PSA20U-560

WWW.PHIHONG.COM 19.6W Power Over Ethernet Adapter PSA20U High Power single port injector. Features • • • • • • • • • • Fully Compliant detection, disconnect, over load and voltage control IEEE802.3af Diagnostic LEDs Non-Vented Case • • • • • UNH IOL Test Report Full Protection OCP, OVP Gigabit Compatible Applications IP Telephones Wireless Network Access Points Blue Tooth Access Point Security Camera IP Print Servers Safety Approvals cUL/UL CE • TUV Mechanical Characteristics Length: 140mm (5.51in) Width: 65mm (2.55in) • • Height: 36mm (1.42in) Weight: 0.2Kg (0.44lb.) Output Specifications Model PSA20U-560(G) DC Output Voltage 56V 0A Vp-p* 0.5 0.15 0.15 0.1 Load Min. Max. 0.35A Regulation Line ±4% Load Ripple And Noise* 10M OHM 500VDC Primary to FC: >10M OHM 500VDC OUTPUT: Total Output Power 19.6W FEATURE: Over Voltage/Current, Short Circuit Protection Outputs equipped with short circuit protection and overload protection as per 802.3af specification The output can be shorted permanently without damage Efficiency 65% (typical) at Max. load, and 120VAC 60Hz Hold-up Time 16mS min. 120VAC and max. load Indicators Led #1 indicator for input power “on” GREEN Led #2 Indicator for fault-RED Led #3 Indicator that Detected and Connected to valid IEEE802.3af load-GREEN Transient O/P Voltage Protection 60V max. at switch on and off at any AC line Phase ENVIRONMENTAL: Temperature Operation Non-operation 0 to +40°C -25 to +65°C Input Connector IEC320 inlet 3 pin Humidity Operation 5 to 90% Dimension Diagram Unit: mm (inch)