862-RF1220.0M-A

Oscilent Corporation RF SAW Filter | 862-RF1220.0M-A Page 1 of 3 RF SAW Filter Part Number Package Application Last Modified 862-RF1220.0M-A . TYPE : 3.0 x 3.0 SMD Wireless Jan. 01, 2007 Wireless, Balanced RF SAW Filter PART NUMBER : 862-RF1220.0M-A .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Maximum Insertion Loss Stop Band Attenuation: Condition 1216.0~ 1224.0 MHz Fo-200.0~ Fo-68.0 MHz Fo-88.0 MHz Fo-72.0MHz Fo-44.0 MHz Fo-36.0 MHz Fo-+70.0~ 2000.0 MHz Amplitude Ripple Source Impedence (balanced ended)* Load Impendance (balanced ended)* Group Delay Ripple Maximum DC Voltage Maximum Input Power Operating Temperature * With Matching Network ns 1216.0~ 1224.0 MHz 1216.0~ 1224.0 MHz Minimum 46 48 50 48 46 50 -30 Typical 1220.0 3.5 51 53 58 56 59 61 0.4 200 200 40 Maximum 4.8 1.0 3 0 +80 dBp-p ohm ohm nsp-p V dBm ºC dB Units MHz dB . PACKAGE OUTLINE (mm) PIN LAYOUT A B C D E F G H In In Ground Ground Out Out Ground Ground TEST FIXTURE Oscilent Corporation RF SAW Filter | 862-RF1220.0M-A Page 2 of 3 Load Impedance = 200 ohms Source Impedance = 200 ohms FREQUENCY RESPONSE VSWR SMITH CHART Oscilent Corporation RF SAW Filter | 862-RF1220.0M-A Page 3 of 3 Part No.: 862-RF1220.0M-A Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map