835-IF44.0M-E

Oscilent Corporation IF SAW Filter | 835-IF44.0M-E Page 1 of 3 IF SAW Filter Part Number Package Application Last Modified 835-IF44.0M-E . TYPE : 35.0 x 12.8 Thru Hole Base Station & Repeater Jan. 01, 2007 44.0 MHz Bandpass Filter PART NUMBER : 835-IF44.0M-E .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency Insertion Loss Source Impedance (single ended)* Load Impedance (single ended)* 1.0dB Bandwidth 3.0dB Bandwidth 40.0dB Bandwidth Amplitude Ripple Group Delay Variation Absolute Delay at Fo Ultimate Rejection Temperature Coefficient Minimum 43.95 5.4 5.6 45 Typical 44.0 24.5 50 50 5.5 5.68 6.45 0.5 65 4.07 50 -94 Maximum 44.05 25.5 6.6 0.8 100 Units MHz dB ohm ohm MHz MHz MHz dBp-p ns µs dB ppm/°C * with Matching Network (Ref. Testing Environment Circut as shown below). Those impedances could be modified with different impedances values and/or structures, if necessary. ** Custom SAW IF Filters available. Contact Oscilent for assistance. . PACKAGE OUTLINE (mm) Oscilent Corporation IF SAW Filter | 835-IF44.0M-E Page 2 of 3 PIN Descriptions: IN-1, OUT 5, GROUND -2,3,4,6,Case TEST ENVIRONMENT Source & Load Impedance: 50 ohm FREQUENCY RESPONSE Oscilent Corporation IF SAW Filter | 835-IF44.0M-E Page 3 of 3 Part No.: 835-IF44.0M-E Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map