863-RF243.95M-A

Oscilent Corporation IF SAW Filter | 863-RF243.95M-A Page 1 of 3 IF SAW Filter Part Number Package Application Last Modified 863-RF243.95M-A . TYPE : 3.8 x 3.8 SMD PHS Jan. 01 2007 PHS, IF SAW Filter PART NUMBER : 863-RF243.95M-A .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Insertion Loss Relative Attenutation Fo ± 600 MHz Fo ± 10.7 MHz Fo ± 21.4 MHz Source Impedence (single ended)* Amplitude Ripple within Group Delay Ripple within Load Impendance (single ended)* Terminating Impedance DC Voltage Input Power Operating Temperature Fo ± 100KHz Fo ± 100KHz Minimum 25 40 60 -10 Typical 243.95 3.0 30 60 65 50 0.4 0.4 50 50 0 Maximum 4.0 1.0 1.0 0 5 +60 ohm dB us ohm ohm V dBm ºC dB Units MHz dB * With matching network (Ref. Testing Environment Circuit as shown below) . PACKAGE OUTLINE (mm) PIN LAYOUT A B C D E F G H Ground In Ground Ground Out Ground Out Ground TEST FIXTURE Oscilent Corporation IF SAW Filter | 863-RF243.95M-A Page 2 of 3 Source/Load Impedance = 50 ohms FREQUENCY RESPONSE Oscilent Corporation IF SAW Filter | 863-RF243.95M-A Page 3 of 3 Part No.: 863-RF243.95M-A Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map