 40 22.5 -0 -35 Typical 482.0 8.7 8 45 23.0 26.5 37.5 0.8 7 0.35 100 100 -94 Maximum 12.0 39.0 1.0 10 +50 +85 dBp-p DEG. µsec ohm ohm ppm/ºC ºC ºC MHz Units MHz dB dB * With Matching Network (Ref. Testing Environment Circuit as shown below) ** Custom SAW IF Filters available. Contact Oscilent for assistance. . PACKAGE OUTLINE (mm) PIN LAYOUT A B C D E F G H Ground In In Ground Ground Out Out Ground TEST FIXTURE Oscilent Corporation IF SAW Filter | 805-SL482.0M-20 Page 2 of 2 L1 = 18nH L2 = 12nH C1 = 27pF C2 = 36pF Source/Load Impedance = 100 ohms FREQUENCY RESPONSE Part No.: 805-SL482.0M-20 Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map