2702131

https://www.phoenixcontact.com/us/products/2702131 Bus coupler - IL EIP BK DI8 DO4 2TX-XC-PAC - 2702131 Please be informed that the data shown in this PDF Document is generated from our Online Catalog. Please find the complete data in the user's documentation. Our General Terms of Use for Downloads are valid (http://phoenixcontact.com/download) Inline XC, Bus coupler, EtherNet/IP™, RJ45 jack, Digital inputs: 8, 24 V DC, connection method: 3-wire, Digital outputs: 4, 24 V DC, 500 mA, connection method: 3-wire, Extreme conditions version, transmission speed in the local bus: 500 kbps / 2 Mbps, degree of protection: IP20, including Inline connectors and marking fields Product Description The bus coupler with integrated I/Os is intended for use within an EtherNet/IP™ network and represents the link to the Inline I/O system. Up to 61 Inline devices can be connected to the bus coupler. The bus coupler supports a maximum of 8 PCP devices. A corresponding EDS file is available for integrating the Inline station into the programming system. This file can be downloaded via the product at phoenixcontact.net/products. Your advantages  Eight digital inputs, four digital outputs (on-board)  EtherNet/IP™, Version 1.2  Web-based management  2 RJ45 connections  Automatic detection of the transmission speed in the local bus (500 kbps or 2 Mbps)  Can be used under extreme ambient conditions  Extended temperature range of -40 °C ... +70 °C (see “Tested successfully: use under extreme ambient conditions” in the data sheet)  Coated PCBs Key Commercial Data Packing unit 1 pc GTIN GTIN 4046356981071 Weight per Piece (excluding packing) 270.000 g Custom tariff number 85389091 Country of origin Germany 06/27/2020   Page 1 / 11 https://www.phoenixcontact.com/us/products/2702131 Bus coupler - IL EIP BK DI8 DO4 2TX-XC-PAC - 2702131 Technical data Dimensions Width 80 mm Height 119.8 mm Depth 71.5 mm Note on dimensions Specfications with connectors Ambient conditions Ambient temperature (operation) -25 °C ... 60 °C (Standard) -40 °C ... 70 °C (Extended, see section “Tested successfully: use under extreme ambient conditions” in the data sheet.) Ambient temperature (storage/transport) -40 °C ... 85 °C Permissible humidity (operation) 10 % ... 95 % (non-condensing) Permissible humidity (storage/transport) 10 % ... 95 % (non-condensing) Air pressure (operation) 70 kPa ... 106 kPa (up to 3000 m above sea level) Air pressure (storage/transport) 70 kPa ... 106 kPa (up to 3000 m above sea level) Degree of protection IP20 Connection data Designation Inline connector Connection method Spring-cage connection Conductor cross section solid min. 0.08 mm² Conductor cross section solid max. 1.5 mm² Conductor cross section flexible min. 0.08 mm² Conductor cross section flexible max. 1.5 mm² Conductor cross section AWG min. 28 Conductor cross section AWG max. 16 Stripping length 8 mm General Mounting type DIN rail Color green Net weight 329 g Note on weight specifications with connectors Diagnostics messages Short-circuit or overload of the digital outputs Yes Sensor supply failure Yes Failure of the actuator supply Yes System limits of the bus coupler Designation System limits of the bus coupler Amount of process data max. 512 Byte (per station) 06/27/2020   Page 2 / 11 https://www.phoenixcontact.com/us/products/2702131 Bus coupler - IL EIP BK DI8 DO4 2TX-XC-PAC - 2702131 Technical data System limits of the bus coupler Number of supported devices max. 63 (per station) Number of local bus devices that can be connected max. 61 (The on-board I/Os are two devices) Number of devices with parameter channel max. 8 Number of supported branch terminals with remote bus branch 0 Inline potentials Designation Bus coupler supply UBC; Communications power UL (7.5 V) and the analog supply UANA (24 V) are generated from the bus coupler supply. Supply voltage 24 V DC (via Inline connector) Supply voltage range 19.2 V DC ... 30 V DC (including all tolerances, including ripple) Current consumption 80 mA (without connected I/O terminal blocks) max. 0.98 A Designation Communications power (UL) Supply voltage 7.5 V DC Power supply unit max. 0.8 A DC Designation Supply of analog modules (UANA) Supply voltage 24 V DC Supply voltage range 19.2 V DC ... 30 V DC (including all tolerances, including ripple) Power supply unit max. 0.5 A DC Designation Main circuit supply (UM) Supply voltage 24 V DC (via Inline connector) Supply voltage range 19.2 V DC ... 30 V DC (including all tolerances, including ripple) Power supply unit max. 8 A DC (sum of UM + US) Current consumption 3 mA (without sensors) max. 8 A DC Designation Segment circuit supply (US) Supply voltage 24 V DC (via Inline connector) Supply voltage range 19.2 V DC ... 30 V DC (including all tolerances, including ripple) Power supply unit max. 8 A DC (sum of UM + US) Current consumption max. 8 A DC Type of protection Short-circuit protection of the communications power Short-circuit protection of the analog supply Power consumption typ. 3 W (entire device) Current consumption 6 mA (without connected peripherals) Digital inputs Input name Digital inputs Description of the input EN 61131-2 type 1 06/27/2020   Page 3 / 11 https://www.phoenixcontact.com/us/products/2702131 Bus coupler - IL EIP BK DI8 DO4 2TX-XC-PAC - 2702131 Technical data Digital inputs Connection method Inline connector Connection technology 3-wire Number of inputs 8 Typical response time approx. 500 µs Protective circuit Reverse polarity protection Suppressor diode Nominal input voltage UIN 24 V DC Nominal input current at UIN typ. 3 mA Input voltage 24 V DC Input voltage range "0" signal -30 V DC ... 5 V DC Input voltage range "1" signal 15 V DC ... 30 V DC Typical input current per channel typ. 3 mA Delay at signal change from 0 to 1 1.2 ms Delay at signal change from 1 to 0 1.2 ms Digital outputs Output name Digital outputs Connection method Inline connector Connection technology 3-wire Number of outputs 4 Protective circuit Short-circuit and overload protection Freewheeling circuit in the output driver Output voltage 24 V DC -1 V (At nominal current) Nominal output voltage 24 V DC Maximum output current per channel 500 mA Maximum output current per module / terminal block 2A Maximum output current per module 2A Nominal load, inductive 12 VA (1.2 H, 48 Ω) Nominal load, lamp 12 W Nominal load, ohmic 12 W Limitation of the voltage induced on circuit interruption approx. -30 V Output current when switched off max. 10 µA (When not loaded, a voltage can be measured even at an output that is not set.) Behavior with overload Auto restart Behavior with inductive overload Output can be destroyed Reverse voltage resistance to short pulses Reverse voltage proof Standards and Regulations Mechanical tests Vibration resistance in acc. with EN 60068-2-6/IEC 60068-2-6 5g 06/27/2020   Page 4 / 11 https://www.phoenixcontact.com/us/products/2702131 Bus coupler - IL EIP BK DI8 DO4 2TX-XC-PAC - 2702131 Technical data Standards and Regulations Shock in acc. with EN 60068-2-27/IEC 60068-2-27 Operation: 25g, 11 ms duration, semi-sinusoidal shock impulse Protection class III (IEC 61140, EN 61140, VDE 0140-1) Environmental Product Compliance REACh SVHC Lead 7439-92-1 China RoHS Environmentally friendly use period: unlimited = EFUP-e No hazardous substances above threshold values Drawings Dimensional drawing 06/27/2020   Page 5 / 11 https://www.phoenixcontact.com/us/products/2702131 Bus coupler - IL EIP BK DI8 DO4 2TX-XC-PAC - 2702131 Dimensional drawing 06/27/2020   Page 6 / 11 https://www.phoenixcontact.com/us/products/2702131 Bus coupler - IL EIP BK DI8 DO4 2TX-XC-PAC - 2702131 Connection diagram 06/27/2020   Page 7 / 11 https://www.phoenixcontact.com/us/products/2702131 Bus coupler - IL EIP BK DI8 DO4 2TX-XC-PAC - 2702131 Classifications eCl@ss eCl@ss 5.1 27242600 eCl@ss 6.0 27242600 eCl@ss 7.0 27242608 eCl@ss 8.0 27242608 eCl@ss 9.0 27242608 ETIM ETIM 5.0 EC001604 ETIM 6.0 EC001604 ETIM 7.0 EC001604 UNSPSC UNSPSC 13.2 32151602 UNSPSC 19.0 32151602 Accessories Accessories Connector set Connector set - IL BKDIO-PLSET - 2878599 Connector set, for Inline bus coupler with I/Os mounted in rows     Data cable by the meter Network cable - FL CAT5 HEAVY - 2744814 CAT5-SF/UTP cable (J-02YS(ST)C HP 2 x 2 x 24 AWG), heavy-duty installation cable, 2 x 2 x 0.22 mm², solid conductor, shielded, outer sheath: 7.8 mm diameter, inner sheath: 5.75 mm ± 0.15 mm diameter     06/27/2020   Page 8 / 11 https://www.phoenixcontact.com/us/products/2702131 Bus coupler - IL EIP BK DI8 DO4 2TX-XC-PAC - 2702131 Accessories Network cable - FL CAT5 FLEX - 2744830 CAT5-SF/UTP cable (J-LI02YS(ST)C H 2 x 2 x 26 AWG), light-duty, flexible installation cable 2 x 2 x 0.14 mm², stranded, shielded, outer sheath: 5.75 mm ± 0.15 mm diameter     End block End clamp - CLIPFIX 35 - 3022218 Quick mounting end clamp for NS 35/7,5 DIN rail or NS 35/15 DIN rail, with marking option, width: 9.5 mm, color: gray     End clamp - E/UK - 1201442 End clamp, width: 9.5 mm, height: 35.3 mm, material: PA, length: 50.5 mm, Mounting on a DIN rail NS 32 or NS 35, color: gray     Labeling panel Labeling field - IB IL FIELD 8 - 2727515 Labeling field, width: 48.8 mm     Labeling field - IB IL FIELD 2 - 2727501 Labeling field, width: 12.2 mm     06/27/2020   Page 9 / 11 https://www.phoenixcontact.com/us/products/2702131 Bus coupler - IL EIP BK DI8 DO4 2TX-XC-PAC - 2702131 Accessories Plug RJ45 connector - FL PLUG RJ45 GR/2 - 2744856 RJ45 connector, shielded, with bend protection sleeve, 2 pieces, gray for straight cables, for assembly on site. For connections that are not crossed, it is recommended that you use the connector set with gray bend protection sleeve.     RJ45 connector - FL PLUG RJ45 GN/2 - 2744571 RJ45 connector, shielded, with bend protection sleeve, 2 pieces, green for crossed cables, for assembly on site. For connections that are crossed, it is recommended that the connector set with green bend protection sleeves is used.     Terminal marking Insert strip - ESL 62X46 - 0809502 Insert strip, Sheet, white, unlabeled, can be labeled with: Office printing systems: Laser printer, mounting type: insert, lettering field size: 62 x 46 mm, Number of individual labels: 120     Insert strip - ESL 62X10 - 0809492 Insert strip, Sheet, white, unlabeled, can be labeled with: Office printing systems: Laser printer, mounting type: insert, lettering field size: 62 x 10 mm, Number of individual labels: 72     06/27/2020   Page 10 / 11 https://www.phoenixcontact.com/us/products/2702131 Bus coupler - IL EIP BK DI8 DO4 2TX-XC-PAC - 2702131 Accessories Assembly tool - FL CRIMPTOOL - 2744869 Crimping pliers, for assembling the RJ45 plugs FL PLUG RJ45..., for assembly on site     Software - IPASSIGN - 2701094 IPAssign is an easy to use tool for setting the IP address of devices which rely on BOOTP. No installation or administrative rights are required to use IPAssign. This product is free and only available from the "Downloads" tab.     Phoenix Contact 2020 © - all rights reserved http://www.phoenixcontact.com 06/27/2020   Page 11 / 11