1410506

https://www.phoenixcontact.com/us/products/1410506 Test accessories - EV-T2MBIE24-1ACDC-INFRA - 1410506 Please be informed that the data shown in this PDF Document is generated from our Online Catalog. Please find the complete data in the user's documentation. Our General Terms of Use for Downloads are valid (http://phoenixcontact.com/download) Special Vehicle Inlet for charging station tests, CCS type 2, IEC 62196-3, 125 A / 850 V (DC), 24 V Locking actuator, Single wires, Length: 2 m Product Description Special Vehicle Inlet for charging station tests, solely for laboratory tests, tests with charging stations (EVSE), and further analyses on the infrastructure side - not for installation in any type of vehicle, cannot be used outside of the laboratory area Key Commercial Data Packing unit 1 pc Weight per Piece (excluding packing) 4580.0 g Custom tariff number 85366990 Country of origin Germany Technical data Dimensions Conductor length 2.00 m General Product type Special Vehicle Inlet for charging station tests Standards/regulations IEC 62196-3 Charging standard CCS type 2 Charging mode Mode 2, 3, 4 Features Charging power 106 kVA Number of phases 1 Rated current for power contacts 125 A DC 20 A AC Rated voltage for power contacts 250 V AC 03/15/2016   Page 1 / 6 https://www.phoenixcontact.com/us/products/1410506 Test accessories - EV-T2MBIE24-1ACDC-INFRA - 1410506 Technical data Features 850 V DC Rated current for signal contacts 2A Rated voltage for signal contacts 30 V AC Type of signal transmission Pulse width modulation Temperature monitoring 2x Pt 1000 Number of power contacts 5 (L1, N, PE, DC+, DC-) Number of signal contacts 2 (CP, PP) Insertion force < 100 N Withdrawal force < 100 N Insertion/withdrawal cycles > 10000 Ambient temperature (operation) -30 °C ... 50 °C Ambient temperature (storage/transport) -40 °C ... 80 °C Altitude difference for area of application 5000 m (above sea level) Degree of protection IP44 (plugged in) IP55 (in road position) Locking actuator Typical power supply at the motor 24 V Possible power supply range at the motor 22 V ... 26 V Typical motor current for locking 0.05 A Max. reverse current of the motor 0.5 A Max. dwell time with reverse current 1000 ms Recommended adaptation time 600 ms Maximum voltage for locking detection 30 V Service life > 10000 load cycles Ambient temperature (operation) -30 °C ... 50 °C Length of cable 0.5 m Classifications eCl@ss eCl@ss 4.1 27260701 eCl@ss 5.1 27059110 eCl@ss 6.0 27059290 eCl@ss 8.0 27440590 eCl@ss 9.0 27144706 03/15/2016   Page 2 / 6 https://www.phoenixcontact.com/us/products/1410506 Test accessories - EV-T2MBIE24-1ACDC-INFRA - 1410506 Classifications ETIM ETIM 4.0 EC002498 ETIM 5.0 EC002498 Drawings Connection diagram Dimensional drawing PE PP !126,9 L1 N L2 L3 DC- DC+ 26,5 R!31 CP R!41 Pin assignment of Vehicle Inlet !101,9 51,5 Dimensional drawing, side view Dimensional drawing 75,9 46 116 104 R24,5 M6 70 Dimensional drawing top view 03/15/2016   Page 3 / 6 https://www.phoenixcontact.com/us/products/1410506 Test accessories - EV-T2MBIE24-1ACDC-INFRA - 1410506 Schematic diagram DC AC The Combined Charging System (CCS) principle - standard-compliant charging system for electric vehicles, which supports both conventional AC charging and fast DC charging. Both Vehicle Connectors fit into the CCS Vehicle Inlet. 03/15/2016   Page 4 / 6 https://www.phoenixcontact.com/us/products/1410506 Test accessories - EV-T2MBIE24-1ACDC-INFRA - 1410506 Schematic diagram DC [I] DC [II] DC [III] DC [IV] [V] Operating instructions DC 03/15/2016   Page 5 / 6 https://www.phoenixcontact.com/us/products/1410506 Test accessories - EV-T2MBIE24-1ACDC-INFRA - 1410506 Schematic diagram R=∞Ω R=0Ω Detection for Vehicle Connector Phoenix Contact 2016 © - all rights reserved http://www.phoenixcontact.com 03/15/2016   Page 6 / 6