835-IF167.5M-A

Oscilent Corporation IF SAW Filter | 835-IF167.5M-A Page 1 of 2 IF SAW Filter Part Number Package Application Last Modified 835-IF167.5M-A TYPE : 35.0 x 12.8 Thru Hole Base Station & Repeater Jan. 01, 2007 167.5 MHz Bandpass Filter PART NUMBER : 835-IF167.5M-A OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Insertion Loss at Fo Source Impedance (single ended)* Load Impedance (single ended)* Temperature Coefficient Amplitude Ripple Bandwidth at 3.0 dB Ultimate Rejection Fo + 200 KHz Fo + 400 KHz Fo + 600 KHz Fo + 1 MHz Adsolute Delay at Fo 50 9.4 21.2 42.3 62 3.12 Minimum 167.35 9.8 Typical 167.5 24.5 50 50 -23 0.55 10.0 dB dB dB dB us Maximum 167.65 26.0 1.0 Units MHz dB ohm ohm ppm/°C dBp-p MHz * with Matching Network (Ref. Testing Environment Circut as shown below). Those impedances could be modified with different impedances values and/or structures, if necessary. ** Custom SAW IF Filters available. Contact Oscilent for assistance. PACKAGE OUTLINE (mm) PIN Descriptions: IN-1, OUT 5, GROUND -2,3,4,6,Case TEST ENVIRONMENT Oscilent Corporation IF SAW Filter | 835-IF167.5M-A Page 2 of 2 Source & Load Impedance: 50 ohm FREQUENCY RESPONSE Part No.: 835-IF167.5M-A Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map