835-IF160.0M-M

Oscilent Corporation IF SAW Filter | 835-IF160.0M-M Page 1 of 3 IF SAW Filter Part Number Package Application Last Modified 835-IF160.0M-M . TYPE : 35.0 x 12.8 Thru Hole Base Station & Repeater Jan. 01, 2007 160.0 MHz Bandpass Filter PART NUMBER : 835-IF160.0M-M .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Insertion Loss at Fo Storage Temperature Operating Temperature Source Impedance (single ended)* Load Impedance (single ended)* Temperature Coefficient Amplitude Ripple (Fo+/-9.375 MHz) Bandwidth at 1.5 dB Bandwidth at 3.0 dB Bandwidth at 40.0 dB Ultimate Rejection Group Delay Variation (Fo+/-9.375 MHz) Adsolute Delay at Fo Minimum 159.9 -40 -30 18.9 19.2 50 Typical 160.0 31.3 50 50 -20 0.9 19.12 19.40 20.78 55 50 2.73 Maximum 160.1 32.5 +85 +70 1.5 21.0 100 Units MHz dB °C °C ohm ohm ppm/°C dBp-p MHz MHz MHz dB ns us * with Matching Network (Ref. Testing Environment Circut as shown below). Those impedances could be modified with different impedances values and/or structures, if necessary. ** Custom SAW IF Filters available. Contact Oscilent for assistance. . PACKAGE OUTLINE (mm) Oscilent Corporation IF SAW Filter | 835-IF160.0M-M Page 2 of 3 PIN Descriptions: IN-1, OUT 5, GROUND -2,3,4,6,Case TEST ENVIRONMENT Source & Load Impedance: 50 ohm FREQUENCY RESPONSE Oscilent Corporation IF SAW Filter | 835-IF160.0M-M Page 3 of 3 Part No.: 835-IF160.0M-M Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map