821-IF65.0M-H

Oscilent Corporation IF SAW Filter | 821-IF65.0M-H Page 1 of 2 IF SAW Filter Part Number Package Application Last Modified 821-IF65.0M-H . TYPE : 20 x9.8 SMD 65.0 MHz IF SAW Filter Jan. 01 2007 65.0 MHz IF SAW Filter PART NUMBER : 821-IF65.0M-H .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Insertion Loss Source Impedance (single ended)* Load Impedance (single ended)* Temperature Coefficient Amplitude Ripple within fo+/-9.75Mhz 1dB Bandwidth 3dB Bandwidth 40dB Bandwidth 50dB Bandwidth Attenuation Rejection Absolute Delay at Fo Group Delay Variation Minimum 9.8 10.3 50 Typical 65.0 18.5 50 50 -72 0.65 10.00 10.52 12.63 12.82 55 1.67 45 Maximum 20.5 1.0 12.8 13.0 100 Units MHz dB ohm ohm ppm/C dBp-p MHz MHz MHz dB dB µsec nsec *With Matching Network (Ref. Testing Environment Circut as shown below). Those impedances could be modified with different impedance values and/or structures, if necessary. ** Custom SAW IF Filters available. Contact Oscilent for assistance. . PACKAGE OUTLINE (mm) TEST FIXTURE L1 = 68nH C1 = 24pF L2 = 120nH - Source/Load Impedance = 50 ohms Pin Descriptions: IN-10, OUT-5, GROUND- 1,2,3,4,6,7,8,9 FREQUENCY RESPONSE Oscilent Corporation IF SAW Filter | 821-IF65.0M-H Page 2 of 2 Part No.: 821-IF65.0M-H Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map