863-RF433.92M-D

Oscilent Corporation RF SAW Filter | 863-RF433.92M-D Page 1 of 2 RF SAW Filter Part Number Package Application Last Modified 863-RF433.92M-D . TYPE : 3.8 x 3.8 SMD Remote Control Jan. 01, 2007 Remote Control, RF SAW Filter PART NUMBER : 863-RF433.92M-D .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Maximum Insertion Loss Relative Attenuation: Condition 433.80~ 434.12 MHz 10.0 ~ 414.0 MHz 414.0~ 428.0 MHz 428.0 ~ 432.92MHz 434.92 ~ 442.0 MHz 442.0 ~ 550.0 MHz 550.0 ~ 1000.0 MHz Source Impedence (single ended)* Load Impendance (single ended)* Pass Band Ripple Maximum DC Voltage Maximum Input Power Operating Temperature * With Matching Network 433.76~ 434.16 MHz Minimum 45 40 15 10 35 45 -40 Typical 433.92 2.0 50 45 20 15 40 50 50 50 1.0 Maximum 4.5 2.0 10 10 +85 ohm ohm V dBm ºC dB Units MHz dB . PACKAGE OUTLINE (mm) PIN LAYOUT 1 2 3 4 5 6 7 8 Out Ground Ground Ground Ground In Ground Ground TEST FIXTURE Oscilent Corporation RF SAW Filter | 863-RF433.92M-D Page 2 of 2 Source/ Load Impedance = 50 ohms FREQUENCY RESPONSE Part No.: 863-RF433.92M-D Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map