2736110

https://www.phoenixcontact.com/us/products/2736110 Distributed I/O device - FLS PB M12 DO 8 M12-2A - 2736110 Please be informed that the data shown in this PDF Document is generated from our Online Catalog. Please find the complete data in the user's documentation. Our General Terms of Use for Downloads are valid (http://phoenixcontact.com/download) The stand-alone device for PROFIBUS has 8 digital outputs each with a load capacity of 2 A. The M12 connection is established using fast connection technology. The 24 V DC supply is protected against short circuit and overload. Product Features ■ ■ ■ ■ ■ ■ Flexible power supply concept Diagnostic and status indicators SPEEDCON fast locking system Short-circuit and overload protection Consistent connection via M12 connectors Directly accessible address encoding switch Key Commercial Data Packing unit 1 pc Weight per Piece (excluding packing) 389.3 g Custom tariff number 85389099 Country of origin Germany Technical data Note Utilization restriction EMC: class A product, see manufacturer's declaration in the download area Environmental Product Compliance REACh SVHC DEHP 117-81-7 Dimensions Width 60 mm Height 178 mm Depth 49.3 mm 05/03/2016   Page 1 / 5 https://www.phoenixcontact.com/us/products/2736110 Distributed I/O device - FLS PB M12 DO 8 M12-2A - 2736110 Technical data Dimensions Drill hole spacing 168 mm Ambient conditions Ambient temperature (operation) -25 °C ... 60 °C Ambient temperature (storage/transport) -25 °C ... 85 °C Permissible humidity (storage/transport) 95 % Air pressure (operation) 80 kPa ... 106 kPa (up to 2000 m above sea level) Air pressure (storage/transport) 70 kPa ... 106 kPa (up to 3000 m above sea level) Degree of protection IP65/IP67 General Mounting type Wall mounting Net weight 337.74 g Interfaces Fieldbus system PROFIBUS DP Designation PROFIBUS DP Connection method 2x M12 connectors, B-coded Designation connection point Copper cable Transmission speed 9,6 kBit/s ... 12 MBit/s (Automatic baud rate detection) Transmission physics PROFIBUS-DP-compliant copper cable Address area assignment 1 ... 99, can be set Number of positions 5 Power supply for module electronics Connection method M12 connector, (A-coded) Designation UL Supply voltage 24 V DC Supply voltage range 18 V DC ... 30 V DC (including ripple) Fieldline potentials Voltage supply UL 24 V DC Power supply at UL 4A Current consumption from UL typ. 40 mA max. 100 mA Voltage supply US 24 V DC Power supply at US max. 4 A Current consumption from US typ. 3 mA max. 700 mA Voltage supply UA11 24 V DC 05/03/2016   Page 2 / 5 https://www.phoenixcontact.com/us/products/2736110 Distributed I/O device - FLS PB M12 DO 8 M12-2A - 2736110 Technical data Fieldline potentials Power supply at UA11 max. 4 A Current consumption at UA11 typ. 12 mA (plus actuator current) max. 4 A Voltage supply UA12 24 V DC Power supply at UA12 max. 4 A Current consumption at UA12 typ. 12 mA (plus actuator current) max. 4 A Voltage supply UA21 24 V DC Power supply at UA21 max. 4 A Current consumption at UA21 typ. 12 mA (plus actuator current) max. 4 A Voltage supply UA22 24 V DC Power supply at UA22 max. 4 A Current consumption at UA22 typ. 12 mA (plus actuator current) max. 4 A Digital outputs Output name Digital outputs Connection method M12 connector 2, 3-wire Number of outputs 8 Protective circuit Short-circuit protection Output voltage 24 V DC Maximum output current per channel 2A Standards and Regulations Test section 24 V supply (bus logics) / Bus connection 24 V supply (bus logics) / FE 500 V AC 50 Hz 1 min. 24 V supply (bus logics) / Digital outputs (actuator supply) 500 V AC 50 Hz 1 min. Bus connection / FE 500 V AC 50 Hz 1 min. Bus connection / Digital outputs (actuator supply) 500 V AC 50 Hz 1 min. FE / Digital outputs (actuator supply) 500 V AC 50 Hz 1 min. Connection in acc. with standard CUL Protection class III, IEC 61140, EN 61140, VDE 0140-1 05/03/2016   Page 3 / 5 https://www.phoenixcontact.com/us/products/2736110 Distributed I/O device - FLS PB M12 DO 8 M12-2A - 2736110 Classifications eCl@ss eCl@ss 4.0 27250302 eCl@ss 4.1 27250302 eCl@ss 5.0 27250302 eCl@ss 5.1 27242604 eCl@ss 6.0 27242604 eCl@ss 7.0 27242604 eCl@ss 8.0 27242604 eCl@ss 9.0 27242604 ETIM ETIM 2.0 EC001430 ETIM 3.0 EC001599 ETIM 4.0 EC001599 ETIM 5.0 EC001599 UNSPSC UNSPSC 6.01 43172015 UNSPSC 7.0901 43201404 UNSPSC 11 43172015 UNSPSC 12.01 43201404 UNSPSC 13.2 43201404 Approvals Approvals Approvals UL Recognized / cUL Recognized / PROFIBUS / EAC / EAC / cULus Recognized Ex Approvals UL Recognized / cUL Recognized / cULus Recognized Approvals submitted Approval details 05/03/2016   Page 4 / 5 https://www.phoenixcontact.com/us/products/2736110 Distributed I/O device - FLS PB M12 DO 8 M12-2A - 2736110 Approvals UL Recognized  cUL Recognized  PROFIBUS  EAC  EAC  cULus Recognized  Drawings Connection diagram Dimensional drawing 178 O4 O5 O6 OUT6 OUT5 49,3 OUT3 OUT4 O3 Phoenix Contact 2016 © - all rights reserved http://www.phoenixcontact.com 05/03/2016   Page 5 / 5