1855319

Panel-mount flange - VC-D-AF 1855319 https://www.phoenixcontact.com/us/products/1855319 Please be informed that the data shown in this PDF document is generated from our Online Catalog. Please find the complete data in the user documentation. Our General Terms of Use for Downloads are valid. Panel mounting flange for screw locking, for fixing the crimp contact insert to the housing panel, with two M3 threaded holes and one M4 threaded hole Commercial Data Item number 1855319 Packing unit 1 pc Minimum order quantity 20 pc Note Made to Order (non-returnable) Sales Key A16 Product Key ABLAZE Catalog Page Page 38 (C-2-2013) GTIN 4017918159306 Weight per Piece (including packing) 4.325 g Weight per Piece (excluding packing) 3.3 g Customs tariff number 85389099 Country of origin PL Dec 9, 2022, 3:17 PM Page 1 (7) Panel-mount flange - VC-D-AF 1855319 https://www.phoenixcontact.com/us/products/1855319 Technical Data Notes General 2 for every connector Safety note Safety note WARNING: The connectors may not be plugged in or disconnected under load. Ignoring the warning or improper use may damage persons and/or property. • WARNING: Commission properly functioning products only. The products must be regularly inspected for damage. Decommission defective products immediately. Replace damaged products. Repairs are not possible. • WARNING: Only electrically qualified personnel may install and operate the product. They must observe the following safety notes. The qualified personnel must be familiar with the basics of electrical engineering. They must be able to recognize and prevent danger. The relevant symbol on the packaging indicates that only personnel familiar with electrical engineering are allowed to install and operate the product. • The products are suitable for applications in plant, controller, and electrical device engineering. • When operating the connectors in outdoor applications, they must be separately protected against environmental influences. • Assembled products may not be manipulated or improperly opened. • Only use mating connectors that are specified in the technical data of the standards listed (e.g. the ones listed in the product accessories online at phoenixcontact.com/products). • When using the product in direct connection with third-party manufacturers, the user is responsible. • For operating voltages > 50 V AC, conductive connector housings must be grounded • Ensure that the protective or functional ground has been properly connected. • VDE 0100/1.97 § 411.1.3.2 and DIN EN 60 204/11.98 § 14.1.3 are applicable when combining several circuits in a cable and/or connector • Observe the corresponding technical data. You will find information: o On the product o On the packing label o In the supplied documentation o Online at phoenixcontact.com/products under the product • Only use tools recommended by Phoenix Contact • The installation notes/Design In documents online on the download page at phoenixcontact.com/products must be observed for this product. • Use a protective cap to protect connectors that are not in use. The suitable accessories are available online in the accessory section of the product at phoenixcontact.com/products • Operate the connector only when it is fully plugged in. Dec 9, 2022, 3:17 PM Page 2 (7) Panel-mount flange - VC-D-AF 1855319 https://www.phoenixcontact.com/us/products/1855319 • Ensure that when laying the cable, the tensile load on the connectors does not exceed the upper limit specified in the standards. • Observe the minimum bending radius of the cable. Lay the cable without twisting it. • The connector warms up in normal operation. Depending on the ambient conditions, the surface of the connector can continue to warm up. In this case, the user is responsible for posting warnings (e.g. DIN EN ISO 13732-1:2008-12). Product properties Product type Panel-mount flange Locking type Screw locking Dimensions Dimensional drawing Width 30 mm Height 10 mm Length 2 mm Material specifications Material SteelNickel Material for screw connection Steel, galvanized Mechanical properties Mechanical data Locking type Nut Dec 9, 2022, 3:17 PM Page 3 (7) Panel-mount flange - VC-D-AF 1855319 https://www.phoenixcontact.com/us/products/1855319 Drawings Dimensional drawing 30 20 M3 2 10 6,4 M4 Dec 9, 2022, 3:17 PM Page 4 (7) Panel-mount flange - VC-D-AF 1855319 https://www.phoenixcontact.com/us/products/1855319 Approvals  EAC Approval ID: B.01687 Dec 9, 2022, 3:17 PM Page 5 (7) Panel-mount flange - VC-D-AF 1855319 https://www.phoenixcontact.com/us/products/1855319 Classifications ECLASS ECLASS-9.0 27440210 ECLASS-10.0.1 27440210 ECLASS-11.0 27440210 ETIM ETIM 8.0 EC002310 UNSPSC UNSPSC 21.0 39121400 Dec 9, 2022, 3:17 PM Page 6 (7) Panel-mount flange - VC-D-AF 1855319 https://www.phoenixcontact.com/us/products/1855319 Environmental Product Compliance China RoHS Environmentally friendly use period: unlimited = EFUP-e No hazardous substances above threshold values Phoenix Contact 2022 © - all rights reserved https://www.phoenixcontact.com Phoenix Contact USA 586 Fulling Mill Road Middletown, PA 17057, United States (+717) 944-1300 info@phoenixcon.com Dec 9, 2022, 3:17 PM Page 7 (7)