2903335

https://www.phoenixcontact.com/us/products/2903335 Relay Module - RIF-1-RPT-LV-230AC/1X21AU - 2903335 Please be informed that the data shown in this PDF Document is generated from our Online Catalog. Please find the complete data in the user's documentation. Our General Terms of Use for Downloads are valid (http://phoenixcontact.com/download) Pre-assembled relay module with push-in connection, consisting of: relay base, multi-layer contact relay, plug-in display/suppressor module, and retaining bracket. Contact type: 1 PDT. Input voltage: 230 V AC The figure shows the 24 V DC version Key Commercial Data Packing unit 1 pc Weight per Piece (excluding packing) 68.0 g Custom tariff number 85364900 Country of origin Germany Technical data Note Utilization restriction EMC: class A product, see manufacturer's declaration in the download area Dimensions Width 16 mm Height 93 mm Depth 75 mm Ambient conditions Ambient temperature (operation) -40 °C ... 50 °C Ambient temperature (storage/transport) -40 °C ... 85 °C Coil side Nominal input voltage UN 230 V AC Input voltage range in reference to UN see diagram Mains frequency 50 Hz 04/11/2016   Page 1 / 7 https://www.phoenixcontact.com/us/products/2903335 Relay Module - RIF-1-RPT-LV-230AC/1X21AU - 2903335 Technical data Coil side 60 Hz Typical input current at UN 6 mA Typical response time 3 ms ... 12 ms Typical release time range 3 ms ... 20 ms Coil voltage 230 V AC Protective circuit Varistor Operating voltage display Yellow LED Contact side Contact type 1 PDT Contact material AgNi, hard gold-plated Maximum switching voltage 30 V AC 36 V DC Minimum switching voltage 100 mV (at 10 mA) Min. switching current 1 mA (at 24 V) Maximum inrush current 50 mA Limiting continuous current 50 mA Interrupting rating (ohmic load) max. 1.2 W (at 24 V DC) Switching capacity in acc. with DIN VDE 0660/IEC 60947 2 A (at 24 V, AC15) Note the following values are applicable if a gold layer is destroyed Maximum switching voltage 250 V AC/DC Minimum switching voltage 12 V (at 10 mA) Limiting continuous current 25 A (20 ms, N/O contact) Min. switching current 10 mA (at 12 V) Interrupting rating (ohmic load) max. 240 W (at 24 V DC) 58 W (at 48 V DC) 48 W (at 60 V DC) 50 W (at 110 V DC) 80 W (at 220 V DC) 2500 VA (for 250 V AC) Switching capacity in acc. with DIN VDE 0660/IEC 60947 2 A (at 24 V, DC13) 0.2 A (at 110 V, DC13) 0.2 A (at 250 V, DC13) 2 A (at 24 V, AC15) 2 A (at 120 V, AC15) 2 A (at 250 V, AC15) Connection data input side 04/11/2016   Page 2 / 7 https://www.phoenixcontact.com/us/products/2903335 Relay Module - RIF-1-RPT-LV-230AC/1X21AU - 2903335 Technical data Connection data input side Connection name Coil side Connection method Push-in connection Stripping length 8 mm Conductor cross section solid 0.14 mm² ... 1.5 mm² Conductor cross section flexible 0.14 mm² ... 1.5 mm² 0.14 mm² ... 1 mm² (Ferrule with plastic sleeve) 0.14 mm² ... 1.5 mm² (Ferrules without plastic sleeve) Conductor cross section AWG 26 ... 16 Connection data output side Connection name Contact side Connection method Push-in connection Stripping length 8 mm Conductor cross section solid 0.14 mm² ... 1.5 mm² Conductor cross section flexible 0.14 mm² ... 1.5 mm² 0.14 mm² ... 1 mm² (Ferrule with plastic sleeve) 0.14 mm² ... 1.5 mm² (Ferrules without plastic sleeve) Conductor cross section AWG 26 ... 16 General Type of note Notes on operation Note FBS 2-6... plug-in bridge for the input side (A2) and FBS-2-8... plug-in bridge for the output side (11/21) Test voltage relay winding/relay contact 4 kVrms (50 Hz, 1 min.) Operating mode 100% operating factor Degree of protection IP20 (Relay socket) RT II (Relay) Mechanical service life Approx. 10 cycles Standards/regulations DIN EN 50178 7 IEC 62103 Rated insulation voltage 250 V AC Degree of pollution 2 Overvoltage category III Mounting position any Assembly instructions In rows with zero spacing Standards and Regulations Standards/regulations DIN EN 50178 IEC 62103 04/11/2016   Page 3 / 7 https://www.phoenixcontact.com/us/products/2903335 Relay Module - RIF-1-RPT-LV-230AC/1X21AU - 2903335 Technical data Standards and Regulations Rated insulation voltage 250 V AC Insulation safe isolation Degree of pollution 2 Overvoltage category III Articles in set Relay socket - RIF-1-BPT/2X21 - 2900931 RIF-1... relay base, for miniature power relay with 1 or 2 PDTs or solid-state relays of the same design, push-in connection, plug-in option for input/suppressor modules, for mounting on NS 35/7,5     Single relay - REL-MR-230AC/21HC AU - 2961529 Plug-in miniature power relay, with multi-layer gold contact for high continuous currents, 1 PDT, input voltage 230 V AC     Plug-in module - RIF-LV-120-230 AC/110 DC - 2900944 Plug-in module, for mounting on RIF-1, RIF-2, RIF-3, and RIF-4, with varistor and yellow LED, input voltage: 120 - 230 V AC/110 V DC ±20%     Retaining bracket - RIF-RH-1 - 2900953 Relay retaining bracket, with ejector function and holder for marking material, suitable for RIF-1 relay base, for 16 mm tall miniature power relay and solid-state relay     04/11/2016   Page 4 / 7 https://www.phoenixcontact.com/us/products/2903335 Relay Module - RIF-1-RPT-LV-230AC/1X21AU - 2903335 Classifications eCl@ss eCl@ss 4.0 27371102 eCl@ss 4.1 27371102 eCl@ss 5.0 27371603 eCl@ss 5.1 27371603 eCl@ss 6.0 27371603 eCl@ss 7.0 27371603 eCl@ss 8.0 27371601 eCl@ss 9.0 27371601 ETIM ETIM 3.0 EC001456 ETIM 4.0 EC001456 ETIM 5.0 EC001437 UNSPSC UNSPSC 6.01 30211917 UNSPSC 7.0901 39121516 UNSPSC 11 39121516 UNSPSC 12.01 39121516 UNSPSC 13.2 39121516 Approvals Approvals Approvals EAC / GL / LR / EAC Ex Approvals Approvals submitted Approval details EAC  04/11/2016   Page 5 / 7 https://www.phoenixcontact.com/us/products/2903335 Relay Module - RIF-1-RPT-LV-230AC/1X21AU - 2903335 Approvals GL  LR  EAC  Drawings 22 12 24 14 21 11 A2 Diagram Coil voltage U/UN Circuit diagram A1 AC coils 1,8 1,7 1,6 1,5 1,4 1,3 1,2 1,1 1,0 0,9 0,8 0,7 0,6 20 30 40 50 60 70 Ambient temperature [°C] 80 DC coils AC coils Operating voltage range Diagram Diagram 10 6 4 Cycles Switching current [A] 20 2 10 7 10 6 1 1 0,5 0,3 0,2 0,1 10 20 30 AC, ohmic load DC, ohmic load DC, L/R = 40 ms Interrupting rating 50 70 100 200 Switching voltage [V] 300 10 5 10 4 0 2 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 Switching current [A] 1 250 V AC, ohmic load (DC coils) 2 250 V AC, ohmic load (AC coils) Electrical service life 04/11/2016   Page 6 / 7 https://www.phoenixcontact.com/us/products/2903335 Relay Module - RIF-1-RPT-LV-230AC/1X21AU - 2903335 Diagram 1 Reduction factor 0,9 0,8 0,7 0,6 0,5 0,4 0,3 1 0,9 0,8 0,7 0,6 0,5 0,4 0,3 0,2 COS j Service life reduction factor Phoenix Contact 2016 © - all rights reserved http://www.phoenixcontact.com 04/11/2016   Page 7 / 7