835-IF100.0M-F

Oscilent Corporation IF SAW Filter | 835-IF100.0M-F Page 1 of 2 IF SAW Filter Part Number Package Application Last Modified 835-IF100.0M-F . TYPE : 35.0 x 12.8 Thru Hole Base Station & Repeater May 30 2003 100.0 MHz Bandpass Filter 19.00 MHz Bandwidth PART NUMBER : 835-IF100.0M-F .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency Insertion Loss 1dB Bandwidth 3dB Bandwidth 40dB Bandwidth Passband Ripple Group Delay Variation Absolute Delay Ultimate Rejection Substrate Material Ambient Temperature Minimum 99.91 18.70 19.0 50 Typical 100.00 24.5 18.75 19.05 20.15 0.90 50 2.70 55 128° LN 25 Maximum 100.09 27.0 20.20 1.2 100 Units MHz dB MHz MHz MHz dB nsec µsec dB °C * Custom SAW IF Filters available. Contact Oscilent for assistance. . PACKAGE OUTLINE (mm) TEST FIXTURE L1 = 47nH L2 = 47nH C1 = 62pF C2 = 8pF Source/Load Impedance = 50 ohms Part No.: 835-IF100.0M-F http://www.oscilent.com/spec_pages/if_sawfilter/if_835_if100_0f.htm 12/28/2005 Oscilent Corporation IF SAW Filter | 835-IF100.0M-F Page 2 of 2 Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map http://www.oscilent.com/spec_pages/if_sawfilter/if_835_if100_0f.htm 12/28/2005