871-IF38.912M-E

Oscilent Corporation IF SAW Filter | 871-IF38.912M-E Page 1 of 3 IF SAW Filter Part Number Package Application Last Modified 871-IF38.912M-E TYPE : 11.5 x 4.8 SMD DAB Jan. 01, 2007 38.912 MHz IF SAW Filter for DAB Application 1.5 MHz Bandwidth PART NUMBER : 871-IF38.912M-E OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency Insertion Loss at Fo -3.0 dB Bandwidth -30.0 dB Bandwidth Relative Attenuation 30.00 to 36.26 MHz Relative Attenuation 36.26 to 37.30 MHz Relative Attenuation 40.60 to 41.40MHz Relative Attenuation 41.40 to 50.00MHz Source Impedance (Single Ended or Balanced)* Load Impedance (Single Ended or Balanced)* Group Delay Variation Storage Temperature Operating Temperature Temperature Coefficient Absolute Delay at Fo Minimum 40 40 40 40 -40 -30 Typical 38.912 17.0 1.5 2.7 45 48 48 50 50/2000 50/2000 80 -20 1.36 Maximum 19.0 200 +85 +80 Units MHz dB MHz MHz dB dB dB dB ohm ohm ns ppm/°C °C ppm/°C µsec * With Matching Network (Ref. Testing Environment Circuit as shown below) Those impedances could be modified with different impedance values and/or structures, if necessary. ** Custom SAW IF Filters available. Contact Oscilent for assistance. PACKAGE OUTLINE (mm) Oscilent Corporation IF SAW Filter | 871-IF38.912M-E Page 2 of 3 TEST CIRCUIT SOURCE AND LOAD IMPEDANCE: 50 or 2K ohm FREQUENCY RESPONSE Oscilent Corporation IF SAW Filter | 871-IF38.912M-E Page 3 of 3 GROUP DELAY VARIATION Part No.: 871-IF38.912M-E Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map