1444814

Crimp contact - CK1,0-ED-1,5ST AU WTN 1444814 https://www.phoenixcontact.com/us/products/1444814 Please be informed that the data shown in this PDF document is generated from our Online Catalog. Please find the complete data in the user documentation. Our General Terms of Use for Downloads are valid. Crimp contact, Range of articles: VARIOCON, Crimp contact, min. conductor cross section: 0.5 mm2, max. conductor cross section: 1.5 mm2, Connection method: Crimp connection, Type of contact: Pin Commercial Data Item number 1444814 Packing unit 1 pc Minimum order quantity 1,000 pc Note Made to Order (non-returnable) Sales Key A16 Product Key ABLADE GTIN 4046356574921 Weight per Piece (including packing) 0.433 g Weight per Piece (excluding packing) 0.433 g Customs tariff number 85366990 Country of origin DE Nov 6, 2022, 8:39 PM Page 1 (6) Crimp contact - CK1,0-ED-1,5ST AU WTN 1444814 https://www.phoenixcontact.com/us/products/1444814 Technical Data Notes Safety note Safety note WARNING: The connectors may not be plugged in or disconnected under load. Ignoring the warning or improper use may damage persons and/or property. • WARNING: Commission properly functioning products only. The products must be regularly inspected for damage. Decommission defective products immediately. Replace damaged products. Repairs are not possible. • WARNING: Only electrically qualified personnel may install and operate the product. They must observe the following safety notes. The qualified personnel must be familiar with the basics of electrical engineering. They must be able to recognize and prevent danger. The relevant symbol on the packaging indicates that only personnel familiar with electrical engineering are allowed to install and operate the product. • The products are suitable for applications in plant, controller, and electrical device engineering. • When operating the connectors in outdoor applications, they must be separately protected against environmental influences. • Assembled products may not be manipulated or improperly opened. • Only use mating connectors that are specified in the technical data of the standards listed (e.g. the ones listed in the product accessories online at phoenixcontact.com/products). • When using the product in direct connection with third-party manufacturers, the user is responsible. • For operating voltages > 50 V AC, conductive connector housings must be grounded • Ensure that the protective or functional ground has been properly connected. • VDE 0100/1.97 § 411.1.3.2 and DIN EN 60 204/11.98 § 14.1.3 are applicable when combining several circuits in a cable and/or connector • Observe the corresponding technical data. You will find information: o On the product o On the packing label o In the supplied documentation o Online at phoenixcontact.com/products under the product • Only use tools recommended by Phoenix Contact • The installation notes/Design In documents online on the download page at phoenixcontact.com/products must be observed for this product. • Use a protective cap to protect connectors that are not in use. The suitable accessories are available online in the accessory section of the product at phoenixcontact.com/products • Operate the connector only when it is fully plugged in. • Ensure that when laying the cable, the tensile load on the connectors does not exceed the upper limit specified in the Nov 6, 2022, 8:39 PM Page 2 (6) Crimp contact - CK1,0-ED-1,5ST AU WTN 1444814 https://www.phoenixcontact.com/us/products/1444814 standards. • Observe the minimum bending radius of the cable. Lay the cable without twisting it. • The connector warms up in normal operation. Depending on the ambient conditions, the surface of the connector can continue to warm up. In this case, the user is responsible for posting warnings (e.g. DIN EN ISO 13732-1:2008-12). Product properties Product type Crimp contact Contact type turned Connection data Connection method Crimp connection Material specifications Contact material CuZn Contact surface material gold-plated Dimensions Width 2.5 mm Height 2.5 mm Length 23.3 mm Mechanical characteristics Contact diameter 1 mm Nov 6, 2022, 8:39 PM Page 3 (6) Crimp contact - CK1,0-ED-1,5ST AU WTN 1444814 https://www.phoenixcontact.com/us/products/1444814 Approvals  EAC Approval ID: B.01687 Nov 6, 2022, 8:39 PM Page 4 (6) Crimp contact - CK1,0-ED-1,5ST AU WTN 1444814 https://www.phoenixcontact.com/us/products/1444814 Classifications ECLASS ECLASS-9.0 27440204 ECLASS-10.0.1 27440204 ECLASS-11.0 27440204 ETIM ETIM 8.0 EC000796 UNSPSC UNSPSC 21.0 39121500 Nov 6, 2022, 8:39 PM Page 5 (6) Crimp contact - CK1,0-ED-1,5ST AU WTN 1444814 https://www.phoenixcontact.com/us/products/1444814 Environmental Product Compliance China RoHS Environmentally Friendly Use Period = 50 years For information on hazardous substances, refer to the manufacturer’s declaration available under “Downloads” Phoenix Contact 2022 © - all rights reserved https://www.phoenixcontact.com Phoenix Contact USA 586 Fulling Mill Road Middletown, PA 17057, United States (+717) 944-1300 info@phoenixcon.com Nov 6, 2022, 8:39 PM Page 6 (6)