1886757

https://www.phoenixcontact.com/us/products/1886757 Protective covers - VC-SD-T4 - 1886757 Please be informed that the data shown in this PDF Document is generated from our Online Catalog. Please find the complete data in the user's documentation. Our General Terms of Use for Downloads are valid (http://phoenixcontact.com/download) VARIOCON protective cover for sleeve housing, with IP50 protection, type 4, max. tightening torque: 1.6 Nm Your advantages  Easy mounting  Contact inserts are protected when not plugged in Key Commercial Data Packing unit 1 pc Minimum order quantity 5 pc GTIN GTIN 4017918908447 Weight per Piece (excluding packing) 23.340 g Custom tariff number 39269097 Country of origin Poland Technical data Dimensions Length 104 mm Width 33 mm Height 22.9 mm Ambient conditions Degree of protection IP65 Ambient temperature (operation) -40 °C ... 80 °C 12/17/2019   Page 1 / 5 https://www.phoenixcontact.com/us/products/1886757 Protective covers - VC-SD-T4 - 1886757 Technical data General Size VC4 Type For sleeve housing Material PA Flammability rating according to UL 94 V0 Seal present no Assembly instructions Tightening torque 1.6 Nm Mounting type Screw locking Standards and Regulations Flammability rating according to UL 94 V0 Safety note WARNING: The connectors may not be plugged in or disconnected under load. Ignoring the warning or improper use may damage persons and/or property. • WARNING: Commission properly functioning products only. The products must be regularly inspected for damage. Decommission defective products immediately. Replace damaged products. Repairs are not possible. • WARNING: Only electrically qualified personnel may install and operate the product. They must observe the following safety notes. The qualified personnel must be familiar with the basics of electrical engineering. They must be able to recognize and prevent danger. The relevant symbol on the packaging indicates that only personnel familiar with electrical engineering are allowed to install and operate the product. • The products are suitable for applications in plant, controller, and electrical device engineering. • When operating the connectors in outdoor applications, they must be separately protected against environmental influences. • Assembled products may not be manipulated or improperly opened. • Only use mating connectors that are specified in the technical data of the standards listed (e.g. the ones listed in the product accessories online at phoenixcontact.com/products). • When using the product in direct connection with third-party manufacturers, the user is responsible. • For operating voltages > 50 V AC, conductive connector housings must be grounded • Ensure that the protective or functional ground has been properly connected. • VDE 0100/1.97 § 411.1.3.2 and DIN EN 60 204/11.98 § 14.1.3 are applicable when combining several circuits in a cable and/or connector • Observe the corresponding technical data. You will find information: o On the product o On the packing label o In the supplied documentation o Online at phoenixcontact.com/products under the product • Only use tools recommended by Phoenix Contact 12/17/2019   Page 2 / 5 https://www.phoenixcontact.com/us/products/1886757 Protective covers - VC-SD-T4 - 1886757 Technical data Standards and Regulations • The installation notes/Design In documents online on the download page at phoenixcontact.com/products must be observed for this product. • Use a protective cap to protect connectors that are not in use. The suitable accessories are available online in the accessory section of the product at phoenixcontact.com/products • Operate the connector only when it is fully plugged in. • Ensure that when laying the cable, the tensile load on the connectors does not exceed the upper limit specified in the standards. • Observe the minimum bending radius of the cable. Lay the cable without twisting it. Environmental Product Compliance China RoHS Environmentally friendly use period: unlimited = EFUP-e No hazardous substances above threshold values Drawings Dimensional drawing Classifications eCl@ss eCl@ss 4.0 27141200 12/17/2019   Page 3 / 5 https://www.phoenixcontact.com/us/products/1886757 Protective covers - VC-SD-T4 - 1886757 Classifications eCl@ss eCl@ss 4.1 27141200 eCl@ss 5.0 27142100 eCl@ss 5.1 27142100 eCl@ss 6.0 27261200 eCl@ss 7.0 27440208 eCl@ss 8.0 27440208 eCl@ss 9.0 27440208 ETIM ETIM 2.0 EC000241 ETIM 3.0 EC002040 ETIM 4.0 EC002040 ETIM 5.0 EC002314 ETIM 6.0 EC002314 ETIM 7.0 EC002314 UNSPSC UNSPSC 6.01 30212113 UNSPSC 7.0901 39121712 UNSPSC 11 39121712 UNSPSC 12.01 39121712 UNSPSC 13.2 39121421 UNSPSC 18.0 39121421 UNSPSC 19.0 39121421 UNSPSC 20.0 39121421 UNSPSC 21.0 39121421 Approvals Approvals Approvals EAC Ex Approvals Approval details 12/17/2019   Page 4 / 5 https://www.phoenixcontact.com/us/products/1886757 Protective covers - VC-SD-T4 - 1886757 Approvals EAC      B.01742 Phoenix Contact 2019 © - all rights reserved http://www.phoenixcontact.com 12/17/2019   Page 5 / 5