1401201

https://www.phoenixcontact.com/us/products/1401201 Flush-type connector - SACC-DSI-FS-5CON-PG9/2,0PE SCO - 1401201 Please be informed that the data shown in this PDF Document is generated from our Online Catalog. Please find the complete data in the user's documentation. Our General Terms of Use for Downloads are valid (http://phoenixcontact.com/download) Sensor/actuator flush-type socket, 5-pos., M12 SPEEDCON, A-coded, rear/screw mounting with Pg9 thread, with 2 m TPE litz wire, 5 x 0.34 mm², green/yellow wire to PIN5 Key Commercial Data Packing unit 1 pc Minimum order quantity 50 pc GTIN GTIN 4046356536264 Weight per Piece (excluding packing) 40.000 g Custom tariff number 85444290 Country of origin Germany Technical data Dimensions Fixed cable length 2 Ambient conditions Ambient temperature (operation) -25 ... -85 (Plug / socket) General Standards/regulations according to IEC 61076-2-101 Overvoltage category II Mounting type Rear mounting Coding A-coded Cable cross section 0.34 AWG signal line 22 Rated surge voltage 1.5 kV AC Degree of pollution 3 Degree of protection IP67 Number of positions 5 01/05/2020   Page 1 / 8 https://www.phoenixcontact.com/us/products/1401201 Flush-type connector - SACC-DSI-FS-5CON-PG9/2,0PE SCO - 1401201 Technical data General Current 4A Voltage 60 V Material Contact material CuZn Contact surface material Au Flammability rating according to UL 94 V0 Connection data Connection method Individual wires Cable type TPE litz wire Standards and Regulations Standards/regulations according to IEC 61076-2-101 Flammability rating according to UL 94 V0 Safety note WARNING: The connectors may not be plugged in or disconnected under load. Ignoring the warning or improper use may damage persons and/or property. • WARNING: Commission properly functioning products only. The products must be regularly inspected for damage. Decommission defective products immediately. Replace damaged products. Repairs are not possible. • WARNING: Only electrically qualified personnel may install and operate the product. They must observe the following safety notes. The qualified personnel must be familiar with the basics of electrical engineering. They must be able to recognize and prevent danger. The relevant symbol on the packaging indicates that only personnel familiar with electrical engineering are allowed to install and operate the product. • The products are suitable for applications in plant, controller, and electrical device engineering. • When operating the connectors in outdoor applications, they must be separately protected against environmental influences. • Assembled products may not be manipulated or improperly opened. • Only use mating connectors that are specified in the technical data of the standards listed (e.g. the ones listed in the product accessories online at phoenixcontact.com/products). • When using the product in direct connection with third-party manufacturers, the user is responsible. • For operating voltages > 50 V AC, conductive connector housings must be grounded • Ensure that when laying the cable, the tensile load on the connectors does not exceed the upper limit specified in the standards. • Observe the corresponding technical data. You will find information: o On the product o On the packing label o In the supplied documentation o Online at phoenixcontact.com/products under the product 01/05/2020   Page 2 / 8 https://www.phoenixcontact.com/us/products/1401201 Flush-type connector - SACC-DSI-FS-5CON-PG9/2,0PE SCO - 1401201 Technical data Standards and Regulations • Only use tools recommended by Phoenix Contact • Use a protective cap to protect connectors that are not in use. The suitable accessories are available online in the accessory section of the product at phoenixcontact.com/products • Ensure that the protective or functional ground has been properly connected. • VDE 0100/1.97 § 411.1.3.2 and DIN EN 60 204/11.98 § 14.1.3 are applicable when combining several circuits in a cable and/or connector • The connector warms up in normal operation. Depending on the ambient conditions, the surface of the connector can continue to warm up. In this case, the user is responsible for posting warnings (e.g. DIN EN ISO 13732-1:2008-12). Environmental Product Compliance REACh SVHC Lead 7439-92-1 China RoHS Environmentally Friendly Use Period = 50 For details about hazardous substances go to tab “Downloads”, Category “Manufacturer's declaration” Drawings 01/05/2020   Page 3 / 8 https://www.phoenixcontact.com/us/products/1401201 Flush-type connector - SACC-DSI-FS-5CON-PG9/2,0PE SCO - 1401201 Dimensional drawing Housing cutout for Pg9 fastening thread, mounting panel with feed-through hole (alternatively with surface as protection against rotation) 01/05/2020   Page 4 / 8 https://www.phoenixcontact.com/us/products/1401201 Flush-type connector - SACC-DSI-FS-5CON-PG9/2,0PE SCO - 1401201 Dimensional drawing M12 flush-type connector 01/05/2020   Page 5 / 8 https://www.phoenixcontact.com/us/products/1401201 Flush-type connector - SACC-DSI-FS-5CON-PG9/2,0PE SCO - 1401201 Dimensional drawing Housing cutout for Pg9 fastening thread, mounting panel with thread 01/05/2020   Page 6 / 8 https://www.phoenixcontact.com/us/products/1401201 Flush-type connector - SACC-DSI-FS-5CON-PG9/2,0PE SCO - 1401201 Schematic diagram Pin assignment M12 socket, 5-pos., A-coded, socket side view Classifications eCl@ss eCl@ss 10.0.1 27440102 eCl@ss 4.0 27140800 eCl@ss 4.1 27140800 eCl@ss 5.0 27143400 eCl@ss 5.1 27143400 eCl@ss 6.0 27279200 eCl@ss 7.0 27440103 eCl@ss 8.0 27440103 01/05/2020   Page 7 / 8 https://www.phoenixcontact.com/us/products/1401201 Flush-type connector - SACC-DSI-FS-5CON-PG9/2,0PE SCO - 1401201 Classifications eCl@ss eCl@ss 9.0 27440102 ETIM ETIM 3.0 EC002061 ETIM 4.0 EC002061 ETIM 5.0 EC002061 ETIM 6.0 EC002061 UNSPSC UNSPSC 6.01 31261501 UNSPSC 7.0901 31261501 UNSPSC 11 31261501 UNSPSC 12.01 31261501 UNSPSC 13.2 39121413 UNSPSC 18.0 39121413 UNSPSC 19.0 39121413 UNSPSC 20.0 39121413 UNSPSC 21.0 39121413 Approvals Approvals Approvals EAC Ex Approvals Approval details EAC      B.00767 Phoenix Contact 2020 © - all rights reserved http://www.phoenixcontact.com 01/05/2020   Page 8 / 8