862-RF423.7M-B

Oscilent Corporation RF SAW Filter | 862-RF423.7M-B Page 1 of 3 RF SAW Filter Part Number Package Application Last Modified 862-RF423.7M-B . TYPE : 3.0 x 3.0 SMD CDMA450(D-Band) Jan. 01, 2007 CDMA450(D-Band), Balanced RF-Rx SAW Filter PART NUMBER : 862-RF423.7M-B .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Maximum Insertion Loss Stop Band Attenuation: Condition 421.6~ 425.9 MHz 0.3~ 411.6 MHz 411.6~ 415.9 MHz 442.0~ 600.0MHz 600~ 1200.0 MHz 1200~ 2000.0 MHz Source Impedence (single ended)* Load Impendance (balanced ended)* VSWR Maximum Input Power Operating Temperature * No Matching Network 421.6~ 425.9 MHz Minimum 40 35 40 40 35 -30 Typical 423.7 2.3 50 48 47 55 50 50 100 1.7 Maximum 4.5 2.4 27 +80 ohm ohm dBm ºC dB Units MHz dB . PACKAGE OUTLINE (mm) PIN LAYOUT A B C D E F G H Ground In Ground Ground Out Ground Out Ground TEST FIXTURE Oscilent Corporation RF SAW Filter | 862-RF423.7M-B Page 2 of 3 Load Impedance = 100 ohms Source Impedance = 50 ohms FREQUENCY RESPONSE VSWR SMITH CHART Oscilent Corporation RF SAW Filter | 862-RF423.7M-B Page 3 of 3 Part No.: 862-RF423.7M-B Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map