835-IF222.064-A

Oscilent Corporation IF SAW Filter | 835-IF222.064M-A Page 1 of 3 IF SAW Filter Part Number Package Application Last Modified 835-IF222.064M-A . TYPE : 35.0 x 12.8 Thru Hole Base Station & Repeater Jan. 01, 2007 222.064 MHz Bandpass Filter PART NUMBER : 835-IF222.064-A .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency Insertion Loss Source Impedance (single ended)* Load Impedance (single ended)* 1dB Bandwidth 3dB Bandwidth 40dB Bandwidth Amplitude Ripple Group Delay Variation (smo 0.5%) Absolute Delay Ultimate Rejection Temperature Coefficient Minimum 50 Typical 222.064 23.20 50 50 1.75 1.89 2.53 0.75 150 3.77 55 -0.03 Maximum 25.0 1.2 Units MHz dB ohm ohm MHz MHz MHz dBp-p ns µs dB ppm/°C * with Matching Network (Ref. Testing Environment Circut as shown below). Those impedances could be modified with different impedances values and/or structures, if necessary. ** Custom SAW IF Filters available. Contact Oscilent for assistance. . PACKAGE OUTLINE (mm) Oscilent Corporation IF SAW Filter | 835-IF222.064M-A Page 2 of 3 PIN Descriptions: IN-1, OUT 5, GROUND -2,3,4,6,Case TEST ENVIRONMENT Source & Load Impedance: 50 ohm FREQUENCY RESPONSE Oscilent Corporation IF SAW Filter | 835-IF222.064M-A Page 3 of 3 Part No.: 835-IF222.064M-A Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map