1534562

Device connector, rear mounting - SACCBP-M12FSB5CON-M16/2,0-900 1534562 https://www.phoenixcontact.com/us/products/1534562 Please be informed that the data shown in this PDF document is generated from our Online Catalog. Please find the complete data in the user documentation. Our General Terms of Use for Downloads are valid. Device connector, rear mounting, INTERBUS (16 Mbps), 5-position, PUR halogen-free, green RAL 6017, shielded, Flush-type female connector, straight, M12-SPEEDCON, B-coded, on free cable end, Cable connection, cable length: 2 m, INTERBUS item no.: 1239945 Your advantages • Pre-assembled with cables in various standard lengths for immediate use • Customer-specific assemblies and cable lengths can be supplied • Sealed on the cable side for optimum tightness of seal • Cable designs for all common networks and fieldbuses • For high transmission safety: shield connection to the housing with optional EMC nut Commercial Data Item number 1534562 Packing unit 1 pc Minimum order quantity 1 pc Note Made to Order (non-returnable) Sales Key A11 Product Key ABQCED Catalog Page Page 425 (C-2-2019) GTIN 4046356026734 Weight per Piece (including packing) 164.8 g Weight per Piece (excluding packing) 164.8 g Customs tariff number 85444290 Country of origin DE Dec 21, 2022, 5:50 PM Page 1 (13) Device connector, rear mounting - SACCBP-M12FSB5CON-M16/2,0-900 1534562 https://www.phoenixcontact.com/us/products/1534562 Technical Data Notes Notes on operation The electrical and mechanical data specified assume that the connector pair is correctly locked and mounted. If the connector is unlocked and if there is a danger of contamination, the connector must be sealed using a protective cap > IP54. Influences arising from litz wires, cables or PCB assembly must also be taken into consideration. Safety note Safety note WARNING: The connectors may not be plugged in or disconnected under load. Ignoring the warning or improper use may damage persons and/or property. • WARNING: Commission properly functioning products only. The products must be regularly inspected for damage. Decommission defective products immediately. Replace damaged products. Repairs are not possible. • WARNING: Only electrically qualified personnel may install and operate the product. They must observe the following safety notes. The qualified personnel must be familiar with the basics of electrical engineering. They must be able to recognize and prevent danger. The relevant symbol on the packaging indicates that only personnel familiar with electrical engineering are allowed to install and operate the product. • The products are suitable for applications in plant, controller, and electrical device engineering. • When operating the connectors in outdoor applications, they must be separately protected against environmental influences. • Assembled products may not be manipulated or improperly opened. • Only use mating connectors that are specified in the technical data of the standards listed (e.g. the ones listed in the product accessories online at phoenixcontact.com/products). • When using the product in direct connection with third-party manufacturers, the user is responsible. • For operating voltages > 50 V AC, conductive connector housings must be grounded • Ensure that when laying the cable, the tensile load on the connectors does not exceed the upper limit specified in the standards. • Observe the corresponding technical data. You will find information: o On the product o On the packing label o In the supplied documentation o Online at phoenixcontact.com/products under the product • Only use tools recommended by Phoenix Contact • Use a protective cap to protect connectors that are not in use. The suitable accessories are available online in the accessory section of the product at phoenixcontact.com/products Dec 21, 2022, 5:50 PM Page 2 (13) Device connector, rear mounting - SACCBP-M12FSB5CON-M16/2,0-900 1534562 https://www.phoenixcontact.com/us/products/1534562 • Ensure that the protective or functional ground has been properly connected. • VDE 0100/1.97 § 411.1.3.2 and DIN EN 60 204/11.98 § 14.1.3 are applicable when combining several circuits in a cable and/or connector • The connector warms up in normal operation. Depending on the ambient conditions, the surface of the connector can continue to warm up. In this case, the user is responsible for posting warnings (e.g. DIN EN ISO 13732-1:2008-12). Mounting Mounting type Rear mounting, M16 x 1.5 thread with flat nut Product properties Product type Circular connectors (device side) Number of positions 5 No. of cable outlets 1 Shielded yes Coding B - inverse Insulation characteristics Overvoltage category II Degree of pollution 3 Material specifications Flammability rating according to UL 94 V0 Sealing material FKM Contact material CuZn Contact surface material Ni/Au Contact carrier material PA 6.6 Material for screw connection Nickel-plated brass Electrical properties Rated surge voltage 1.5 kV Contact resistance ≤ 3 mΩ Insulation resistance ≥ 100 MΩ Nominal voltage UN 48 V AC 60 V DC Nominal current IN 4 A (Plug/socket in accordance with IEC 61076-2-101, cable technical data is to be observed) Test voltage 2500 V Transmission medium Copper Connection data Conductor connection Dec 21, 2022, 5:50 PM Page 3 (13) Device connector, rear mounting - SACCBP-M12FSB5CON-M16/2,0-900 1534562 https://www.phoenixcontact.com/us/products/1534562 Connection method Cable connection Type of contact Crimp contacts Tightening torque 2 Nm 3 Nm Connector Connection 1 Head design Flush-type female connector Head cable outlet straight Head thread type M12 Head locking type SPEEDCON Coding B-coded Connection 2 Head design free cable end Cable / line Cable length 2m INTERBUS [900] Dimensional drawing Cable weight 70 kg/km Number of positions 6 Shielded yes Cable type INTERBUS [900] Conductor structure 3 x 2 x 0.22 mm² Signal speed 0.66 c Conductor structure signal line 32x 0.10 mm AWG signal line 24 Conductor cross section 3x 2x 0.22 mm² External cable diameter 8 mm Outer sheath, material PUR External sheath, color may green RAL 6017 Conductor material Bare Cu litz wires Material wire insulation PE Single wire, color Green-yellow, white-brown, gray-pink Dec 21, 2022, 5:50 PM Page 4 (13) Device connector, rear mounting - SACCBP-M12FSB5CON-M16/2,0-900 1534562 https://www.phoenixcontact.com/us/products/1534562 Twisted pairs 2 cores to the pair Overall twist 3 pairs to the core Insulation resistance ≥ 5 GΩ*km Coupling resistance < 250.00 mΩ/m (at 30 MHz) Loop resistance ≤ 159.80 Ω/km Wave impedance 120 Ω ±20 % (at 64 kHz) 100 Ω ±15 % (with 1 MHz) Cable capacity ≤ 60 nF/km (At 800 Hz) Nominal voltage, cable 250 V (Peak value, not for high-power applications) Test voltage Core/Core 1500 Vrms Test voltage Core/Shield 1000 Vrms Minimum bending radius, fixed installation 7.5 x D Minimum bending radius, flexible installation 15 x D Max. bending cycles 5000000 Near end crosstalk attenuation (NEXT) ≥ 61 dB (at 772 kHz) ≥ 59 dB (with 1 MHz) ≥ 55 dB (at 2 МHz) ≥ 50 dB (at 4 МHz) ≥ 46 dB (at 8 МHz) ≥ 44 dB (at 10 MHz) ≥ 41 dB (at 16 MHz) ≥ 40 dB (at 20 МHz) Shield attenuation ≤ 15 dB/km (at 256 kHz) ≤ 24 dB/km (at 772 kHz) ≤ 27 dB/km (with 1 MHz) ≤ 52 dB/km (at 4 МHz) ≤ 84 dB/km (at 10 MHz) ≤ 112 dB/km (at 16 MHz) ≤ 119 dB/km (at 20 МHz) Flame resistance according to VDE 0472, Part 4, test type B according to IEC 60332-1 Ambient temperature (operation) -40 °C ... 80 °C (cable, fixed installation) -30 °C ... 70 °C (Cable, flexible installation) Ambient conditions Degree of protection IP67 (When plugged in) IP65 (When plugged in) Degree of protection IP65/IP67 Ambient temperature (operation) -25 °C ... 85 °C (Plug / socket) -40 °C ... 85 °C (without mechanical actuation) Standards and regulations Dec 21, 2022, 5:50 PM Page 5 (13) Device connector, rear mounting - SACCBP-M12FSB5CON-M16/2,0-900 1534562 https://www.phoenixcontact.com/us/products/1534562 M12 Standards/specifications IEC 61076-2-101 Dec 21, 2022, 5:50 PM Page 6 (13) Device connector, rear mounting - SACCBP-M12FSB5CON-M16/2,0-900 1534562 https://www.phoenixcontact.com/us/products/1534562 Drawings Schematic diagram 3 4 5 2 1 Pin assignment M12 socket, 5-pos., B-coded, female side Dimensional drawing 38,1 30,5 1,5 17 19 M12 M16x1,5 20,5 2,8 M12 flush-type connector Dec 21, 2022, 5:50 PM Page 7 (13) Device connector, rear mounting - SACCBP-M12FSB5CON-M16/2,0-900 1534562 https://www.phoenixcontact.com/us/products/1534562 Dimensional drawing Ø15,9 ⁰,¹ 4,5 13,5 ⁰,¹ Housing cutout for M16 fastening thread, mounting panel with feed-through hole (alternatively with surface as protection against rotation) Dec 21, 2022, 5:50 PM Page 8 (13) Device connector, rear mounting - SACCBP-M12FSB5CON-M16/2,0-900 1534562 https://www.phoenixcontact.com/us/products/1534562 I [A] Diagram 9 8 7 6 5 4 3 2 1 0 1 1 0 2 = 5x0,34mm 10 20 30 40 50 60 70 80 90 100 110 120 130 [°C] I = current strength, T = ambient temperature Circuit diagram 1 YE 2 GN 3 GY 4 PK 5 BN WH Dec 21, 2022, 5:50 PM Page 9 (13) Device connector, rear mounting - SACCBP-M12FSB5CON-M16/2,0-900 1534562 https://www.phoenixcontact.com/us/products/1534562 Approvals EAC  Approval ID: B.01687   cUL Recognized Approval ID: E221474-20220908 Nominal Voltage UN Nominal Current IN Cross Section AWG Cross Section mm2 60 V 1.5 A - - Nominal Voltage UN Nominal Current IN Cross Section AWG Cross Section mm2 60 V 2A - - UL Recognized Approval ID: E221474-20220908 cULus Recognized Dec 21, 2022, 5:50 PM Page 10 (13) Device connector, rear mounting - SACCBP-M12FSB5CON-M16/2,0-900 1534562 https://www.phoenixcontact.com/us/products/1534562 Classifications ECLASS ECLASS-9.0 27440102 ECLASS-10.0.1 27440102 ECLASS-11.0 27440103 ETIM ETIM 8.0 EC003570 UNSPSC UNSPSC 21.0 39121400 Dec 21, 2022, 5:50 PM Page 11 (13) Device connector, rear mounting - SACCBP-M12FSB5CON-M16/2,0-900 1534562 https://www.phoenixcontact.com/us/products/1534562 Environmental Product Compliance REACh SVHC Lead 7439-92-1 China RoHS Environmentally Friendly Use Period = 50 years For information on hazardous substances, refer to the manufacturer’s declaration available under “Downloads” Dec 21, 2022, 5:50 PM Page 12 (13) Device connector, rear mounting - SACCBP-M12FSB5CON-M16/2,0-900 1534562 https://www.phoenixcontact.com/us/products/1534562 Accessories EMV nut EMV nut - SACC-M16-KD-NUT-SH - 1440164 https://www.phoenixcontact.com/us/products/1440164 EMV nut, Threads, M16 x 1.5 item no.: 1239703 Phoenix Contact 2022 © - all rights reserved https://www.phoenixcontact.com Phoenix Contact USA 586 Fulling Mill Road Middletown, PA 17057, United States (+717) 944-1300 info@phoenixcon.com Dec 21, 2022, 5:50 PM Page 13 (13)