https://www.phoenixcontact.com/gb/products/1629121
Coupler connector - M23-09P1N8A9004S - 1629121
Please be informed that the data shown in this PDF Document is generated from our Online Catalog. Please find the complete data in the user's
documentation. Our General Terms of Use for Downloads are valid
(http://phoenixcontact.com/download)
Coupler connector, M23 PRO, straight, shielded: yes, for standard and ONECLICK fast locking system, M23,
No. of pos.: 8+1, Direction of rotation: Standard, type of contact: Pin, Crimp, cable diameter range: 9 mm ... 15
mm, coding:N
Your advantages
Solutions with cross-manufacturer compatibility for standard and fast locking systems
Modern, consistent design for highly convenient operation
Easy, cost-effective cable assembly: uniform shielding of M17 to M40
Key Commercial Data
Packing unit
1 pc
GTIN
GTIN
4055626762685
Weight per Piece (excluding packing)
120.600 g
Custom tariff number
85366990
Sales Key
ABRBHI
Technical data
Temperature range
Ambient temperature
-40 °C ... 105 °C (see to derating)
max. operating temperature
125 °C (DIN EN 60512-9-2 / 1000 h)
Standards and Regulations
Safety note
WARNING: The connectors may not be plugged in or disconnected
under load. Ignoring the warning or improper use may damage persons
and/or property.
• WARNING: Commission properly functioning products only. The
products must be regularly inspected for damage. Decommission
defective products immediately. Replace damaged products. Repairs
are not possible.
• WARNING: Only electrically qualified personnel may install and
operate the product. They must observe the following safety notes.
01/18/2022 Page 1 / 8
https://www.phoenixcontact.com/gb/products/1629121
Coupler connector - M23-09P1N8A9004S - 1629121
Technical data
Standards and Regulations
The qualified personnel must be familiar with the basics of electrical
engineering. They must be able to recognize and prevent danger. The
relevant symbol on the packaging indicates that only personnel familiar
with electrical engineering are allowed to install and operate the product.
• The products are suitable for applications in plant, controller, and
electrical device engineering.
• When operating the connectors in outdoor applications, they must be
separately protected against environmental influences.
• Assembled products may not be manipulated or improperly opened.
• Only use mating connectors that are specified in the technical data
of the standards listed (e.g. the ones listed in the product accessories
online at phoenixcontact.com/products).
• When using the product in direct connection with third-party
manufacturers, the user is responsible.
• For operating voltages > 50 V AC, conductive connector housings must
be grounded
• Ensure that the protective or functional ground has been properly
connected.
• VDE 0100/1.97 § 411.1.3.2 and DIN EN 60 204/11.98 § 14.1.3 are
applicable when combining several circuits in a cable and/or connector
• Only use tools recommended by Phoenix Contact
• The installation notes/Design In documents online on the download
page at phoenixcontact.com/products must be observed for this product.
• Operate the connector only when it is fully plugged in and interlocked.
• Ensure that when laying the cable, the tensile load on the connectors
does not exceed the upper limit specified in the standards.
• Observe the minimum bending radius of the cable. Lay the cable
without twisting it.
• The connector warms up in normal operation. Depending on the
ambient conditions, the surface of the connector can continue to warm
up. In this case, the user is responsible for posting warnings (e.g. DIN
EN ISO 13732-1:2008-12).
Data of the insulating body
Note
Order information: Order crimp contacts 8 x Ø 1 mm, 1 x Ø 2 mm
separately
Coding
N
Insulator material
PA 6.6
Contact connection method
Crimp
Type of contacts
Pin
Application
Signal
Number of positions
9
Direction of rotation
Standard
Contact diameter of power contacts
2 mm
Litz wire cross section of power contacts min.
0.5 mm²
Litz wire cross section of power contacts max.
2.5 mm²
Rated current for power contacts
20 A
01/18/2022 Page 2 / 8
https://www.phoenixcontact.com/gb/products/1629121
Coupler connector - M23-09P1N8A9004S - 1629121
Technical data
Data of the insulating body
Note
for max. connection cross section
Rated voltage
300 V
Rated surge voltage
2.5 kV
Overvoltage category
II
Degree of pollution
3
Contact diameter of signal contacts
1 mm
Litz wire cross section of signal contacts min.
0.08 mm²
Litz wire cross section of signal contacts max.
1 mm²
Nominal current per signal contact
8A
Note
for max. connection cross section
Rated voltage of signal contact
300 V
Rated surge voltage
2.5 kV
Overvoltage category
II
Degree of pollution
3
Note
for max. connection cross section
Installation height
2000 m
Housing data
Housing material
GD-Zn
Type of locking
for standard and ONECLICK fast locking system
Degree of protection (when plugged in)
IP66 / IP68 (2 m / 24 h)
Thread type
M23
Cable seal data
Cable diameter
9 mm ... 15 mm
Sealing material
FKM
Environmental Product Compliance
China RoHS
Environmentally friendly use period: unlimited = EFUP-e
No hazardous substances above threshold values
Drawings
Diagram
I [A]
Schematic diagram
15
N
PO
5
1
2
9
6
10
1
8
7
3
5
4
0
1
0
2
= 9 x 1,0 mm
10 20 30 40 50 60 70 80 90 100 110 120 130
[°C]
I = current strength, ϑ = ambient temperature, 9x 8 A
01/18/2022 Page 3 / 8
https://www.phoenixcontact.com/gb/products/1629121
Coupler connector - M23-09P1N8A9004S - 1629121
Dimensional drawing
Ø 27,4
M23x1
60
Dimensional drawing
Classifications
eCl@ss
eCl@ss 10.0.1
27440102
eCl@ss 11.0
27440102
eCl@ss 9.0
27440102
ETIM
ETIM 7.0
EC002635
UNSPSC
UNSPSC 18.0
39121413
UNSPSC 19.0
39121413
UNSPSC 20.0
39121413
UNSPSC 21.0
39121413
Approvals
Approvals
Approvals
UL Recognized / cUL Recognized / cULus Recognized
Ex Approvals
Approval details
UL Recognized
http://database.ul.com/cgi-bin/XYV/template/LISEXT/1FRAME/index.htm E335019-20141210
Nominal voltage UN
300 V
Nominal current IN
6A
01/18/2022 Page 4 / 8
https://www.phoenixcontact.com/gb/products/1629121
Coupler connector - M23-09P1N8A9004S - 1629121
Approvals
mm²/AWG/kcmil
20
cUL Recognized
http://database.ul.com/cgi-bin/XYV/template/LISEXT/1FRAME/index.htm E335019-20141210
Nominal voltage UN
300 V
Nominal current IN
4A
mm²/AWG/kcmil
20
cULus Recognized
Accessories
Accessories
Crimp contact
Crimp contact - RC-11P2000 - 1596770
Crimp contact, turned, Single contact, contact diameter: 1 mm, crimp range: 0.08 mm² ... 0.22 mm²
Crimp contact - RC-12P2000 - 1597862
Crimp contact
Crimp contact - RC-1KP2000 - 1602996
Crimp contact
01/18/2022 Page 5 / 8
https://www.phoenixcontact.com/gb/products/1629121
Coupler connector - M23-09P1N8A9004S - 1629121
Accessories
Crimp contact - RC-22P2000 - 1603321
Crimp contact, rolled, Single contact, contact diameter: 1 mm, crimp range: 0.22 mm² ... 0.56 mm², Single contact
Crimp contact - RC-22P2300 - 1603324
Crimp contact, rolled, Taped articles, number of pieces per reel: 500, contact diameter: 1 mm, crimp range: 0.22
mm² ... 0.56 mm²
Crimp contact - RC-22P2400 - 1603325
Crimp contact, rolled, number of pieces per reel: 10000, contact diameter: 1 mm, crimp range: 0.22 mm² ... 0.56 mm²
Crimp contact - RC-21P2000 - 1603310
Crimp contact, rolled, Single contact, contact diameter: 1 mm, crimp range: 0.08 mm² ... 0.22 mm², Single contact
Crimp contact - RC-21P2300 - 1603313
Crimp contact, rolled, Taped articles, number of pieces per reel: 500, contact diameter: 1 mm, crimp range: 0.08
mm² ... 0.22 mm²
01/18/2022 Page 6 / 8
https://www.phoenixcontact.com/gb/products/1629121
Coupler connector - M23-09P1N8A9004S - 1629121
Accessories
Crimp contact - RC-21P2400 - 1611637
Crimp contact, rolled, number of pieces per reel: 10000, contact diameter: 1 mm, crimp range: 0.08 mm² ... 0.22 mm²
Crimp contact - RC-5SP2000 - 1603529
Crimp contact, turned, contact diameter: 2 mm, crimp range: 0.5 mm² ... 0.75 mm²
Crimp contact - RC-59P2000 - 1603498
Crimp contact
Crimp contact - RC-5CP2000 - 1603513
Crimp contact, turned, contact diameter: 2 mm, crimp range: 1 mm² ... 1.5 mm²
Crimp contact - RC-5AP2000 - 1603505
Crimp contact, turned, contact diameter: 2 mm, crimp range: 1.5 mm² ... 2.5 mm²
Protective cover
01/18/2022 Page 7 / 8
https://www.phoenixcontact.com/gb/products/1629121
Coupler connector - M23-09P1N8A9004S - 1629121
Accessories
Protective cap - RC-Z2059 - 1604225
Plastic protection cap for connectors with M23 external thread
Metal protective cap - RC-Z2104 - 1604260
Metal protection cap for signal connectors with M23 external thread
Phoenix Contact 2022 © - all rights reserved
http://www.phoenixcontact.com
01/18/2022 Page 8 / 8
