1629176

https://www.phoenixcontact.com/us/products/1629176 Cable connector - M23-07P1N8A80DUS - 1629176 Please be informed that the data shown in this PDF Document is generated from our Online Catalog. Please find the complete data in the user's documentation. Our General Terms of Use for Downloads are valid (http://phoenixcontact.com/download) Cable connector, M23 PRO, straight, shielded: yes, ONECLICK fast locking system, M23, No. of pos.: 7, type of contact: Pin, Crimp connection, cable diameter range: 3 mm ... 15 mm, coding:N Your advantages  Solutions with cross-manufacturer compatibility for standard and fast locking systems  ONECLICK fast locking system with an optically, haptically, and acoustically clear locking position  Reliable under the harshest conditions: cable connectors with vibration brake  Modern, consistent design for highly convenient operation  Easy, cost-effective cable assembly: uniform shielding of M17 to M40 Key Commercial Data Packing unit 1 pc GTIN GTIN 4055626618098 Weight per Piece (excluding packing) 100.000 g Custom tariff number 85366990 Country of origin Germany Technical data Temperature range Temperature range -40 °C ... 125 °C Standards and Regulations Safety note WARNING: The connectors may not be plugged in or disconnected under load. Ignoring the warning or improper use may damage persons and/or property. 03/28/2021   Page 1 / 7 https://www.phoenixcontact.com/us/products/1629176 Cable connector - M23-07P1N8A80DUS - 1629176 Technical data Standards and Regulations • WARNING: Commission properly functioning products only. The products must be regularly inspected for damage. Decommission defective products immediately. Replace damaged products. Repairs are not possible. • WARNING: Only electrically qualified personnel may install and operate the product. They must observe the following safety notes. The qualified personnel must be familiar with the basics of electrical engineering. They must be able to recognize and prevent danger. The relevant symbol on the packaging indicates that only personnel familiar with electrical engineering are allowed to install and operate the product. • The products are suitable for applications in plant, controller, and electrical device engineering. • When operating the connectors in outdoor applications, they must be separately protected against environmental influences. • Assembled products may not be manipulated or improperly opened. • Only use mating connectors that are specified in the technical data of the standards listed (e.g. the ones listed in the product accessories online at phoenixcontact.com/products). • When using the product in direct connection with third-party manufacturers, the user is responsible. • For operating voltages > 50 V AC, conductive connector housings must be grounded • Ensure that the protective or functional ground has been properly connected. • VDE 0100/1.97 § 411.1.3.2 and DIN EN 60 204/11.98 § 14.1.3 are applicable when combining several circuits in a cable and/or connector • Only use tools recommended by Phoenix Contact • The installation notes/Design In documents online on the download page at phoenixcontact.com/products must be observed for this product. • Operate the connector only when it is fully plugged in and interlocked. • Ensure that when laying the cable, the tensile load on the connectors does not exceed the upper limit specified in the standards. • Observe the minimum bending radius of the cable. Lay the cable without twisting it. • The connector warms up in normal operation. Depending on the ambient conditions, the surface of the connector can continue to warm up. In this case, the user is responsible for posting warnings (e.g. DIN EN ISO 13732-1:2008-12). Data of the insulating body Note Order information: Order 7 x Ø 2 mm crimp contacts separately Coding N Insulator material PA 6.6 Contact connection method Crimp connection Type of contacts Pin Application Signal 03/28/2021   Page 2 / 7 https://www.phoenixcontact.com/us/products/1629176 Cable connector - M23-07P1N8A80DUS - 1629176 Technical data Data of the insulating body Number of positions 7 Direction of rotation Standard Contact diameter of signal contacts 2 mm Litz wire cross section of signal contacts min. 0.5 mm² Litz wire cross section of signal contacts max. 2.5 mm² Nominal current per signal contact 20 A Note for max. connection cross section Rated voltage of signal contact 300 V Rated surge voltage 2.5 kV Overvoltage category II Degree of pollution 3 Note for max. connection cross section Installation height 2000 m Housing data Housing material GD-Zn Type of locking ONECLICK fast locking system Degree of protection (when plugged in) IP66 / IP68 (2 m / 24 h) Thread type M23 Cable seal data Cable diameter 3 mm ... 15 mm (Universal gasket) Sealing material FKM Environmental Product Compliance China RoHS Environmentally friendly use period: unlimited = EFUP-e No hazardous substances above threshold values Drawings 03/28/2021   Page 3 / 7 https://www.phoenixcontact.com/us/products/1629176 Cable connector - M23-07P1N8A80DUS - 1629176 Schematic diagram Dimensional drawing N 60,8 6 7 5 3 Ø27,4 2 PO Ø27,4 1 4 Technical drawings can be found under Downloads I [A] Diagram 30 25 20 1 15 10 5 1 2 = 7 x 2,5 mm 0 0 10 20 30 40 50 60 70 80 90 100 110 120 130  [°C] I = current strength, ϑ = ambient temperature, 7x 20 A Classifications eCl@ss eCl@ss 10.0.1 27440102 eCl@ss 11.0 27440102 eCl@ss 9.0 27440102 ETIM ETIM 6.0 EC002061 Approvals Approvals Approvals UL Recognized / cUL Recognized / cULus Recognized Ex Approvals 03/28/2021   Page 4 / 7 https://www.phoenixcontact.com/us/products/1629176 Cable connector - M23-07P1N8A80DUS - 1629176 Approvals Approval details UL Recognized    http://database.ul.com/cgi-bin/XYV/template/LISEXT/1FRAME/index.htm     Nominal voltage UN 300 V Nominal current IN 17 A mm²/AWG/kcmil 14 cUL Recognized    http://database.ul.com/cgi-bin/XYV/template/LISEXT/1FRAME/index.htm     Nominal voltage UN 300 V Nominal current IN 10 A mm²/AWG/kcmil 14 cULus Recognized      E335019-20141210  E335019-20141210   Accessories Accessories Circular connectors (device side) Hook wrench - SF-Z0027 - 1607455 Hook wrench     Crimp contact 03/28/2021   Page 5 / 7 https://www.phoenixcontact.com/us/products/1629176 Cable connector - M23-07P1N8A80DUS - 1629176 Accessories Crimp contact - RC-5SP2000 - 1603529 Crimp contact, turned, contact diameter: 2 mm, crimp range: 0.5 mm² ... 0.75 mm²     Crimp contact - RC-59P2000 - 1603498 Crimp contact, turned, contact diameter: 2 mm, crimp range: 0.75 mm² ... 1 mm²     Crimp contact - RC-5CP2000 - 1603513 Crimp contact, turned, contact diameter: 2 mm, crimp range: 1 mm² ... 1.5 mm²     Crimp contact - RC-5AP2000 - 1603505 Crimp contact, turned, contact diameter: 2 mm, crimp range: 1.5 mm² ... 2.5 mm²     Mounting material Torque screwdriver - SF-Z0028 - 1607456 Torque screwdriver     03/28/2021   Page 6 / 7 https://www.phoenixcontact.com/us/products/1629176 Cable connector - M23-07P1N8A80DUS - 1629176 Accessories Special wrench - RF-Z0007 - 1614347 Special wrench     Phoenix Contact 2021 © - all rights reserved http://www.phoenixcontact.com 03/28/2021   Page 7 / 7